Urban sewage scum and primary sludge as profitable sources of biodiesel and biolubricants of new generation

Valorization of fat balls and primary scum from wastewater treatment: a promising renewable lipid feedstock for biodiesel production

We investigated the potential of waste materials from wastewater treatment plants (WWTPs) to serve as an alternative lipid feedstock for biodiesel production. The average lipid recoveries from fat balls (46.4%) and primary scum (49.5-54.5%) were higher than the lipid recovery of primary sludge (15.8-16.4%). The yield of biodiesel produced from the extracted lipids ranged from 5.7 to 20.1%. There were considerable site- and season-dependent variations in the characteristics of the lipid waste materials. Radiocarbon analysis indicated the presence of fossil-derived carbon (26.0-42.0%) in the biodiesel obtained from wastewater lipids. Finally, we estimated the potential for biodiesel production from WWTP-derived lipids; about 333.0 metric tons of biodiesel per year could be produced from fat balls and primary scum in Japan. The results indicate that lipid-rich materials from WWTPs represent a valuable alternative feedstock for biodiesel production.

Lipid extraction in the primary sludge generated from urban wastewater treatment: characteristics and seasonal composition analysis

A seasonal study of the lipid composition of a primary sludge (dry and dewatered base) obtained from an urban wastewater treatment plant located in Aguascalientes (Mexico) is reported. This study assessed the variability in sludge composition to establish its potential as a raw material for biodiesel production. Lipid recovery was achieved by extraction using two solvents. Hexane was employed for lipid extraction from dry sludge, whereas hexane and ethyl butyrate were used for comparison with dewatered sludge. The formation (%) of fatty acid methyl esters (biodiesel) was determined using extracted lipids. The extraction results from the dry sludge showed 14 and 6% of recovered lipids and their conversion to biodiesel, respectively. For the dewatered sludge, the lipid recovery and biodiesel formation were 17.4 and 60% using hexane, and 23 and 77% for ethyl butyrate, respectively, on a dry basis. Statistical data indicated that lipid recovery depended on the physicochemical characteristics of sewage sludge, which were related to seasonal changes, population activities, and changes in plant configuration, among other factors. These variables must be considered in the design of large-scale extraction equipment for the application and commercial exploitation of biomass waste in biofuel production.

Recent advances in valorization of organic municipal waste into energy using biorefinery approach, environment and economic analysis

Researcher's all around works on a copious technique to lessen waste production and superintend the waste management for long-term socio-economic and environmental benefits. Value-added products can be produced from municipal waste by using holistic and integrated approaches. In this review, a detail about the superiority of the different methods like anaerobic digestion, biofuel production, incineration, pyrolysis and gasification were used for the conversion of municipal waste to feedstock for alternate energy and its economic- environmental impacts were consolidated. Most conversion techniques were environmentally friendly to manage municipal waste. The biological process was more economically feasible compare to the thermal process, for the reason thermal process required a large amount of capital investment and energy utilization. In the thermal process, gasification shows low emission, and pyrolysis shows low capital investment and economically feasible compare to other thermal processes. Waste to energy technology significantly reduced the emission and energy demand.

A Novel and Efficient Method for the Synthesis of Methyl (R)-10-Hydroxystearate and FAMEs from Sewage Scum

In this work, the transesterification of methyl estolides (ME) extracted from the lipid component present in the sewage scum was investigated. Methyl 10-(R)-hydroxystearate (Me-10-HSA) and Fatty Acid Methyl Esters (FAMEs) were obtained in a single step. A three-level and four factorial Box–Behnken experimental design were used to study the effects of methanol amounts, catalyst, temperature, and reaction time on the transesterification reaction using aluminum chloride hexahydrate (AlCl3·6H2O) or hydrochloric acid (HCl) as catalysts. AlCl3·6H2O was found quite active as well as conventional homogeneous acid catalysts as HCl. In both cases, a complete conversion of ME into Me-10-HSA and FAMEs was observed. The products were isolated, quantified, and fully characterized. At the end of the process, Me-10-HSA (32.3%wt) was purified through a chromatographic separation and analyzed by NMR. The high enantiomeric excess (ee > 92%) of the R-enantiomer isomer opens a new scenario for the valorization of sewage scum.