Radiation grafting of N-vinylcaprolactam onto nano and macrogels of chitosan: Synthesis and characterization

A Pickering emulsion stabilized by Chitosan-g-Poly(N-vinylcaprolactam) microgels: Interface formation, stability and stimuli-responsiveness

Pickering emulsions stabilized by solid particles are more stable and environmentally friendly compared to traditional surfactants. Herein, a series of Chitosan-g-Poly(N-vinylcaprolactam) (CS-g-PNVCL) microgel particles were synthesized via a free radical surfactant-free emulsion copolymerization and the obtained particles were used to stabilize Pickering emulsions. It is found that the ratio (CS/PNVCL = 60 wt%) was optimal to produce Pickering emulsions. The microstructures of Pickering emulsions can maintain for 60 days at room temperature and this long-term stability is attributed to the CS-g-PNVCL microgel particles adsorbed at the oil-water interface. The Pickering emulsions displayed thermo-responsive characteristics when exposed to environmental stimuli. The emulsions became destabilized with an increase in pH and temperature. The droplets turned unstable and irregular due to excessive NaCl concentration, caused by electrostatic repulsion between the microgel particles. This study presents a novel way to form smart and uniform Pickering emulsions with the application potential in food, cosmetics, and drug delivery, etc.

Natural Polysaccharide-Based Hydrogels Used for Dye Removal

Removal of contaminants from discharge water is vital and demands urgent assistance with the goal to keep clean water. Adsorption is one of the most common, efficient, and low-priced methods used in water treatment. Various polysaccharide-based gels have been used as efficient dye adsorbents from wastewater. This review summarizes cutting-edge research of the last decade of different hydrogels based on natural polysaccharides (chitin, chitosan, cellulose, starch, pullulan, and dextran) concerning their dye adsorption efficiency. Beyond their natural abundance, attributes of polysaccharides such as biocompatibility, biodegradability, and low cost make them not only efficient, but also environmentally sustainable candidates for water purification. The synthesis and dye removal performance together with the effect of diverse factors on gels retaining ability, kinetic, and isotherm models encountered in adsorption studies, are introduced. Thermodynamic parameters, sorbent recycling capacity along with conclusions and future prospects are also presented.

Exploring microgel adsorption: synthesis, classification, and pollutant removal dynamics

Microgels have gained significant importance for the removal of pollutants owing to their stimulus-responsive behavior, high stability, and reusable capacity. However, despite these advantages, several hurdles need to be overcome to fully maximize their potential as effective adsorbents for eradicating various contaminants from the environment, such as metallic cations, organic compounds, anions, harmful gases, and dyes. Therefore, a critical review on the adsorption of pollutants by microgels is needed. In this regard, this review presents the latest developments in the adsorptive properties of microgels. The synthetic methods, architectural structures, and stimulus-responsive behavior of microgels are explained in detail. In addition, this review explores various factors that directly influence the adsorption of pollutants by microgels, such as pH, feed composition, content of pollutants, content of comonomers, agitation time, temperature, microgel dose, nature of both adsorbates (pollutants) and adsorbents (microgels), nature of the medium, and ionic strength. Various adsorption isotherms are also explored together with the kinetic aspects of the adsorption process to provide a comprehensive understanding.

Synthesis and characterization of n-phosphonium chitosan and its virucidal activity evaluation against coronavirus

Despite the worldwide vaccination effort against COVID-19, the demand for biocidal materials has increased. One promising solution is the chemical modification of polysaccharides, such as chitosan, which can provide antiviral activity through the insertion of cationic terminals. In this study, chitosan was modified with (4-carboxybutyl) triphenylphosphonium bromide to create N-phosphonium chitosan (NPCS), a quaternized derivative. The resulting NPCS samples with three degrees of substitution (15.6 %, 19.8 % and 24.2 %) were characterized and found to have improved solubility in water and alkaline solutions but reduced thermal stability. The particles zeta potential exhibits positive charges and is directly correlated with the degree of substitution of the derivative. In virucidal assays, all NPCS samples were able to inhibit 99.999 % of the MHV-3 coronavirus within 5 min at low concentrations of 0.1 mg/mL, while maintaining low cytotoxicity to L929 cells. In addition to its potential application against current coronavirus strains, NPCS could also be valuable in combating future pandemics caused by other viral pathogens. The antiviral properties of NPCS make it a promising material for use in coating surface and personal protective equipment to limit the spread of disease-causing viruses.

Alginate Hydrogels with Aloe vera: The Effects of Reaction Temperature on Morphology and Thermal Properties

In this study, we investigated the impact of reaction temperature on the physicochemical, structural, morphological, and thermal properties of sodium alginate/poly (vinyl alcohol)-based hydrogels, both in the pure form and with the addition of 20% (v/v) Aloe vera solution. The materials were prepared by chemical crosslinking at temperatures in the range of 65–75 °C. Poly (ethylene glycol) diacrylate was used as a crosslinking agent. The extent to which the crosslinking reaction proceeded was studied as a function of the reaction temperature, along with the thermal properties and morphology of the final materials. A measurement of gel fraction, in agreement with differential scanning calorimetry and Fourier transform infrared spectroscopy, showed that a higher temperature of reaction promoted the crosslinking reaction. On the basis of the aforementioned techniques, as well as by energy dispersive X-ray analysis under an electron microscope, it was also shown that the bioadditive Aloe vera promoted the crosslinking reaction.

Binary Graft of Poly(N-vinylcaprolactam) and Poly(acrylic acid) onto Chitosan Hydrogels Using Ionizing Radiation for the Retention and Controlled Release of Therapeutic Compounds

In this study, we carried out the synthesis of a thermo- and pH-sensitive binary graft, based on N-vinylcaprolactam (NVCL) and pH sensitive acrylic acid (AAc) monomers, onto chitosan gels (net-CS) by ionizing radiation. Pre-oxidative irradiation and direct methods were examined, and materials obtained were characterized by FTIR-ATR, thermogravimetric analysis (TGA), scanning electron microscopy (SEM), and swelling tests (equilibrium swelling time, critical pH, and temperature). The best synthesis radiation method was the direct method, which resulted in the maximum grafting percentages (~40%) at low doses (10–12 kGy). The main goal of this study was the comparison of the swelling behavior and physicochemical properties of net-CS with those of the binary system (net-CS)-g-NVCL/AAc with the optimum grafting percentage (~30%). This produced a material that showed an upper critical solution temperature (UCST) of 33.5 °C and a critical pH value of 3.8, indicating the system is more hydrophilic at higher temperatures and low pH values. Load and release studies were carried out using diclofenac. The grafted system (32%) was able to load 19.3 mg g⁻¹ of diclofenac and release about 95% within 200 min, in comparison to net-CS, which only released 80% during the same period. When the grafted system was protonated before diclofenac loading, it loaded 27.6 mg g⁻¹. However, the drug was strongly retained in the material by electrostatic interactions and only released about 20%.

Natural Polymer-based Stimuli-responsive Hydrogels

The abilities of intelligent polymer hydrogels to change their structure and volume phase in response to external stimuli have provided new possibilities for various advanced technologies and great research and application potentials in the medical field. The natural polymer-based hydrogels have the advantages of environment-friendliness, rich sources and good biocompatibility. Based on their responsiveness to external stimuli, the natural polymer-based hydrogels can be classified into the temperature-responsive hydrogel, pH-responsive hydrogel, light-responsive hydrogel, electricresponsive hydrogel, redox-responsive hydrogel, enzyme-responsive hydrogel, magnetic-responsive hydrogel, multi-responsive hydrogel, etc. In this review, we have compiled some recent studies on natural polymer-based stimuli-responsive hydrogels, especially the hydrogels prepared from polysaccharides. The preparation methods, properties and applications of these hydrogels in the medical field are highlighted.

A chitosan-based cascade-responsive drug delivery system for triple-negative breast cancer therapy

BACKGROUND

It is extremely difficult to develop targeted treatments for triple-negative breast (TNB) cancer, because these cells do not express any of the key biomarkers usually exploited for this goal.

RESULTS

In this work, we develop a solution in the form of a cascade responsive nanoplatform based on thermo-sensitive poly(N-vinylcaprolactam) (PNVCL)-chitosan (CS) nanoparticles (NPs). These are further modified with the cell penetrating peptide (CPP) and loaded with the chemotherapeutic drug doxorubicin (DOX). The base copolymer was optimized to undergo a phase change at the elevated temperatures of the tumor microenvironment. The acid-responsive properties of CS provide a second trigger for drug release, and the inclusion of CPP should ensure the formulations accumulate in cancerous tissue. The resultant CPP-CS-co-PNVCL NPs could self-assemble in aqueous media into spherical NPs of size < 200 nm and with low polydispersity. They are able to accommodate a high DOX loading (14.8% w/w). The NPs are found to be selectively taken up by cancerous cells both in vitro and in vivo, and result in less off-target cytotoxicity than treatment with DOX alone. In vivo experiments employing a TNB xenograft mouse model demonstrated a significant reduction in tumor volume and prolonging of life span, with no obvious systemic toxicity.

CONCLUSIONS

The system developed in this work has the potential to provide new therapies for hard-to-treat cancers.

Chitosan Derivatives: Introducing New Functionalities with a Controlled Molecular Architecture for Innovative Materials

The functionalization of polymeric substances is of great interest for the development of innovative materials for advanced applications. For many decades, the functionalization of chitosan has been a convenient way to improve its properties with the aim of preparing new materials with specialized characteristics. In the present review, we summarize the latest methods for the modification and derivatization of chitin and chitosan under experimental conditions, which allow a control over the macromolecular architecture. This is because an understanding of the interdependence between chemical structure and properties is an important condition for proposing innovative materials. New advances in methods and strategies of functionalization such as the click chemistry approach, grafting onto copolymerization, coupling with cyclodextrins, and reactions in ionic liquids are discussed.

Radiation grafting: A voyage from bio-waste corn husk to an efficient thermostable adsorbent

The initiator free environmentally benign gamma radiation is employed to graft poly-acrylic acid (PAA) onto the widely produced bio-waste corn husk to develop promising, cheap, efficient and reusable adsorbent (AAc-g-husk) having specific adsorption capacity of 1682.7mgg^-1 of methylene blue (MB) at pH 9.0 and 320K. The most suitable grafting yield is found by optimizing absorbed dose, dose rate and concentrations of monomer, Mohr's salt and inorganic acid. The inter-planar hydrogen bonding among (002) planes of cellulose in the husk decreases after diversifying grafting of PAA on ad-axial, ribs and micro-fibrils surfaces of the corn husks. The chemically and structurally modified AAc-g-husk shows superior thermal stability. The mechanism of MB dye adsorption by AAc-g-husk has been discussed through six two-parameters adsorption isotherm and ten three-parameters adsorption isotherm models at three different temperatures (300, 310 and 320K), seven kinetic models at room temperature, FT-IR and desorption studies in different solvent compositions.

Dual stimuli-responsive saccharide core based nanocarrier for efficient Birc5-shRNA delivery

Stimuli-responsive delivery systems show great promise in meeting the requirements of several delivery stages to achieve satisfactory gene transfection.

Recent advances in engineered chitosan-based nanogels for biomedical applications

Recent progress in the preparation and biomedical applications of engineered chitosan-based nanogels has been comprehensively reviewed.