Chemical characteristics of biomass from nature conservation management for methane production

Effect of mowing versus abandonment of mesic grasslands in Central Europe on biomass use for biogas production: Implications for semi-natural ecosystem conservation

The economic management of lignocellulosic biomass from semi-natural grasslands is now a challenge across Europe. The abandonment of mowing these grasslands leads to the gradual degradation of these ecosystems. This study investigates how chemical and biological factors affect the suitability of biomass from abandoned grasslands for biogas production. We sampled 30 mown and 30 abandoned grassland sites in the Sudetes Mountains (Poland and Czechia). The cover contribution of short herbs was found to be significantly higher in mown grasslands (p < 0.001), while that of tall herbs was more prevalent in abandoned grasslands (p < 0.01). The specific biogas yield (SBY, NL kg-1 volatile solids) is negatively affected by an increased percentage of herbs in the biomass of mown and abandoned grasslands. This is due to the inhibitory effect of herbs on biodegradation, the increase in lignin content and the decrease in cellulose. This study highlights the importance of individual plant species in assessing grassland biomass for area biogas yield (ABY, m3 ha-1) and provides new insights into a field that has not yet been extensively investigated. In mown grasslands, ABY was most positively correlated with grass species (Arrhenatherum elatius, Trisetum flavescens and Festuca pratensis). In abandoned grasslands, the ABY was most correlated with herbaceous species (Galium aparine, Urtica dioica and Chaerophyllum aromaticum) and grasses (A. elatius and Elymus repens). Mown grasslands had significantly higher species richness (p < 0.001) compared to abandoned grasslands, but the number of species sampled did not correlate with SBY and ABY. This study contributes to the development of a sustainable bio-economy by highlighting the need for efficient use of grassland biomass. This approach helps protect semi-natural ecosystems and facilitates sustainable management of renewable resources.

A new attempt to control volatile organic compounds (VOCs) pollution - Modification technology of biomass for adsorption of VOCs gas

The detrimental impact of volatile organic compounds on the surroundings is widely acknowledged, and effective solutions must be sought to mitigate their pollution. Adsorption treatment is a cost-effective, energy-saving, and flexible solution that has gained popularity. Biomass is an inexpensive, naturally porous material with exceptional adsorbent properties. This article examines current research on volatile organic compounds adsorption using biomass, including the composition of these compounds and the physical (van der Waals) and chemical mechanisms (Chemical bonding) by which porous materials adsorb them. Specifically, the strategic modification of the surface chemical functional groups and pore structure is explored to facilitate optimal adsorption, including pyrolysis, activation, heteroatom doping and other methods. It is worth noting that biomass adsorbents are emerging as a highly promising strategy for green treatment of volatile organic compounds pollution in the future. Overall, the findings signify that biomass modification represents a viable and competent approach for eliminating volatile organic compounds from the environment.

Improving the energetic utilization of household food waste: Impact of temperature and atmosphere during storage

Food waste (FW) from households represents a major fraction of municipal waste and it is often collected in separate biowaste bins. Until waste collection is carried out, storage conditions in the biowaste bin influence FW properties. To draw conclusions for an optimized waste utilization in anaerobic digestion (AD), the aim of this study was to evaluate the impact of storage duration (20 to 40 days) and temperature (5 °C and 20 °C) on inherent energy potentials of household FW during aerobic and anaerobic storage. Therefore, physico-chemical parameters of recipe-based FW samples with reproducible initial compositions were monitored. After 20 days of aerobic storage, water contents (WC) were reduced from 61.9% to 39.5% (20 °C) and from 63.9% to 50.3% (5 °C) while organic dry matter (oDM) concentrations were lowered by 4.3% (20 °C) and 1.1% (5 °C). Increased pH-values of 6.6 (initially 5.5) were only measured for FW stored aerobically at 20 °C. In total, the energy potential was decreased by 31% (20 °C) and by 16% (5 °C). Thus, storage temperature and duration are crucial parameters for optimized aerobic FW storage leading to higher energy yields in AD. Instead, anaerobic storage of FW decreased pH-values to <5 while increasing WC in all samples (up to 67% at 20 °C). As oDM concentrations were preserved almost completely, the energy potential losses were only marginal proving that energy contents of FW could be preserved at household level. Consequently, energy yields in AD of FW could be increased through anaerobic storage conditions.

Specific Methane Yield of Wetland Biomass in Dry and Wet Fermentation Technologies

Our study evaluated the specific methane yield (SMY) of selected wetland species subjected to wet and dry anaerobic digestion: Carex elata All. (CE), a mixture (~50/50) of Carex elata All. and Carex acutiformis L. (CA), Phragmites australis (Cav.) Trin. ex Steud. (PA), Typha latifolia L. (TL) and Phalaris arundinacea L. (PAr). Plants were harvested in late September, and therefore, the study material was characterised by high lignin content. The highest lignin content (36.40 ± 1.04% TS) was observed in TL, while the lowest (16.03 ± 1.54% TS) was found in CA. PAr was characterised by the highest hemicellulose content (37.55 ± 1.04% TS), while the lowest (19.22 ± 1.22% TS) was observed in TL. Cellulose content was comparable in almost all plant species studied and ranged from 25.32 ± 1.48% TS to 29.37 ± 0.87% TS, except in PAr (16.90 ± 1.29% TS). The methane production potential differed significantly among species and anaerobic digestion (AD) technologies. The lowest SMY was observed for CE (121 ± 28 NL kgVS−1) with dry fermentation (D–F) technology, while the SMY of CA was the highest for both technologies, 275 ± 3 NL kgVS−1 with wet fermentation (W–F) technology and 228 ± 1 NL kgVS−1 with D–F technology. The results revealed that paludi-biomass could be used as a substrate in both AD technologies; however, biogas production was more effective for W–F. Nonetheless, the higher methane content in the biogas and the lower energy consumption of technological processes for D–F suggest that the final amount of energy remains similar for both technologies. The yield is critical in energy production by the AD of wetland plants; therefore, a promising source of feedstock for biogas production could be biomass from rewetted and previously drained areas, which are usually more productive than natural habitats.

Integrating ecosystem services into decision support for management of agroecosystems: Viva Grass tool

The area covered by low-input agroecosystems (e.g. semi-natural and permanent grasslands) in Europe has considerably decreased throughout the last century. To support more sustainable management practices and to promote biodiversity and ecosystem service values of such agroecosystems, a decision support tool was developed. The tool aims to enhance the implementation of ecosystem services and address the challenge of their integration into spatial planning.

The Viva Grass tool aims to enhance the maintenance of ecosystem services delivered by low-input agroecosystems. It does so by providing spatially-explicit decision support for land-use planning and sustainable management of agroecosystems. The Viva Grass tool is a multi-criteria decision analysis tool for integrated planning. It is designed for farmers, spatial planners and policy-makers to support decisions for management of agroecosystems. The tool has been tested to assess spatial planning in eight case studies across the Baltic States.

Bromatological, Proximate and Ultimate Analysis of OFMSW for Different Seasons and Collection Systems

In order to study the quality of organic fractions of municipal solid waste (OFMSW), five different municipalities in Tuscany were chosen for sampling according to the peculiarities of their collection systems. The five collection systems selected were sampled four times: during March, June, September and December, for a total of 20 picking analyses. In addition, emphasis was also given to the study of the variability of OFMSW composition related to ultimate, proximate and bromatological analyses. Road container collection systems proved to have a higher content of non-compostable and undesirable fractions (22%±1%) when compared to door-to-door systems (6% ± 1%). During months with lower temperature (March and December), the garden waste content in the OFMSW was negligible, with kitchen waste prevailing. This altered the physical chemical composition of OFMSW, which had a lower lignin content and higher methane production in the months with lower temperatures (272 ± 23 NLCH4 kgTVS−1) compared to June and September (238 ± 14 NLCH4 kgTVS−1). In general, the Tuscan OFMSW had a higher dry matter content (42%) than observed in previous studies. In conclusion, the result could direct possible future operators of anaerobic digestion plants towards the choice of dry and semi-dry technologies.

Trace elements effect on hydrolytic stage towards biogas production of model lignocellulosic substrates

The effect and the response of several trace elements (TE) addition to the anaerobic degradation of key compounds of lignocellulosic biomass were evaluated. Lignin, cellulose and xylose were selected as principal compounds of lignocellulosic biomass. Lignin degradation was only improved by the addition of 1000 mg Fe/L, which allowed an improvement on the methane yield coefficient of 28% compared to control. SEM images from an abiotic assay showed that this effect is more likely related with a chemical effect induced by the Fe solution, instead of an enzymatic response. Pre-treatments focused on breaking the recalcitrant structure of the lignin could be more promising than TE addition for rich lignin-content substrates. Unlike to the response observed with lignin, cellulose showed a clear effect of the TE addition on methane production rate, indicating a higher preponderance of the enzymatic activity compared to the lignin biomethanization. Experiments with xylose resulted in a strong accumulation of volatile fatty acids. TE addition should be adapted to the substrate composition given the different response of each lignocellulosic compound to the different TE addition.

The Future Agricultural Biogas Plant in Germany: A Vision

After nearly two decades of subsidized and energy crop-oriented development, agricultural biogas production in Germany is standing at a crossroads. Fundamental challenges need to be met. In this article we sketch a vision of a future agricultural biogas plant that is an integral part of the circular bioeconomy and works mainly on the base of residues. It is flexible with regard to feedstocks, digester operation, microbial communities and biogas output. It is modular in design and its operation is knowledge-based, information-driven and largely automated. It will be competitive with fossil energies and other renewable energies, profitable for farmers and plant operators and favorable for the national economy. In this paper we discuss the required contribution of research to achieve these aims.

Characteristics of the organic fraction of municipal solid waste and methane production: A review

Anaerobic digestion of the organic fraction of municipal solid waste (OFMSW) is a viable alternative for waste stabilization and energy recovery. Biogas production mainly depends on the type and amount of organic macromolecules. Based on results from different authors analysing OFMSW from different cities, this paper presents the importance of knowing the OFMSW composition to understand how anaerobic digestion can be used to produce methane. This analysis describes and discusses physical, chemical and bromatological characteristics of OFMSW reported by several authors from different countries and cities and their relationship to methane production. The main conclusion is that the differences are country and not city dependant. Cultural habits and OFMSW management systems do not allow a generalisation but the individual analysis for specific cities allow understanding the general characteristics for a better methane production. Not only are the OFMSW characteristics important but also the conditions under which the methane production tests were performed.