The biomechanical performance of bone block and soft-tissue posterior cruciate ligament graft fixation with interference screw and cross-pin techniques

Biomechanical properties of femoral posterior cruciate ligament fixations

PURPOSE

The success of reconstructions of the posterior cruciate ligament (PCL) mainly depends on the fixation strength of the tendon-bone interface. Reliable data about the mechanical characteristics of PCL fixation techniques are sparse. The aim of this study was to investigate the biomechanical properties of different femoral PCL fixation techniques.

METHODS

Fresh human cadaver quadriceps (Q) and hamstring (H) tendons were harvested and fixed into porcine femora with a press-fit fixation suturing the tendon over a bone bridge (group A), a novel implant post-fixation (group B) or an interference screw fixation (group C). Each group consisted of 10 specimens. The constructs were cyclically stretched and eventually loaded until failure. Elongation during cyclic loading, stiffness, failure mode and maximum failure load was evaluated.

RESULTS

Elongation during cyclical loading was significantly larger between the 1st and the 20th cycle than between the 20th and the 500th cycle in all groups (p < 0.05). Maximum failure load was 409 ± 71 (336-517) N in group QA, 456 ± 58 (347-510) N in group QB, 548 ± 116 (400-798) N in group QC, 472 ± 114 N (316-676 N) in group HA, 494 ± 98 N (371-668 N) in group HB and 498 ± 87 N (391-687 N) in group HC (significantly higher for QB compared to QA, p < 0.05).

CONCLUSION

This is the first study investigating the biomechanical properties of femoral PCL fixations. Implant-free fixation techniques like press-fit or post-fixations are able to withstand equal biomechanical forces compared to interference screw fixation. The novel fixations described in this study can be considered as a reliable alternative for the reconstruction of PCL using either hamstring or quadriceps tendons.

TransMedial All-Inside Posterior Cruciate Ligament Reconstruction Using a Reinforced Tibial Inlay Graft

Surgical reconstruction of the posterior cruciate ligament (PCL) is technically demanding. Potential challenges include visualization of the tibial footprint and drilling of the tibial tunnel without damaging posterior neurovascular structures, as well as graft selection, deployment, tensioning, and fixation. We present a novel TransMedial all-inside arthroscopic technique (technique designed by A. J. Wilson with support from Arthrex) using a single hamstring tendon graft, fixed with adjustable cortical suspensory devices. The technique simplifies the difficult steps encountered during PCL reconstruction and is safe and reproducible. All arthroscopic viewing is accomplished from the lateral portal, and femoral socket preparation is performed from the medial side with specially contoured instruments, which allow accurate marking, measuring, and anatomic positioning of the graft. The quadrupled semitendinosus graft can be augmented with composite polymer tape for increased strength and initial stability. We use outside-in drilling to create retrograde femoral and tibial sockets. Cortical suspensory fixation on the tibial side can be supplemented with anchor fixation. We use an arthroscopic tibial inlay technique that better approximates native knee anatomy. This also avoids the "killer turn," a problem seen in transtibial PCL reconstruction techniques, which theoretically induces graft laxity due to abrasion with cyclic loading. This technique can be further adapted to allow a modified double-bundle or TriLink graft (technique designed by A. J. Wilson with support from Arthrex.).

Surgical management of PCL injuries: indications, techniques, and outcomes

The ideal treatment for posterior cruciate ligament (PCL) injuries is controversial and remains an active area of orthopedic research. The indications for surgery and the ideal method of reconstruction continue to be evaluated in biomechanical and clinical studies. Recent research has provided information on the anatomy and biomechanics of the PCL, and the merits and drawbacks of the transtibial compared with the tibial inlay technique, the use of single vs double-bundle reconstruction, and different graft options for reconstruction. This review discusses important factors in the surgical treatment of PCL injuries, with attention to the most current literature on these topics.

Single-bundle transtibial posterior cruciate ligament reconstruction using a bioabsorbable cross-pin tibial back side fixation

PURPOSE

The purpose of this study was to examine a developed surgical technique by performing a mid-term evaluation of clinical and stability results and complications.

METHODS

Thirty patients who underwent transtibial posterior cruciate ligament (PCL) reconstruction using a bioabsorbable cross-pin tibial back side fixation method were enrolled in this prospective study. Lysholm and International Knee Documentation Committee (IKDC) knee scales were used to evaluate clinical outcomes. Stability was evaluated using a Telos device with a 150 N force at 90 degrees of knee flexion. Follow-up magnetic resonance imaging (MRI) was also performed in 20 (66.7%) patients, and complications were evaluated. Those with complication by MRI were assigned to an abnormal MRI group.

RESULTS

The follow-up period was 47 (range, 25-62) months. On comparing preoperative and final follow-up clinical results, Lysholm and IKDC knee scale scores were found to have improved significantly (P < 0.001). The mean side-to-side difference in posterior translation measured using a Telos device was 13.4 ± 3.1 mm (range 10-20 mm) preoperatively and 3.2 ± 1.5 mm (range 1-7 mm) at last follow-up, which represented a significant improvement in stability (P < 0.001). Five patients showed cyst formation in the tibial tunnel and two patients showed a significant signal increase at the anterior portion of the tibial tunnel, which was believed to indicate a pro-cystic status. The normal and abnormal MRI groups had similar Lysholm and IKDC knee scale scores and stress radiographs (P > 0.05).

CONCLUSIONS

Single-bundle transtibial PCL reconstruction using a bioabsorbable cross-pin tibial back side fixation was found to produce satisfactory clinical and stability results. However, despite these satisfactory results, a potential complication of tibial cyst formation was observed.

LEVEL OF EVIDENCE

Case series, Level IV.

Long-term outcomes following single-bundle transtibial arthroscopic posterior cruciate ligament reconstruction

PURPOSE

Posterior cruciate ligament (PCL) injury has a reported incidence of 3-20 %. PCL reconstruction is aimed at reducing onset of premature articular degeneration and improving function. Numerous operative techniques have been described with varying degrees of result consistency.

METHODS

We evaluated 15 patients treated for isolated primary posterior cruciate ligament injury with a mean follow-up of 4.1 years (range one to nine). Post-reconstruction clinical assessment included the Lysholm and Tegner knee scoring scale, international knee documentation committee (IKDC) ligament evaluation, and KT2000 arthrometer assessment.

RESULTS

On the Lysholm knee score 11 patients (73 %) had excellent results, three patients (20 %) had good results and one patient (7 %) had a poor result. On the Tegner activity score the majority of patients scored 7-8 with a return to high level sports. At the final follow-up, the post-reconstruction IKDC score was normal or nearly normal (A and B) in 14 (93 %) patients, and abnormal (C) in one (7 %) patient. According to KT-2000 arthrometer measurements at final follow-up review, 11 patients (73 %) were rated as normal (A, 0-2 mm), and four patients (27 %) as nearly normal (B, 3-5 mm). These results were independent of age, mechanism of injury, time elapsed to surgical reconstruction, and length of follow-up.

CONCLUSIONS

Despite being a technically demanding procedure, the outcomes reported in this study show that single bundle transtibial arthroscopic PCL repair using four strands hamstring autograft provides satisfactory and consistent functional outcomes.

The fixation strength of tibial PCL press-fit reconstructions

PURPOSE

A secure tibial press-fit technique in posterior cruciate ligament reconstructions is an interesting technique because no hardware is necessary. For anterior cruciate ligament (ACL) reconstruction, a few press-fit procedures have been published. Up to the present point, no biomechanical data exist for a tibial press-fit posterior cruciate ligament (PCL) reconstruction. The purpose of this study was to characterize a press-fit procedure for PCL reconstruction that is biomechanically equivalent to an interference screw fixation.

METHODS

Quadriceps and hamstring tendons of 20 human cadavers (age: 49.2 ± 18.5 years) were used. A press-fit fixation with a knot in the semitendinosus tendon (K) and a quadriceps tendon bone block graft (Q) were compared to an interference screw fixation (I) in 30 porcine femora. In each group, nine constructs were cyclically stretched and then loaded until failure. Maximum load to failure, stiffness, and elongation during failure testing and cyclical loading were investigated.

RESULTS

The maximum load to failure was 518 ± 157 N (387-650 N) for the (K) group, 558 ± 119 N (466-650 N) for the (I) group, and 620 ± 102 N (541-699 N) for the (Q) group. The stiffness was 55 ± 27 N/mm (18-89 N/mm) for the (K) group, 117 ± 62 N/mm (69-165 N/mm) for the (I) group, and 65 ± 21 N/mm (49-82 N/mm) for the (Q) group. The stiffness of the (I) group was significantly larger (P = 0.01). The elongation during cyclical loading was significantly larger for all groups from the 1st to the 5th cycle compared to the elongation in between the 5th to the 20th cycle (P < 0.03).

CONCLUSION

All techniques exhibited larger elongation during initial loading. Load to failure and stiffness was significantly different between the fixations. The Q fixation showed equal biomechanical properties compared to a pure tendon fixation (I) with an interference screw. All three fixation techniques that were investigated exhibit comparable biomechanical properties. Preconditioning of the constructs is critical. Clinical trials have to investigate the biological effectiveness of these fixation techniques.

A biomechanical comparison of tibial back side fixation between suspensory and expansion mechanisms in trans-tibial posterior cruciate ligament reconstruction

Soft tissue grafts have attracted increasing attention in anterior cruciate ligament (ACL) reconstruction and offer a number of advantages Therefore, it can also be attractive for trans-tibial PCL reconstruction, if four-strand hamstring or two-strand tibialis grafts could be converted for this use. We intended to investigate the biomechanical properties of fixation devices that are frequently used for the soft tissue graft in the trans-tibial PCL reconstruction.Thirty-six fresh adult porcine knees were used in this study. Porcine digital extensor tendons were used as two-stranded soft tissue grafts. The tibial side of the PCL was fixed using a bio-TransFix of suspensory mechanism (TransFix system®: Arthrex, Naples, FL, USA) device (group I) or a RIGIDFIX of expansion mechanism (RIGIDFIX system®: Mitek, Johnson & Johnson, USA) device (group II). We performed biomechanical testing to identify maximum failure load, stiffness, and displacement for both devices.Maximum mean failure loads in groups I and II were 907.3±142.2 and 701.9±101.5N, respectively (p=0.03). Stiffness was 65.6±16.8 and 63.1±15.1N/mm, respectively (p=0.85). Mean displacements were 23.9±6.0 and 19.8±7.9mm, respectively (p=0.37).Suspensory and expansion mechanisms used for tibial back side fixation in the trans-tibial PCL reconstruction using soft tissue grafts showed acceptable biomechanical properties and could be a good choice in case of short multi-stranded soft tissue graft.

Posterior cruciate ligament: anatomy, biomechanics, and outcomes

The optimal treatment of posterior cruciate ligament ruptures remains controversial despite numerous recent basic science advances on the topic. The current literature on the anatomy, biomechanics, and clinical outcomes of posterior cruciate ligament reconstruction is reviewed. Recent studies have quantified the anatomic location and biomechanical contribution of each of the 2 posterior cruciate ligament bundles on tunnel placement and knee kinematics during reconstruction. Additional laboratory and cadaveric studies have suggested double-bundle reconstructions of the posterior cruciate ligament may better restore normal knee kinematics than single-bundle reconstructions although clinical outcomes have not revealed such a difference. Tibial inlay posterior cruciate ligament reconstructions (either open or arthroscopic) are preferred by many authors to avoid the "killer turn" and graft laxity with cyclic loading. Posterior cruciate ligament reconstruction improves subjective patient outcomes and return to sport although stability and knee kinematics may not return to normal.

Optimizing an intermittent stretch paradigm using ERK1/2 phosphorylation results in increased collagen synthesis in engineered ligaments

Dynamic mechanical input is believed to play a critical role in the development of functional musculoskeletal tissues. To study this phenomenon, cyclic uniaxial mechanical stretch was applied to engineered ligaments using a custom-built bioreactor and the effects of different stretch frequency, amplitude, and duration were determined. Stretch acutely increased the phosphorylation of p38 (3.5±0.74-fold), S6K1 (3.9±0.19-fold), and ERK1/2 (2.45±0.32-fold). The phosphorylation of ERK1/2 was dependent on time, rather than on frequency or amplitude, within these constructs. ERK1/2 phosphorylation was similar following stretch at frequencies from 0.1 to 1 Hz and amplitudes from 2.5% to 15%, whereas phosphorylation reached maximal levels at 10 min of stretch and returned toward basal within 60 min of stretch. Following a single 10-min bout of cyclic stretch, the cells remained refractory to a second stretch for up to 6 h. Using the phosphorylation of ERK1/2 as a guide, the optimum stretch paradigm was hypothesized to be 10 min of stretch at 2.5% of resting length repeated every 6 h. Consistent with this hypothesis, 7 days of stretch using this optimized intermittent stretch program increased the collagen content of the grafts more than a continuous stretch program (CTL=3.1%±0.44%; CONT=4.8%±0.30%; and INT=5.9%±0.56%). These results suggest that short infrequent bouts of loading are optimal for improving engineered tendon and ligament physiology.

Fracture of the tibial bone block after posterior cruciate ligament allograft reconstruction using double cross pins

We report the fracture of the tibial bone block after posterior cruciate ligament reconstruction using double cross pins for bone block fixation in the postoperative period. The possible reasons include the size of bone block,direction of cross pin or the quality of bone block. This case emphasizes the biomechanical properties and failure of modes of double cross pin.