Synergistic substrates determination with biosensors

Laccase-catalyzed bisphenol A oxidation in the presence of 10-propyl sulfonic acid phenoxazine

The kinetics of the Coriolopsis byrsina laccase-catalyzed bisphenol A (BisA) oxidation was investigated in the absence and presence of electron-transfer mediator 3-phenoxazin-10-yl-propane-1-sulfonic acid (PPSA) at pH5.5 and 25°C. It was shown that oxidation rate of the hardly degrading compound BisA increased in the presence of the highly reactive substrate PPSA. The increase of reaction rate depends on PPSA and BisA concentrations as well on their ratio, e.g., at 0.2 mmol/L of BisA and 2 μmol/L of PPSA the rate increased 2 times. The kinetic data were analyzed using a scheme of synergistic laccase-catalyzed BisA oxidation. The calculated constant, characterizing reactivity of PPSA with laccase, is almost 1000 times higher than the constant, characterizing reactivity of BisA with laccase. This means that mediator-assisted BisA oxidation rate can be 1000 times higher in comparison to non-mediator reaction if compounds concentration is equal but very low.

Modelling of amperometric biosensor used for synergistic substrates determination

In this paper the operation of an amperometric biosensor producing a chemically amplified signal is modelled numerically. The chemical amplification is achieved by using synergistic substrates. The model is based on non-stationary reaction-diffusion equations. The model involves three layers (compartments): a layer of enzyme solution entrapped on the electrode surface, a dialysis membrane covering the enzyme layer and an outer diffusion layer which is modelled by the Nernst approach. The equation system is solved numerically by using the finite difference technique. The biosensor response and sensitivity are investigated by altering the model parameters influencing the enzyme kinetics as well as the mass transport by diffusion. The biosensor action was analyzed with a special emphasis to the effect of the chemical amplification. The simulation results qualitatively explain and confirm the experimentally observed effect of the synergistic substrates conversion on the biosensor response.

Modelling Amperometric Biosensors Based on Chemically Modified Electrodes

The response of an amperometric biosensor based on a chemically modified electrode was modelled numerically. A mathematical model of the biosensor is based on a system of non-linear reaction-diffusion equations. The modelling biosensor comprises two compartments: an enzyme layer and an outer diffusion layer. In order to define the main governing parameters the corresponding dimensionless mathematical model was derived. The digital simulation was carried out using the finite difference technique. The adequacy of the model was evaluated using analytical solutions known for very specific cases of the model parameters. By changing model parameters the output results were numerically analyzed at transition and steady state conditions. The influence of the substrate and mediator concentrations as well as of the thicknesses of the enzyme and diffusion layers on the biosensor response was investigated. Calculations showed complex kinetics of the biosensor response, especially when the biosensor acts under a mixed limitation of the diffusion and the enzyme interaction with the substrate.

Mediator-assisted laccase-catalyzed oxidation of 4-hydroxybiphenyl

The kinetics of oxidation of 4-hydroxybiphenyl (4-HBP) catalyzed by laccase from Polyporus pinsitus was studied in the presence of methyl syringate (MS), which acts as an electron-transfer mediator. Measurements were performed in 0.05 M acetate buffer, pH 5.5, in the presence of 4-HBP, MS, and laccase. It is shown that the oxidation rate of the lowly reactive substrate 4-HBP significantly increases during synergistic action of the highly reactive substrate MS. Bimolecular kinetic constants of interaction between the oxidized form of laccase and MS, the former and 4-HBP, and the oxidized form of MS and 4-HBP were calculated. A kinetic scheme of the synergistic substrate action is suggested; based on this scheme, the dependence of the initial rate on reagent concentration is derived. Analyzing experimental data, we obtained kinetic constants close to those obtained by modeling the processes.