Electrochemistry of raloxifene on glassy carbon electrode and its determination in pharmaceutical formulations and human plasma

Colorimetric detection for raloxifene based on Cu-PTs nanozyme with peroxidase-like activity

The amorphous Cu-containing phosphomolybdate (Cu-PTs) composite with high peroxidase (POD)-like activity at neutral conditions was explored as biosensors for raloxifene (RAF) detection. The strong attraction between negatively charged Cu-PTs and positively charged substrates 3,3',5,5'-tetramethylbenzidine (TMB), as well as the acceleration of the conversion of active Cu+/Cu2+ by the Cu/W bimetallic redox couples were demonstrated to play significant roles in POD-like activity in physiological environment. When RAF is presence, it can bind to the surface of Cu-PTs and changes the chemical signal on the material surface, leading to the decreased POD-like activity. Based on this, a colorimetric method was established for the sensitive assay of RAF with a lower limit of detection (LOD) of 0.025 mg/L and good recovery from 90.13% to 108.9%. This work paves a new way to design a POD-like colorimetric protocol for tracing RAF in pharmaceutical products and environmental samples.

Simulating the phase II metabolism of raloxifene on a screen-printed electrode

Raloxifene (RLX) is a selective estrogen receptor modulator widely used for the treatment of osteoporosis in post-menopause women. Toxicological in vitro studies suggested the reactivity of RLX through phase I metabolism. Herein, we describe a simple and inexpensive method for monitoring the reactive metabolism and detoxification of RLX by electrochemistry (EC) and mass spectrometry (MS). The phase I metabolite was synthesized electrochemically on a screen-printed electrode (SPE) and subsequently reacted with glutathione (GSH). The resulted GSH-adducts and GSH disulfides were characterized off-line by electrospray ionization (ESI)–MS.

A Disposable Microfluidic Device with a Screen Printed Electrode for Mimicking Phase II Metabolism

Human metabolism is investigated using several in vitro methods. However, the current methodologies are often expensive, tedious and complicated. Over the last decade, the combination of electrochemistry (EC) with mass spectrometry (MS) has a simpler and a cheaper alternative to mimic the human metabolism. This paper describes the development of a disposable microfluidic device with a screen-printed electrode (SPE) for monitoring phase II GSH reactions. The proposed chip has the potential to be used as a primary screening tool, thus complementing the current in vitro methods.

Construction of an Electrochemical Sensor Based on Carbon Nanotubes/Gold Nanoparticles for Trace Determination of Amoxicillin in Bovine Milk

In this work, a novel electrochemical sensor was fabricated for determination of amoxicillin in bovine milk samples by decoration of carboxylated multi-walled carbon nanotubes (MWCNTs) with gold nanoparticles (AuNPs) using ethylenediamine (en) as a cross linker (AuNPs/en-MWCNTs). The constructed nanocomposite was homogenized in dimethylformamide and drop casted on screen printed electrode. Field emission scanning electron microscopy (FESEM), energy dispersive X-Ray (EDX), X-Ray diffraction (XRD) and cyclic voltammetry were used to characterize the synthesized nanocomposites. The results show that the synthesized nanocomposites induced a remarkable synergetic effect for the oxidation of amoxicillin. Effect of some parameters, including pH, buffer, scan rate, accumulation potential, accumulation time and amount of casted nanocomposites, on the sensitivity of fabricated sensor were optimized. Under the optimum conditions, there was two linear calibration ranges from 0.2-10 µM and 10-30 µM with equations of Ipa (µA) = 2.88C (µM) + 1.2017; r = 0.9939 and Ipa (µA) = 0.88C (µM) + 22.97; r = 0.9973, respectively. The limit of detection (LOD) and limit of quantitation (LOQ) were calculated as 0.015 µM and 0.149 µM, respectively. The fabricated electrochemical sensor was successfully applied for determination of Amoxicillin in bovine milk samples and all results compared with high performance liquid chromatography (HPLC) standard method.

Adsorption properties of tetracycline onto graphene oxide: equilibrium, kinetic and thermodynamic studies

Graphene oxide (GO) nanoparticle is a high potential effective absorbent. Tetracycline (TC) is a broad-spectrum antibiotic produced, indicated for use against many bacterial infections. In the present research, a systematic study of the adsorption and release process of tetracycline on GO was performed by varying pH, sorption time and temperature. The results of our studies showed that tetracycline strongly loads on the GO surface via π-π interaction and cation-π bonding. Investigation of TC adsorption kinetics showed that the equilibrium was reached within 15 min following the pseudo-second-order model with observed rate constants of k2 = 0.2742-0.5362 g/mg min (at different temperatures). The sorption data has interpreted by the Langmuir model with the maximum adsorption of 323 mg/g (298 K). The mean energy of adsorption was determined 1.83 kJ/mol (298 K) based on the Dubinin-Radushkevich (D-R) adsorption isotherm. Moreover, the thermodynamic parameters such as ΔH°, ΔS° and ΔG° values for the adsorption were estimated which indicated the endothermic and spontaneous nature of the sorption process. The electrochemistry approved an ideal reaction for the adsorption under electrodic process. Simulation of GO and TC was done by LAMMPS. Force studies in z direction showed that tetracycline comes close to GO sheet by C8 direction. Then it goes far and turns and again comes close from amine group to the GO sheet.

An 2,2'-azino-bis(3-ethylbenzthiazoline-6-sulfonic acid)-immobilized electrode for the simultaneous detection of dopamine and uric acid in the presence of ascorbic acid

An 2,2'-azino-bis(3-ethylbenzthiazoline-6-sulfonic acid) (ABTS)-immobilized carbon nanotube (CNT) electrode was used to simultaneously detect dopamine (DA) and uric acid (UA) in the presence of ascorbic acid (AA) with differential pulse voltammetry. When ABTS was immobilized onto the CNT electrode in the presence of DA, UA and 100 μM AA, the sensitivity to DA increased from 0.600 (±0.013) to 1.334 (±0.010) μA/μM in the concentration ranges of 0.90-10 μM and 1.87-20 μM, respectively, and the sensitivity to UA increased from 0.030 (±0.005) to 0.078 (±0.006) μA/μM in the concentration ranges of 2.16-240 μM and 3.07-400 μM, respectively. These findings demonstrate that the ABTS-immobilized CNT electrode attained a higher sensitivity to UA and also a wider linear range of concentrations.