Polyelectrolyte nanocomposite hydrogels filled with cationic and anionic clays

Study of the Efficiency of a Polycation Using the Diafiltration Technique in the Removal of the Antibiotic Oxytetracycline Used in Aquaculture

The presence of antibiotics in aquatic systems in recent years has become a global environmental and public health concern due to the appearance of strains resistant to these antibiotics. Oxytetracycline (OXT) is a high-impact antibiotic used for both human and veterinary consumption, and it is the second most used antibiotic in aquaculture in Chile. Based on the above, this problem is addressed using a linear polymer whose structure is composed of aromatic rings and quaternary ammonium groups, which will help enhance the removal capacity of this antibiotic. To obtain the polycation, a radical polymerization synthesis was carried out using (4-vinylbenzyl)-trimethylammonium chloride as the monomer. The polycation was characterized via Fourier Transform Infrared spectroscopy (FTIR) and Nuclear Magnetic Resonance (NMR). The removal studies were conducted under different experimental conditions such as pH levels (3.0, 5.0, 7.0, 8.0, and 11.0), ionic strength (0.0-0.50 mg L-1 of NaCl), polymer dose (0.25-25.5 mg), variation of the antibiotic concentration (1-100 mg L-1), and evaluation of the maximum retention capacity, as well as load and discharge studies. The antibiotic retention removal was higher than 80.0%. The antibiotic removal performance is greatly affected by the effect of pH, ionic strength, molar ratio, and/or OXT concentration, as these parameters directly affect the electrostatic interactions between the polymer and the antibiotics. The diafiltration technique was shown to be highly efficient for the removal of OXT, with maximum removal capacities of 1273, 966, and 778 mg OXT g-1 polycation. In conclusion, it can be said that coupling water-soluble polymers to the diafiltration technique is an excellent low-cost way to address the problem of antibiotics in aquatic systems.

Polydopamine/montmorillonite-embedded pullulan hydrogels as efficient adsorbents for removing crystal violet

Both secondary pollution and the low mechanical strength of adsorbents have severely impeded the practical application of adsorption methods in the dye wastewater treatment. In this work, we innovatively synthesized a composite hydrogel adsorbent by incorporating polydopamine (PDA) and montmorillonite (MMT) into the pullulan hydrogel matrix for dye adsorption. First, the successful formation of the resultant adsorbents was verified by Fourier-transform infrared spectroscopy and scanning electron microscope elemental mapping analysis. Then, several physicochemical properties (such as thermal and swelling properties, microarchitecture, and mechanical strength) of the five prepared adsorbents (PM1-PM5) were investigated. These results demonstrated the adsorbents had tunable properties, which can be achieved by adjusting the PDA/MMT mass ratio. Next, the dye adsorption performance was systematically explored. The resultant adsorbent (PM3) had a maximum adsorption capacity of 112.45 mg/g and its adsorption data was best described by a Langmuir isotherm and pseudo-second-order kinetic. Finally, the adsorption mechanisms and potential commercial practicability of the adsorbent were studied. Altogether, the designed adsorbent could effectively avoid generating the secondary pollution typical of adsorbents and it displayed excellent mechanical strength, thus opening up a new horizon in mitigating environmental pollution from textile industries.

N-Alkylated chitosan coupled to the liquid-phase polymer-based retention (LPR) technique to remove arsenic (V) from aqueous systems

Water-soluble polymer based on alkylated chitosan with a quaternary ammonium group (Ch-QAG) was prepared, characterized, and applied to remove arsenate ions from aqueous solution by LPR technique. The arsenic removal was performed by the washing method (WM) and enrichment method (EM). Through the WM, studies of the pH and variation in the concentrations of interferents and arsenate ions were carried out. The effect of the removal of arsenate ions in simulated water was determined from the Camarones River in northern Chile. Ch-QAG showed high affinity for binding arsenate species (99% of removal) at pH 11.0 at a molar ratio of 20:1 polymer: As(V). High selectivity was also observed in the presence of interfering ions such as Cl^-, SO₄^2-, and PO₄^3-, resulting in a removal rate over 80% at percentages over 95% for a concentration of 100 mg L^-1 of As (V). The maximum retention capacity obtained was 112, 105, and 98 mg g^-1 for three load cycles. The retention percentage for simulated water was 46.3% at a concentration of 1300 μ g L^-1. In conclusion, the results presented in this study show that using Ch-QAG with ultrafiltration membranes is a great alternative to remove As (V) at high removal rates.