Using a cell-based gas biosensor for investigation of adverse effects of acetone vapors in vitro

Exhaled breath biomarker sensing

This goal of this minireview is to introduce the reader to the area of research concerned with exhaled breath analysis for the purpose of detecting abnormal levels of physiologically-relevant chemical markers reflective of respiratory diseases. Two main two groups of sensing methods are reviewed: mass spectrometry and (bio)sensors. The discussion focuses on biosensor applications for EB and EBC analyses, which are presented in detail. The review finishes with conclusions and future perspectives, including recommendations for future near-term and long-term development of EBC biomarker sensing.

An acetone bio-sniffer (gas phase biosensor) enabling assessment of lipid metabolism from exhaled breath

Several volatile organic compounds (VOCs) are released from human breath or skin. Like chemical substances in blood or urine, some of these vapors can provide valuable information regarding the state of the human body. A highly sensitive acetone biochemical gas sensor (bio-sniffer) was developed and used to measure exhaled breath acetone concentration, and assess lipid metabolism based on breath acetone analysis. A fiber-optic biochemical gas sensing system was constructed by attaching a flow-cell with nicotinamide adenine dinucleotide (NADH)-dependent secondary alcohol dehydrogenase (S-ADH) immobilized membrane onto a fiber-optic NADH measurement system. The NADH measurement system utilizes an ultraviolet-light emitting diode with peak emission of 335 nm as an excitation light source. NADH is consumed by the enzymatic reaction of S-ADH, and the consumption is proportional to the concentration of acetone vapor. Phosphate buffer which contained NADH was circulated into the flow-cell to rinse products and the excessive substrates from the optode. The change of fluorescent emitted from NADH is analyzed by the PMT. Hence, fluorescence intensity decreased as the acetone concentration increased. The relationship between fluorescence intensity and acetone concentration was identified from 20 ppb to 5300 ppb. This interval included the concentration of acetone vapor in the breath of healthy people and those suffering from disorders of carbohydrate metabolism. Finally, the acetone bio-sniffer was used to measure breath acetone during an exercise stress test on an ergometer after a period of fasting. The concentration of acetone in breath was shown to significantly increase after exercise. This biosensor allows rapid, highly sensitive and selective measurement of lipid metabolism.

The heat-transfer method: a versatile low-cost, label-free, fast, and user-friendly readout platform for biosensor applications

In recent years, biosensors have become increasingly important in various scientific domains including medicine, biology, and pharmacology, resulting in an increased demand for fast and effective readout techniques. In this Spotlight on Applications, we report on the recently developed heat-transfer method (HTM) and illustrate the use of the technique by zooming in on four established bio(mimetic) sensor applications: (i) mutation analysis in DNA sequences, (ii) cancer cell identification through surface-imprinted polymers, (iii) detection of neurotransmitters with molecularly imprinted polymers, and (iv) phase-transition analysis in lipid vesicle layers. The methodology is based on changes in heat-transfer resistance at a functionalized solid-liquid interface. To this extent, the device applies a temperature gradient over this interface and monitors the temperature underneath and above the functionalized chip in time. The heat-transfer resistance can be obtained by dividing this temperature gradient by the power needed to achieve a programmed temperature. The low-cost, fast, label-free and user-friendly nature of the technology in combination with a high degree of specificity, selectivity, and sensitivity makes HTM a promising sensor technology.

Selective identification of macrophages and cancer cells based on thermal transport through surface-imprinted polymer layers

In this article, we describe a novel straightforward method for the specific identification of viable cells (macrophages and cancer cell lines MCF-7 and Jurkat) in a buffer solution. The detection of the various cell types is based on changes of the heat transfer resistance at the solid-liquid interface of a thermal sensor device induced by binding of the cells to a surface-imprinted polymer layer covering an aluminum chip. We observed that the binding of cells to the polymer layer results in a measurable increase of heat transfer resistance, meaning that the cells act as a thermally insulating layer. The detection limit was found to be on the order of 10(4) cells/mL, and mutual cross-selectivity effects between the cells and different types of imprints were carefully characterized. Finally, a rinsing method was applied, allowing for the specific detection of cancer cells with their respective imprints while the cross-selectivity toward peripheral blood mononuclear cells was negligible. The concept of the sensor platform is fast and low-cost while allowing also for repetitive measurements.

On-site airborne pheromone sensing

Pheromones and other semiochemicals play an important role in the natural world by influencing the behavior of plants, mammals, and insects. In the latter case, species-dependent pheromone communication has numerous applications, including the detection, trapping, monitoring and guiding of insects, as well as pest management in agriculture. On-site sensors are desirable when volatile organic compounds (VOCs) are used as semiochemicals. Insects have evolved highly selective sensors for such compounds, so biosensors comprising complete insects, isolated organs or individual proteins can be highly effective. However, isolated insect organs have a limited lifetime as biosensor, so biomimetic approaches are needed for prolonged monitoring, novel applications, or measurements in challenging environments. We discuss the development of on-site biosensors and biomimetic approaches for airborne-pheromone sensing, together with biomimetic VOC sensor systems. Furthermore, the infochemical effect describing the anthropogenic contamination of the ecosystem through semiochemicals, will be considered in the context of novel on-site pheromone sensing-systems.