Magnetically recyclable solid acid catalyst Fe3O4@ETMS-TETA-SO3H for efficient alcoholysis of dioscin from Dioscorea Zingiberensis C.H.Wrigh

A comparative study of the removal of o-xylene from gas streams using mesoporous silicas and their silica supported sulfuric acids

The three types of silica supported sulfuric acids (SSA), with the same sulfuric acid loading of 9.25 mmol g^-1, were prepared by a wet impregnation method from silica gel (SG), SBA-15 and MCM-41. Characterization of the prepared SSA showed that two anchoring states coexisted for sulfuric acid supported on the surface of the silicas: A physiosorbed (P)-state sulfuric acid; and a chemically bonded (C)-state sulfuric acid. Dynamic adsorption results showed that each SSA had a significant removal capacity for o-xylene gas in the reactive temperature regions. The ranges of the reactive regions were 120-220 °C (SSA/SG), 120-230 °C (SSA/SBA-15) and 120-250 °C (SSA/MCM-41), and this could be attributed to the sulfonation reaction between o-xylene and the anchored sulfuric acid. SSA/MCM-41 showed the highest theoretical breakthrough adsorption capacity (Q_{B, th}, 526.71 mg g^-1) compared with SSA/SBA-15 (363.54 mg g^-1) and SSA/SG (239.15 mg g^-1). Q_{B, th} was closely associated with the amount or proportion of the C-state sulfuric acid on the surface of each SSA. Optimum breakthrough time and Q_{B, th} was obtained by increasing the bed height and decreasing flow rate and inlet concentration. The SSA exhibited excellent recyclability and reuse performance over eight consecutive adsorption/desorption/regeneration cycles. The results suggested that the SSA, especially SSA/MCM-41, might have good potential in applications using adsorbents for the removal of BTEX pollutants.

Green Conversion of Saponins to Diosgenin in an Alcoholysis System Catalyzed by Solid Acid Derived from Phosphorus Tailings

This work proposed to prepare solid acid from phosphorus tailings and successfully convert Dioscorea zingiberensis C.H. Wright (DZW) into diosgenin from the perspective of solid waste resource reuse and clean production. The results showed that SiO₂-SO₃H solid acid could catalyze the production of diosgenin from total saponins under solvothermal reaction conditions. In addition, the parameters of a single factor, such as the amount of SiO₂-SO₃H, solvent volume, reaction temperature, and reaction time, were optimized to confirm the optimal range of reaction conditions, and the optimal process conditions were determined by the response surface method. The yield of diosgenin was 2.45 ± 0.17% under the optimum conditions, and the yield of diosgenin was increased by 12.90% compared with the traditional acid hydrolysis process. Except the relatively higher catalytic activity, the alcoholysis approach for the production of diosgenin has no waste liquid to discharge. The products were analyzed by high-performance liquid chromatography-mass spectrometry, and the pathway to convert total saponins into diosgenin under SiO₂-SO₃H has been proposed. Moreover, the adopted catalyst can be prepared with very low cost from phosphorus tailings. Considering the obvious superiorities, the alcoholysis approach in this work could be a promising strategy for green production of diosgenin as well as a possible utilization pathway of phosphorus tailings.