Rewiring the microbe-electrode interfaces with biologically reduced graphene oxide for improved bioelectrocatalysis

Release of Pb adsorbed on graphene oxide surfaces under conditions of Shewanella putrefaciens metabolism

In this study, Pb(II) was used as a target heavy metal pollutant, and the metabolism of Shewanella putrefaciens (S. putrefaciens) was applied to achieve reducing conditions to study the effect of microbial reduction on lead that was preadsorbed on graphene oxide (GO) surfaces. The results showed that GO was transformed to its reduced form (r-GO) by bacteria, and this process induced the release of Pb(II) adsorbed on the GO surfaces. After 72 hr of exposure in an S. putrefaciens system, 5.76% of the total adsorbed Pb(II) was stably dispersed in solution in the form of a Pb(II)-extracellular polymer substance (EPS) complex, while another portion of Pb(II) released from GO-Pb(II) was observed as lead phosphate hydroxide (Pb₁₀(PO₄)₆(OH)₂) precipitates or adsorbed species on the surface of the cell. Additionally, increasing pH induced the stripping of oxidative debris (OD) and elevated the content of dispersible Pb(II) in aqueous solution under the conditions of S. putrefaciens metabolism. These research results provide valuable information regarding the migration of heavy metals adsorbed on GO under reducing conditions due to microbial metabolism.

Preparation of biologically reduced graphene oxide-based aerogel and its application in dye adsorption

Graphene-based materials have attracted great attention in wastewater treatment due to their excellent adsorbability for refractory pollutants. However, the high cost, environmental pollution during preparation and the separation after adsorption are issues that restricted its widespread application. In this study, biologically reduced graphene oxide was prepared via bacterium Shewanella sp. CF8-6 in 12 h, and a 3D poly(vinyl alcohol)/BRGO aerogel (PVA-GA) was further synthesized using PVA as cross-linker. Results showed that BRGO had smooth surface, low I_D/I_G value (1.26) and smaller layer spacing (0.38 nm), indicating that the reaction process had little damage to GO structure. The prepared PVA-GA had strong mechanical strength and porous network structure, and its BET specific surface area was 59.02 m²/g. Benefit from the excellent structure of PVA-GA, it had good adsorption performance for methylene blue (MB) and Congo red (CR) (with removal rate of 94.62%, 93.97% and adsorption capacity of 135.17 mg/g, 134.24 mg/g at an initial dye concentration of 50 mg/L), and could maintain more than 75% removal rate after 5 cycles. This study developed a relatively mild and green way of graphene-based material synthesis and demonstrated the great potential of PVA-GA as an efficient and safe adsorbent for dye removal from wastewater.

Extracellular electron transfer leading to the biological mediated production of reduced graphene oxide

To explore a green, low-cost, and efficient strategy to synthesis reduced graphene oxide (RGO), the process and mechanism of the graphene oxide (GO) reduction by a model electrochemically active bacteria (EAB), Geobacter sulfurreducens PCA, were studied. In this work, up to 1.0 mg mL^-1 of GO was reduced by G. sulfurreducens within 0.5-8 days. I_D/I_G ratio in reduced product was similar to chemically RGO. After microbial reduction, the peak which corresponded to the reflection of graphene oxide (001) disappeared, while another peak considered as graphite spacing (002) appeared. The peak intensity of typical oxygen function groups, such as carboxyl C-O and >O (epoxide) groups, diminished in bacterially induced RGO comparing to initial GO. Besides, we observed the doping of nitrogen and phosphorus elements in bacterially induced RGO. In a good agreement with that, better electrochemical performance was noticed after GO reduction. As confirmed with differential pulse voltammetry (DPV) and cyclic voltammetry (CV) analysis, the maximum value of peak currents of bacterially induced RGO were significantly higher than those of GO. Our results showed the electron transfer at microbial cell/GO interface promoted the GO reduction, suggesting a broader application of EAB in biological mediated production of RGO.

Simultaneous copper removal and electricity production and microbial community in microbial fuel cells with different cathode catalysts

With graphene oxide (GO), platinum carbon (Pt/C), and reduced graphene oxide (rGO) as cathode catalysts, three types of single-chamber microbial fuel cells (MFCs) were constructed for simultaneous Cu²⁺ removal and electricity production. Results indicated rGO-MFC and Pt/C-MFC had much better Cu²⁺-removing and electricity-generating performance than that of GO-MFC, and rGO-MFC presented preferable electrochemical characteristics compared with Pt/C-MFC. Microbial community analysis indicated Geobacter dominated anodic biofilms and was mainly responsible for organics degradation and electricity generation. The dual bio-selective effects by cathode catalyst and toxic Cu²⁺ resulted in different cathodic microbial communities. At high Cu²⁺ contents, Nitratireductor, Ochrobactrum, and Serratia as efficient Cu²⁺-removing genera played key roles in Pt/C-MFC, and Azoarcus predominant in cathodic biofilms of rGO-MFC might be important contributor for the favorable performance in this case.

Bioelectrochemical approach for enhancing lignocellulose degradation and biofilm formation in Geobacillus strain WSUCF1

Investigations on microbial electrocatalysis as a strategy for enhancing the rates of substrate utilization leading to enhanced yield of biomass and enhanced biofilm formation are reported. A thermophilic Geobacillus sp. strain WSUCF1 (60 °C), a potential lignocellulose degrading microorganism was used as the electrocatalyst. Glucose, cellulose, and corn stover were used as the feedstocks. The results of this investigation showed that applying the oxidation potential of -0.383 mV (vs PRE) increased the glucose utilization and COD removal by 25.5% and 29.7% respectively. The bioelectrocatalysis strategy also increased the biomass yield by 81.2, 42.1, and 49.5% in the case of systems fed with glucose, cellulose, and corn stover, respectively, when compared with the systems without applied oxidation potential. This is the first work reporting the effects of applied oxidation potential on increasing the rates of degradation of lignocellulosic biomass and enhanced biofilm formation.

Short term atmospheric pressure cold plasma treatment: A novel strategy for enhancing the substrate utilization in a thermophile, Geobacillus sp. strain WSUCF1

The aim of this study was to investigate the effect of atmospheric pressure cold plasma on the microbial substrate utilization and biomass yield in a thermophilic strain. Geobacillus sp. strain WSUCF1, a thermophile capable of producing cellulolytic enzymes with higher activity was used for this investigation. Treatment with cold plasma for 4 min increased the rates of glucose utilization by 74% and biomass yield by 60% when compared with the control. WSUCF1 treated with plasma also displayed enhanced biofilm formation. This study for the first time, reports the use of cold plasma for enhancing the substrate utilization and biofilm formation in a thermophile.