N,N-Dimethylformamide solvent assisted hydrothermal pretreatment of Chlorella for coproduction of sugar, nitrogenous compounds and carbon dots

Transcriptome analysis reveals the molecular mechanisms by which carbon dots regulate the growth of Chlamydomonas reinhardtii

Carbon dots (CDs) have attracted increasing attention for their ability to artificially improve photosynthesis. Microalgal bioproducts have emerged as promising sources of sustainable nutrition and energy. However, the gene regulation mechanism of CDs on microalgae remains unexplored. The study synthesized red-emitting CDs and applied them to Chlamydomonas reinhardtii. Results showed that 0.5 mg/L-CDs acted as light supplements to promote cell division and biomass in C. reinhardtii. CDs improved the energy transfer of PS II, photochemical efficiency of PS II, and photosynthetic electron transfer. The pigment content and carbohydrate production slightly increased, while protein and lipid contents significantly increased (by 28.4% and 27.7%, respectively) in a short cultivation time. Transcriptome analysis identified 1166 differentially expressed genes. CDs resulted in faster cell growth by up-regulating the expression of genes associated with cell growth and death, promoting sister chromatid separation, accelerating the mitotic process and shortening the cell cycle. CDs improved the ability of energy conversion by up-regulating photosynthetic electron transfer-related genes. Carbohydrate metabolism-related genes were regulated and provided more available pyruvate for the citrate cycle. The study provides evidence for the genetic regulation of microalgal bioresources by artificially synthesized CDs.

Stalk-derived carbon dots as nanosensors for Fe3+ ions detection and biological cell imaging

Introduction: Iron is one of the most important needed elements for the growth and reproduction of living organisms. The detection of iron levels is important and developing fluorescent probes with excellent sensitivity for Fe³⁺ ions is of great significance. Carbon dot (CDs) is a new type of fluorescent nanomaterial based on abundant and low-cost carbon elements. The use of widely distributed renewable agricultural waste straw as a carbon precursor to prepare CDs sensor can not only reduce the pollution caused by burning straw to the atmospheric environment, but also achieve the transformation of resources from waste to treasure. Methods: In this study, CDs were obtained from corn stalk powder by pyrolysis and microwave process. The sensitivity and linear response range of CDs sensor was studied through analyzing the effect of different Fe³⁺ ions concentrations on the fluorescence quenching. The application of CDs in biological cell imaging was investigated using HGC-27 cells. Results: The fluorescence quenching showed a good linear relationship with the Fe3+ concentration in the range from 0 to 128 μM, and a low detection limit of 63 nM. In addition, the CDs have high recognition for Fe3+ ions. Meanwhile, the CDs have a low cytotoxicity and desirable biocompatibility, allowing the multicolor living cell imaging. Conclusion: The prepared CDs can be used as fluorescent sensors for the selective detection of Fe³⁺ ions and biological cell imaging. Our results supported that the conversion of agricultural waste into carbon nanomaterials has great potential to be developed.

Hydrothermal and photocatalytic synergistic pretreatment to improve the full utilization of corn stalk

In this study, the hydrothermal and photocatalytic synergistic pretreatment for improving the full component utilization of corn stalk based on lignin first biorefining was employed to generate carbohydrates and obtain modified lignin. The results showed that the highest lignin removal ratio (40.70 %) and cellulose retention ratio (92.64 %) were obtained due to the smallest energy gap (6.05 eV) and the largest penetration distance (1.73 Å) between GVL and the lignin. And the yield of carbohydrates increased from 1.95 % to 58.17 % after hydrothermal pretreatment at 180 ℃. Furthermore, the modified lignin enhanced the flocculation effect, resulting in the increase of the removal of safranine-T by 6 times. In addition, the chemical and physical properties of modified lignin were studied and the mechanism of photocatalysis modification was explored. The research provides a new pretreatment method for the utilization of biomass and simultaneously achieves carbohydrate enrichment in bio-oil and purification of dye wastewater.

Hydrothermal processing of microalgal biomass: Circular bio-economy perspectives for addressing food-water-energy nexus

Hydrothermal processing of microalgae is regarded as a promising technology to generate multitude of energy based and value-added products. The niche of hydrothermal technologies is still under infancy in terms of the technical discrepancies related to research and development. Thus, the present review critically surveyed the recent advancements linked to the influencing factors governing the algal hydrothermal processing in terms of the product yield and quality. The sustainability of hydrothermal technologies as a standalone method and in broader aspects of circular bio-based economy for energy and value-added platform chemicals are comprehensively discussed. Process optimization and strategic integration of technologies has been suggested to improve efficiency, with reduced energy usage and environmental impacts for addressing the energy-food-water supply chains. Within the wider economic transition and sustainability debate, the knowledge gaps identified and the research hotspots fostering future perspective solutions proposed herewith would facilitate its real-time implementation.