Photoelectrical response of mesoporous nickel oxide decorated with size controlled platinum nanoparticles under argon and oxygen gas

Promoting the electrocatalytic properties of nickel aerogel by gold decoration for efficient electrocatalytic oxygen evolution in alkali

Decorating Au onto Ni aerogel via a one-step spontaneous gelation preserved the highly porous structure of Ni aerogel, and contributed to more active sites and enhanced intrinsic activity for water oxidation with low overpotential of 377 mV for the current density of 100 mA cm^-2.

Atomically Dispersed Au on In2O3 Nanosheets for Highly Sensitive and Selective Detection of Formaldehyde

As an important industrial chemical, formaldehyde is used in various fields but is harmful to health. Developing a convenient detection device for formaldehyde is significant. Based on atomically dispersed Au on In₂O₃ nanosheets, a formaldehyde sensor was fabricated in this work. The highly dispersed Au obtained by the ultraviolet (UV) light-assisted reduction method helps improve the sensing performance. A meager loading amount (0.01 wt %) of Au on In₂O₃ nanosheets exhibits high sensitivity toward ppb-level formaldehyde. Au acts as an electron sink and promotes the oxidation of formaldehyde. Atomically dispersed Au on In₂O₃ nanosheets decreases the activation energy and increases the number of active sites, which result in a highly efficient conversion of formaldehyde and a marked resistance change of the fabricated sensors. The selective adsorption and oxidation of formaldehyde on single atom Au's uniform sites establish excellent selectivity. Besides, the sensor exhibits short response/recovery time and excellent stability, with promising applications in formaldehyde detection.

One-pot mechanochemical ball milling synthesis of the MnOx nanostructures as efficient catalysts for CO2 hydrogenation reactions

Here, we report on a one-pot mechanochemical ball milling synthesis of manganese oxide nanostructures synthesized at different milling speeds. The as-synthesized pure oxides and metal (Pt and Cu) doped oxides were tested in the hydrogenation of CO2 in the gas phase. Our study demonstrates the successful synthesis of the manganese oxide nanoparticles via mechano-chemical synthesis. We discovered that the milling speed could tune the crystal structure and the oxidation state of the manganese, which plays an essential role in the CO2 hydrogenation evidenced by ex situ XRD and XPS studies. The pure MnOx milled at 600 rpm showed high catalytic activity (∼20 000 nmol g-1 s-1) at 823 K, which can be attributed to the presence of Mn(ii) besides Mn(iii) and Mn(iv) on the surface under the reaction conditions. This study illustrates that the milling method is a cost-effective, simple way for the production of both pure, Pt-doped and Cu-loaded manganese nanocatalysts for heterogeneous catalytic reactions. Thus, we studied the Pt incorporation effect for the catalytic activity of MnOx using different Pt loading methods such as one-pot milling, wet impregnation and size-controlled 5 nm Pt loading via an ultrasonication-assisted method.

Characterization of Nanoparticles: Advances

Over the past two decades, the unique properties of engineered nanoparticles (NPs) have placed them at the centre of revolutionary advancements in many sectors of science, technology and commerce. Multi-technique and multi-disciplinary analytical approaches are required to identify, quantify, and characterize the chemical composition, size and size distribution, surface properties and the number and concentration of NPs. In this chapter, an overview of the recent advances in the characterization of NPs will be presented.

Determination of the platinum concentration of a Pt/silica nanocomposite decorated with ultra small Pt nanoparticles using single particle inductively coupled plasma mass spectrometry

The accurate load concentration of ultra small nanoparticles in a Pt/SiO₂ nanocomposite is determined by the novel spICP-MS analytical method.