A novel sensitive colorimetric sensor for Cu2+ based on in situ formation of fluorescent quantum dots with photocatalytic activity

Colorimetric Sensors for Chemical and Biological Sensing Applications

Colorimetric sensors have been widely used to detect numerous analytes due to their cost-effectiveness, high sensitivity and specificity, and clear visibility, even with the naked eye. In recent years, the emergence of advanced nanomaterials has greatly improved the development of colorimetric sensors. This review focuses on the recent (from the years 2015 to 2022) advances in the design, fabrication, and applications of colorimetric sensors. First, the classification and sensing mechanisms of colorimetric sensors are briefly described, and the design of colorimetric sensors based on several typical nanomaterials, including graphene and its derivatives, metal and metal oxide nanoparticles, DNA nanomaterials, quantum dots, and some other materials are discussed. Then the applications, especially for the detection of metallic and non-metallic ions, proteins, small molecules, gas, virus and bacteria, and DNA/RNA are summarized. Finally, the remaining challenges and future trends in the development of colorimetric sensors are also discussed.

CdSe/ZnS QDs embedded polyethersulfone fluorescence composite membrane for sensitive detection of copper ions in various drinks

The copper ion was detected rapidly by a novel sensing membrane in this paper for its damage to health and the environment. CdSe/ZnS QDs modified polyethersulfone membrane (QDs@PESM) was made by phase-inversion method using a membrane separation technique and quantum dots (QDs). When the sample passed through the membrane, the copper ions in the sample caused the membrane's fluorescence to be quenched. The fluorescence quenching value of the membrane is used to calculate the concentration of copper ions. With R²= 0.9964, Cu²⁺could be quantitatively detected over a wide concentration range (10-1000 μg/L). The method's LOD and LOQ were 4.27 and 14.23 μg/L, respectively. When the CdSe/ZnS QDs@PESM was used to analyze Cu²⁺ in various real drinks, including well water, baijiu, orange juice, beer, and milk, the recovery ranged from 79.1 to 123.9%, indicating that the CdSe/ZnS QDs@PESM can be used as a rapid, simple and reliable method to determine Cu²⁺ in various matrices.

Fluorescence and Colorimetric Dual-Mode Ratiometric Sensor Based on Zr-Tetraphenylporphyrin Tetrasulfonic Acid Hydrate Metal-Organic Frameworks for Visual Detection of Copper Ions

As a special heavy metal ion, copper ions (Cu²⁺) play an indispensable role in the fields of environmental protection and safety. Their excessive intake not only easily leads to diseases but also affects human health. Therefore, it is particularly important to construct a facile, effective, and highly selective Cu²⁺ probe. Herein, a novel Zr-tetraphenylporphyrin tetrasulfonic acid hydrate (TPPS) metal-organic framework (ZTM) was fabricated using TPPS as the ligand and exhibited strong red fluorescence with a high quantum yield of 12.22%. In addition, we designed a ratiometric fluorescent probe by introducing green fluorescein isothiocyanate (FITC), which was not subject to environmental interference and had high accuracy. When exposed to different amounts of Cu²⁺, the fluorescence emission at 667 nm from ZTMs is remarkably quenched, while that at 515 nm from FITC is enhanced, accompanied by a change in the solutions' fluorescence color from red to green under a UV lamp. Besides, the ZTMs solutions display an excellent ratiometric colorimetric response for Cu²⁺ and produce an obvious color change (from green to colorless) that is visible to the naked eye. The fabricated ZTMs@FITC fluorescent probe exhibits distinguished performance for Cu²⁺ detection with linear ranges of 0.1 to 5 μM and 5 to 50 μM, as well as a low detection limit of 5.61 nM. Moreover, a colorimetric sensor based on ZTMs exhibits a good linear range from 0.1 to 20 μM for Cu²⁺ with the detection limit of 4.96 nM. Furthermore, the dual-signal ratiometric sensor has significant specificity for Cu²⁺ and is successfully applied for monitoring Cu²⁺ in water samples, which proves its practical application value in the environment and biological systems.

A Simple Colorimetric Assay for Sensitive Cu2+ Detection Based on the Glutathione-Mediated Etching of MnO2 Nanosheets

In this paper, we developed a quick, economical and sensitive colorimetric strategy for copper ions (Cu²⁺) quantification via the redox response of MnO₂ nanosheets with glutathione (GSH). This reaction consumed MnO₂ nanosheets, which acted as a catalyst for the oxidation of 3,3',5,5'-tetramethylbenzidine (TMB) to a blue product (oxTMB). In the presence of Cu²⁺, the GSH was catalyzed to GSSG (oxidized glutathione), and the solution changed from colorless to deep blue. Under the optimum conditions, the absorption signal of the oxidized product (oxTMB) became proportional to Cu²⁺ concentration in the range from 10 to 300 nM with a detection limit of 6.9 nM. This detection system showed high specificity for Cu²⁺. Moreover, the system has been efficaciously implemented for Cu²⁺ detection in actual tap water samples. The layered-nanostructures of MnO₂ nanosheets make it possess high chemical and thermal stability. TMB can be quickly oxidized within 10 min by the catalyzing of MnO₂ nanosheets with high oxidase-like activity. There is no need of expensive reagents, additional H₂O₂ and complicated modification processes during the colorimetric assay. Therefore, the strategy primarily based on MnO₂ nanosheets is promising for real-time, rapid and highly sensitive detection of Cu²⁺ under practical conditions.

Recent Advances in Nanomaterials for Analysis of Trace Heavy Metals

In an effort to achieve high sensitivity analysis methods for ultra-trace levels of heavy metals, numerous new nanomaterials are explored for the application in preconcentration processes and sensing systems. Nanomaterial-based methods have proven to be effective for selective analysis and speciation of heavy metals in combination with spectrometric techniques. This review outlined the different types of nanomaterials applied in the field of heavy metal analysis, and concentrated on the latest developments in various new materials. In particular, the functionalization of traditional materials and the exploitation of bio-functional materials could increase the specificity to target metals. The hybridization of multiple materials could improve material properties, to build novel sensor system or achieve detection-removal integration. Finally, we discussed the future perspectives of nanomaterials in the heavy metal preconcentration and sensor design, as well as their respective advantages and challenges. Despite impressive progress and widespread attention, the development of new nanomaterials and nanotechnology is still hampered by numerous challenges, particularly in the specificity to the target and the anti-interference performance in complex matrices.

Dual-Response Detection of Oxidized Glutathione, Ascorbic Acid, and Cell Imaging Based on pH/Redox Dual-Sensitive Fluorescent Carbon Dots

The pH/redox dual-sensitive fluorescent carbon dots (pHRCDs) with the fluorescence quantum yield of 16.97% were synthesized by the pyrolysis of l-glutamic acid (l-glu) and dopamine (DA). Compared with the quantum dot (QD)-dopamine conjugate, when the pH value of the solution was changed from neutral to alkaline, the pHRCDs exhibited unique optical phenomenon including red-shift of fluorescence peak and the fluorescence intensity first decreasing from pH 7 to 10 and then increasing from pH 10 to 13. The pHRCDs could be developed for a discriminative and highly sensitive dual-response fluorescent probe for the detection of oxidized glutathione (GSSG) and ascorbic acid (AA) activity in human blood. Under the optimized experimental conditions, the dual-response fluorescent probe can detect GSSG and AA in the linear range of 1.2-3.6 and 27-35 μM with the detection limits of 0.1 and 3.1 μM, respectively. In addition, the pHRCDs demonstrated low cytotoxicity and good biocompatibility, which can be well applied to in vitro cell imaging, and the pHRCDs/GSH fluorescence system has been successfully developed for the detection of AA in real samples.

Triazole-stabilized fluorescence sensor for highly selective detection of copper in tea and animal feed

A triazole-stabilized fluorescence sensor is developed for copper detection in the study. Tris-(benzyltriazolylmethyl)amine (TBTA) is used to improve the sensitivity and stability for the sensing system. A series of comparative experiments are performed with and without TBTA. In the presence of TBTA, the fluorescence decrease ratio is enhanced from 2.46 to 118.25; the detection limit is reduced from 67 nM to 3.6 nM; the higher selectivity toward copper compared to the other metal ions is verified, including K⁺, Ca²⁺, Cd²⁺, Zn²⁺, Mg²⁺, Mn²⁺, Pb²⁺, Hg²⁺, Fe³⁺ and Cr³⁺. Besides, the sensing system is successfully applied for copper determination in complex tea samples and chicken feed samples with the recovery range of 91.67-116.8%. A good consistency between the presented sensor and the flame atom absorbance spectrometry (FAAS) is confirmed by the low relative errors with the range from -2.39% to 7.02%.

Metal and metal-oxide nanozymes: bioenzymatic characteristics, catalytic mechanism, and eco-environmental applications

Phenolic contaminants (R-OH) are a category of highly toxic organic compounds that are widespread in aquatic ecosystems and can induce carcinogenic risk to wildlife and humans; natural enzymes as green catalysts are capable of step-polymerizing these compounds to produce diverse macromolecular self-coupling products via radical-mediated C-C and C-O-C bonding at either the ortho- or para-carbon position, thereby evading the bioavailability and ecotoxicity of these compounds. Intriguingly, certain artificial metal and metal-oxide nanomaterials are known as nanozymes. They not only possess the unique properties of nanomaterials but also display intrinsic enzyme-mimicking activities. These artificial nanozymes are expected to surmount the shortcomings, such as low stability, easy inactivation, difficult recycling, and high cost, of natural enzymes, thus contributing to eco-environmental restoration. This review highlights the available studies on the enzymatic characteristics and catalytic mechanisms of natural enzymes and artificial metal and metal-oxide nanozymes in the removal and transformation of R-OH. These advances will provide key research directions beneficial to the multifunctional applications of artificial nanozymes in aquatic ecosystems.

Cu2+-Modulated in situ growth of quantum dots for split-type photoelectrochemical immunoassay of prostate-specific antigen

A split-type photoelectrochemical immunosensor of PSA was developed using Cu²⁺-dependent catalytic oxidation for inhibiting the in situ growth of CdS QDs.

A facile electrochemical aptasensor for lysozyme detection based on target-induced turn-off of photosensitization

The quantification of proteins is essential in fundamental research or clinical applications. Here, we developed a facile electrochemical aptasensor based on target-induced turn-off of photosensitization for label-free and ultrasensitive detection of protein (exemplified by lysozyme). EB (ethidium bromide) molecules that were embedded in dsDNA between lysozyme binding aptamer and complementary DNA immobilized on the electrode, could photo-cleave the dsDNA via singlet oxygen (O₂¹) during photosensitization, resulting in a high voltammetry current of the [Fe(CN)₆]^3-/4-. Upon recognition of the lysozyme by aptamer, the EB molecules were released from dsDNA, and its photosensitization activity was turned off. As a result, more amount of complementary DNA was retained on the Au nanoparticles modified carbon nanotube paste electrode (AuNPs-CNPE), leading to a declined voltammetry current. Such a sensing strategy allowed detection of 10 pM-1 µM lysozyme with a low detection limit (about 2 pM). Besides, the sensor was free of labeling procedure as well as extra signal amplification step, and the CNPE modification was quite simple, only with AuNPs. The sensor also showed excellent selectivity toward lysozyme in the presence of interfering proteins, such as thrombin, bovine serum albumin, myoglobin, etc. The proposed sensor was applied to the determination of lysozyme in urine samples with the recoveries ranging from 96.6% to 101%. The proposed biosensor holds a great promise in developing other electrochemical sensors based on photosensitization.

Profuse color-evolution-based fluorescent test paper sensor for rapid and visual monitoring of endogenous Cu2+ in human urine

The fluorescent paper for colorimetric detection of metal ions has been widely fabricated using various sensing probes, but it still remains an elusive task to design a test paper with multicolor variation with target dosages for accurate determination. Herein, we report a profuse color-evolution-based fluorescent test paper sensor for rapid and visual monitoring of Cu²⁺ in human urine by printing tricolor probe onto filter paper. The tricolor probe consists of blue-emission carbon dots (bCDs), green-emission quantum dots (gQDs) and red-emission quantum dots (rQDs), which is based on the principle that the fluorescence of gQDs and rQDs are simultaneously quenched by Cu²⁺, whereas the bCDs as the photostable internal standard is insensitive to Cu²⁺. Upon the addition of different amounts of Cu²⁺, the ratiometric fluorescence intensity of the tricolor probe continuously varied, leading to color changes from shallow pink to blue with a detection limit of 1.3nM. When the tricolor probe solution was printed onto a sheet of filter paper, as-obtained test paper displayed a more profuse color evolution from shallow pink to light salmon to dark orange to olive drab to dark olive green to slate blue to royal blue and to final dark blue with the increase of Cu²⁺ concentration compared with dual-color probe-based test paper, and dosage scale as low as 6.0nM was clearly discriminated. The sensing test paper is simple, rapid and inexpensive, and serves as a visual platform for ultrasensitive monitoring of endogenous Cu²⁺ in human urine.