Membrane reactor design guidelines for ammonia decomposition

On the Maximum Obtainable Purity and Resultant Maximum Useful Membrane Selectivity of a Membrane Separator

Design considerations concerning the maximum purity of a membrane separator, and the resultant maximum effective selectivity of the membranes were explored by modeling a binary gas membrane separator (pressure-driven permeance) using a dimensionless form. Although the maximum purity has an analytical solution at the limit of zero recovery or stage cut, this solution over-predicts the obtained purity as the recovery is increased. Furthermore, at combinations of high recovery, low feed mole fraction, and low pressure ratio, the maximum purity becomes independent of selectivity above some critical selectivity. As a consequence of this purity limitation, a maximum selectivity is defined at which further increases in selectivity will result in less than a 1% change in the final purity. An equation is obtained that specifies the region in which a limiting purity is less than unity (indicating the existence of a limiting selectivity); operating at less than the limiting pressure ratio results in a purity limitation less than unity. This regime becomes larger and more significant as the inlet mole fraction decreases (e.g., inlet feed mole fraction of 10% and pressure ratio of 100 results in a maximum useful membrane selectivity of only 130 at 95% recovery). These results suggest that membrane research should focus on increasing permeance rather than selectivity for low-concentration separations. The results found herein can be used to set benchmarks for membrane development in various gas separation applications.

Study of Static and Dynamic Behavior of a Membrane Reactor for Hydrogen Production

The paper investigates the stability and bifurcation phenomena that can occur in membrane reactors for the production of hydrogen by ammonia decomposition. A simplified mixed model of the membrane reactor is studied and two expressions of hydrogen permeation are investigated. The effect of the model design and operating parameters on the existence of steady state multiplicity is discussed. In this regard, it is shown that the adsorption-inhibition effect caused by the competitive adsorption of ammonia can lead to the occurrence of multiple steady states in the model. The steady state multiplicity exists for a wide range of feed ammonia concentration and reactor residence time. The effect of the adsorption constant, the membrane surface area and its permeability on the steady state multiplicity is delineated. The analysis also shows that no Hopf bifurcation can occur in the studied model.