Disposable electrochemical glucose sensor based on water-soluble quinone-based mediators with flavin adenine dinucleotide-dependent glucose dehydrogenase

Enhanced bioelectricity generation in thermophilic microbial fuel cell with lignocellulose as an electron donor by resazurin-mediated electron transfer

Microbial fuel cell (MFC) with lignocellulose as an electron donor is considered a sustainable biorefinery. However, low lignocellulose degradation and energy output restrict the scale of application. Herein, the extracellular electron transfer (EET) capacity of Acetivibrio thermocellus DSM 1313 with lignocellulose as substrate was shown to be mediated by the self-produced flavin, and its intracellular electron transfer went through the whole respiratory chain. Thermophilic MFC with resazurin exhibited an increase in the open circuit voltage by 37.78%, and a 2.60 folds increase in power density of 77.85 mW/m2, respectively. Differential pulse voltammetry and electrochemical impedance spectroscopy analysis indicated that resazurin decreased the solution and anode charge transfer resistance, and enhanced the extracellular electrochemical activity. Furthermore, resazurin resulted in a lower redox potential, allowing preferential electron transfer to resazurin rather than flavin. This research establishes a resazurin-mediated thermophilic MFC with lignocellulose as substrate, which provides novel idea on the biomass refinery.

Direct Electrochemistry of Glucose Dehydrogenase-Functionalized Polymers on a Modified Glassy Carbon Electrode and Its Molecular Recognition of Glucose

A glucose biosensor was layer-by-layer assembled on a modified glassy carbon electrode (GCE) from a nanocomposite of NAD(P)⁺-dependent glucose dehydrogenase, aminated polyethylene glycol (mPEG), carboxylic acid-functionalized multi-wall carbon nanotubes (fMWCNTs), and ionic liquid (IL) composite functional polymers. The electrochemical electrode was denoted as NF/IL/GDH/mPEG-fMWCNTs/GCE. The composite polymer membranes were characterized by cyclic voltammetry, ultraviolet-visible spectrophotometry, electrochemical impedance spectroscopy, scanning electron microscopy, and transmission electron microscopy. The cyclic voltammogram of the modified electrode had a pair of well-defined quasi-reversible redox peaks with a formal potential of -61 mV (vs. Ag/AgCl) at a scan rate of 0.05 V s^-1. The heterogeneous electron transfer constant (k_s) of GDH on the composite functional polymer-modified GCE was 6.5 s^-1. The biosensor could sensitively recognize and detect glucose linearly from 0.8 to 100 µM with a detection limit down to 0.46 μM (S/N = 3) and a sensitivity of 29.1 nA μM^-1. The apparent Michaelis-Menten constant (Kmapp) of the modified electrode was 0.21 mM. The constructed electrochemical sensor was compared with the high-performance liquid chromatography method for the determination of glucose in commercially available glucose injections. The results demonstrated that the sensor was highly accurate and could be used for the rapid and quantitative determination of glucose concentration.

A disposable enzymatic biofuel cell for glucose sensing via short-circuit current

It is essential to construct a biofuel cell-based sensor and develop an effective strategy to detect glucose without any potentiostat circuitry in order to create a simple and miniaturized device. In this report, an enzymatic biofuel cell (EBFC) is fabricated by the facile design of an anode and cathode on a screen-printed carbon electrode (SPCE). To construct the anode, thionine and flavin adenine dinucleotide-dependent glucose dehydrogenase (FAD-GDH) are covalently immobilized via a crosslinker to make a cross-linked redox network. As a cathode, the Pt-free oxygen reduction carbon catalyst is employed alternative to the commonly used bilirubin oxidase. We proposed the importance of EBFC-based sensors through the connection of anode and cathode; they can identify a short-circuit current by means of applied zero external voltage, thereby capable of glucose detection without under the operation of the potentiostat. The result shows that the EBFC-based sensor could be able to detect based on a short-circuit current with a wide range of glucose concentrations from 0.28 to 30 mM. Further, an EBFC is employed as a one-compartment model energy harvester with a maximum power density of (36 ± 3) μW cm^{- 2} in sample volume 5 μL. In addition, the constructed EBFC-based sensor demonstrates that the physiological range of ascorbic acid and uric acid shows no significant effect on the short-circuit current generation. Moreover, this EBFC can be used as a sensor in artificial plasma without losing its performance and thereby used as a disposable test strip in real blood sample analysis.