The use of a new in vitro reaction substrate reproducing both U3 and U5 regions of the HIV-1 3'-ends increases the correlation between the in vitro and in vivo effects of the HIV-1 integrase inhibitors

Postexposure protection of macaques from vaginal SHIV infection by topical integrase inhibitors

Coitally delivered microbicide gels containing antiretroviral drugs are important for HIV prevention. However, to date, microbicides have contained entry or reverse transcriptase inhibitors that block early steps in virus infection and thus need to be given as a preexposure dose that interferes with sexual practices and may limit compliance. Integrase inhibitors block late steps after virus infection and therefore are more suitable for post-coital dosing. We first determined the kinetics of strand transfer in vitro and confirmed that integration begins about 6 hours after infection. We then used a repeat-challenge macaque model to assess efficacy of vaginal gels containing integrase strand transfer inhibitors when applied before or after simian/human immunodeficiency virus (SHIV) challenge. We showed that gel containing the strand transfer inhibitor L-870812 protected two of three macaques when applied 30 min before SHIV challenge. We next evaluated the efficacy of 1% raltegravir gel and demonstrated its ability to protect macaques when applied 3 hours after SHIV exposure (five of six protected; P < 0.05, Fisher's exact test). Breakthrough infections showed no evidence of drug resistance in plasma or vaginal secretions despite continued gel dosing after infection. We documented rapid vaginal absorption reflecting a short pharmacological lag time and noted that vaginal, but not plasma, virus load was substantially reduced in the breakthrough infection after raltegravir gel treatment. We provide a proof of concept that topically applied integrase inhibitors protect against vaginal SHIV infection when administered shortly before or 3 hours after virus exposure.

A high-throughput assay for HIV-1 integrase 3'-processing activity using time-resolved fluorescence

HIV-1 integrase (HIV-1 IN), a well-validated antiviral drug target, catalyzes multistep reactions to incorporate viral DNA into the genome of the host cell; these include both a 3'-processing (3'P) reaction and a strand transfer reaction. These enzymatic activities can be measured in vitro with short DNA oligonucleotides that mimic a single viral LTR DNA end and purified IN. A highly sensitive and reproducible time-resolved fluorescence (TRF)-based assay for HIV-1 IN 3'P activity is now reported. This assay was optimized with respect to time and concentrations of metal ions, substrate and enzyme. The assay has now been used successfully to measure HIV-1 IN 3'P activity and has been shown to detect the anti-IN activity of several known 3'P inhibition compounds accurately. This assay, which is amenable to high-throughput screening, will be useful for identification of additional HIV-1 IN 3'P inhibitors.

Development of a high-throughput assay for the HIV-1 integrase disintegration reaction

Both HIV-1 integrase (IN) and the central catalytic domain of IN (IN-CCD) catalyze the disintegration reaction in vitro. In this study, IN and IN-CCD proteins were expressed and purified, and a high-throughput format enzyme-linked immunosorbent assay (ELISA) was developed for the disintegration reaction. IN exhibited a marked preference for Mn(2+) over Mg(2+) as the divalent cation cofactor in disintegration. Baicalein, a known IN inhibitor, was found to be an IN-CCD inhibitor. The assay is sensitive and specific for the study of disintegration reaction as well as for the in vitro identification of antiviral drugs targeting IN, especially targeting IN-CCD.

A novel high-throughput format assay for HIV-1 integrase strand transfer reaction using magnetic beads

AIM

To develop a novel high-throughput format assay to monitor the integrase (IN) strand transfer (ST) reaction in vitro and apply it to a reaction character study and the identification of antiviral drugs.

METHODS

The donor DNA duplex, with a sequence identical to the U5 end of HIV-1 long terminal repeats, is labeled at its 5' end with biotin (BIO). The target DNA duplex is labeled at its 3' end with digoxin (DIG). IN mediates the integration of donor DNA into target DNA and results in a 5' BIO and 3' DIG-labeled duplex DNA product. Streptavidin-coated magnetic beads were used to capture the product, and the amount of DIG was measured as the ST reaction product. The assay was optimized in 96-well microplate format for high-throughput screening purpose. Moreover, the assay was applied in a ST reaction character study, and the efficiency of the assay in the identification of antiviral compounds was tested.

RESULTS

The end-point values, measured as absorbance at 405 nm was approximately 1.5 for the IN-mediated ST reaction as compared with no more than 0.05 of background readings. The ST reaction character and the half maximal inhibitory concentration (IC50) values of 2 known IN inhibitors obtained in our assay were similar to previously reported results using other assays. The evaluation parameter Z' factor for this assay ranged from 0.6 to 0.9.

CONCLUSION

The assay presented here has been proven to be rapid, sensitive, and specific for the detection of IN ST activity, the reaction character study, as well as for the identification of antiviral drugs targeting IN.

High-throughput real-time assay based on molecular beacons for HIV-1 integrase 3'-processing reaction

AIM

To develop a high-throughput real-time assay based on molecular beacons to monitor the integrase 3'-processing reaction in vitro and apply it to inhibitor screening.

METHODS

The recombinant human immunodeficiency virus (HIV)-1 integrase (IN) is incubated with a 38 mer oligonucleotide substrate, a sequence identical to the U5 end of HIV-1 long terminal repeats (LTR). Based on the fluorescence properties of molecular beacons, the substrate is designed to form a stem-loop structure labeled with a fluorophore at the 5' end and a quencher at the 3' end. IN cleaves the terminal 3'-dinucleotide containing the quencher, resulting in an increase in fluorescence which can be monitored on a spectrofluorometer. To optimize this assay, tests were performed to investigate the effects of substrates, enzyme and the metal ion concentrations on the IN activity and optimal parameters were obtained. Moreover, 2 IN inhibitors were employed to test the performance of this assay in antiviral compound screening.

RESULTS

The fluorescent intensity of the reaction mixture varies linearly with time and is proportional to the velocity of the 3'-processing reaction. Tests were performed and the results showed that the optimal rate was obtained for a reaction mixture containing 50 mg/L recombinant HIV-1 IN, 400 nmol/L substrate, and 10 mmol/L Mn(2+). The IN 3'-processing reaction under the optimal conditions showed a more than 18-fold increase in the fluorescence intensity compared to the enzyme-free control. The IC50 values of the IN inhibitors obtained in our assay were similar to the values obtained from a radiolabeled substrate assay.

CONCLUSION

Our results demonstrated that this is a fast, reliable, and sensitive method to monitor HIV IN 3'-processing reaction and that it can be used for inhibitor screening.