Facile synthesis of deep eutectic solvent assisted BiOCl/BiVO 4 @AgNWs plasmonic photocatalysts under visible light enhanced catalytic performance

Morphological and elemental tuning of BiOCl/BiVO4 heterostructure for uric acid electrochemical sensor and antibiotic photocatalytic degradation

Deep eutectic solvents (DES) consisting of EG-(ChCl: C₂H₆O₂) and TU-(ChCl: CH₄N₂S) assisted synthesized BiOCl/BiVO₄ heterostructured catalyst studied for electrochemical uric acid (UA) sensor and tetracycline photocatalytic degradation. The chemical composition of the BiOCl/BiVO₄ catalyst was analyzed by X-ray photoelectron spectroscopy (XPS). UV-vis spectroscopy reveals increased absorption of visible light till the near-infrared region, which results in a narrowing of band gap energy from 2.3 eV to 2.2 eV for BiOCl/BiVO₄-TU. Morphology of catalyst analyzed using field-emission scanning electron microscope (FE-SEM) and Transmission electron microscope (TEM) technique. Time-Resolved photoluminescence (TRPL) confirms an increased lifetime of e^-/h⁺ pair after heterostructure formation. The catalyst-modified glassy carbon electrode shows selectivity toward the detection of uric acid (UA). The limit of detection (LOD) is estimated to be 0.04688 μM for UA; also, interference and stability of catalyst were studied. Photocatalytic activity of the synthesized catalyst was investigated by degrading tetracycline (TC) antibiotic pollutants, and their intermediate product was analyzed by ion trap mass spectrometry (MS).

Fabricating BiOCl/BiVO4 nanosheets wrapped in a graphene oxide heterojunction composite for detection of an antihistamine in biological samples

Antibiotics are essential medications for human and animal health, as they are used to battle urinary infections and bacterial diseases. Therefore, the rapid determination of antibiotic drugs in biological samples is necessary to address the current clinical challenge. Here, we developed a heterojunction ternary composite of BiOCl/BiVO₄ nanosheets enriched with graphene oxide (BiOCl/BiVO₄@GO) for accurate and minimal-level detection of an antihistamine (promethazine hydrochloride, PMZ) in urine samples. The BiOCl/BiVO₄ nanosheets were prepared by a wet chemical approach using a deep eutectic green solvent. The spectroscopic and analytical methods verified the formation and interaction of the BiOCl/BiVO₄@GO composite. Our results showed that the thoroughly exfoliated BiOCl/BiVO₄@GO composite retained good electrical conductivity and fast charge transfer toward the electrode-electrolyte interface in neutral aqueous media. In addition, the experimental conditions were accurately optimized, and the BiOCl/BiVO₄@GO composite showed excellent electrocatalytic activity toward the oxidation of PMZ. Indeed, the BiOCl/BiVO₄@GO composite demonstrated a good linear response range (0.01-124.7 μM) and a detection level of 3.3 nM with a sensitivity of 1.586 μA μM^-1 cm^-2. In addition, the BiOCl/BiVO₄@GO composite had excellent storage stability, good reproducibility, and reliable selectivity. Finally, the BiOCl/BiVO₄@GO displayed a desirable recovery level of PMZ in urine samples for real-time monitoring.

Deep Eutectic Solvents in Solar Energy Technologies

Deep Eutectic Solvents (DESs) have been widely used in many fields to exploit their ecofriendly characteristics, from green synthetic procedures to environmentally benign industrial methods. In contrast, their application in emerging solar technologies, where the abundant and clean solar energy is used to properly respond to most important societal needs, is still relatively scarce. This represents a strong limitation since many solar devices make use of polluting or toxic components, thus seriously hampering their eco-friendly nature. Herein, we review the literature, mainly published in the last few years, on the use of DESs in representative solar technologies, from solar plants to last generation photovoltaics, featuring not only their passive role as green solvents, but also their active behavior arising from their peculiar chemical nature. This collection highlights the increasing and valuable role played by DESs in solar technologies, in the fulfillment of green chemistry requirements and for performance enhancement, in particular in terms of long-term temporal stability.

Ionic Liquids and Deep Eutectics as a Transformative Platform for the Synthesis of Nanomaterials

Ionic liquids (ILs) are becoming a revolutionary synthesis medium for inorganic nanomaterials, permitting more efficient, safer and environmentally benign preparation of high quality products. A smart combination of ILs and...

Deep Eutectic Solvent-Assisted Synthesis of Ternary Heterojunctions for the Oxygen Evolution Reaction and Photocatalysis

Hierarchical nano-/microstructured photocatalysts have drawn attention for enhanced photocatalytic performance. Deep eutectic solvents (DESs) have been used as a green sustainable media to act as both solvent and structure-inducing agent in the synthesis of hierarchical nanomaterials. In this work, the DESs-assisted synthesis of flower-structured BiOCl/BiVO₄ (BOC/BVO) with g-C₃ N₄ (BOC/BVO/g-CN) ternary heterojunctions was achieved by using a simple wet-chemical method, providing good acidic and alkaline oxygen evolution reaction (OER) catalysts. BOC/BVO/g-CN-15 achieved an enhanced photocatalytic activity for OER with an overpotential of 570 mV in 1 m H₂ SO₄ and 220 mV in 1 m KOH electrolyte at a current density of 10 mA cm^-2 with excellent stability and extraordinary durability of the catalyst. The ternary heterojunctions displayed extended lifetimes for photogenerated charges and enhanced the separation efficiency of photogenerated electron-hole pairs, which is helpful to enhance the photocatalytic OER. Furthermore, the photocatalytic performance of the ternary heterojunctions in aqueous solution was demonstrated through photocatalytic dye degradation of methyl orange (MO) as a model pollutant, resulting in 95 % degradation of 20 ppm of MO in 210 min under the irradiation of a 35 W Xe arc lamp. This work not only provides new insight into the design of catalysts by using green solvents but also into the design of highly efficient metal-free OER photocatalysts for applications in acidic and alkaline media.

Ag2O-decorated electrospun BiVO4 nanofibers with enhanced photocatalytic performance

Semiconductor photocatalysts are emerging as tools for pollutant degradation in industrial wastewater, air purification, antibacterial applications, etc. due to their use of visible light, which is abundant in sunlight. Here, we report a new type of p–n junction Ag₂O/BiVO₄ heterogeneous nanostructured photocatalyst with enhanced photocatalytic performance. P-type Ag₂O nanoparticles were in situ reduced and assembled on the surface of electrospun BiVO₄ nanofibers using ultraviolet (UV) irradiation; this process hindered the recombination of localized photogenerated electron–hole pairs, and hence resulted in the enhanced photocatalytic activity of the BiVO₄/Ag₂O nanocomposites. The photocatalytic activities of the obtained BiVO₄ and BiVO₄/Ag₂O nanocomposites were assessed by measuring the degradation of rhodamine B (RhB) under visible light. The 10 wt% Ag₂O/BiVO₄ sample yielded the optimum degradation of RhB (98.47%), much higher than that yielded by pure BiVO₄ nanofibers (64.67%). No obvious change in the XRD pattern of an Ag₂O/BiVO₄ sample occurred as a result of its use in the photocatalytic reaction, indicating its excellent stability. The high photocatalytic performance observed was attributed to the large surface-to-volume ratio of the essentially one-dimensional electrospun BiVO₄ nanofibers and to the in situ growth of p-type Ag₂O on the surface of the n-type BiVO₄ nanofibers.

Ag₂O doped electrospun BiVO₄ nanofibers with p–n junction heterogeneous structures show enhanced photocatalytic activity under visible light (photocatalytic efficiency: 98.47% within 100 min) and good cycling stability.

Visible Light Photodegradation of Formaldehyde over TiO2 Nanotubes Synthesized via Electrochemical Anodization of Titanium Foil

In this study, a series of TiO₂ nanotubes (NTs) were synthesized employing electrochemical anodization of titanium foil in an ionic liquid solution containing a mixture of glycerol and choline chloride, acting as electrolyte. The as-synthesized TiO₂ NTs were calcined at 350, 450, or 550 °C for a 2 h duration to investigate the influence of calcination temperature on NTs formation, morphology, surface properties, crystallinity, and subsequent photocatalytic activity for visible light photodegradation of gaseous formaldehyde (HCHO). Results showed that the calcination temperature has a significant effect on the structure and coverage of TiO₂ NTs on the surface. Freshly synthesized TiO₂ NTs showed better-ordered structure compared to calcined samples. There was significant pore rupture with increasing calcination temperature. The transformation from anatase to rutile phase appeared after calcination at 450 °C and the weight fraction of the rutile phase increased from 19% to 36% upon increasing the calcination temperature to 550 °C. The band gaps of the TiO₂ NTs were in the range from 2.80 to 2.74 eV, shifting the active region of the materials to visible light. The presence of mixed anatase–rutile TiO₂ phases in the sample calcined at 450 °C showed enhanced photoactivity, which was confirmed by the 21.56 mg∙L⁻¹∙g⁻¹ removal of gaseous formaldehyde under 120 min of visible light irradiation and displayed enhanced quantum yield, ∅_HCHO of 17%.

One-Pot Synthesized Visible Light-Driven BiOCl/AgCl/BiVO4 n-p Heterojunction for Photocatalytic Degradation of Pharmaceutical Pollutants

A novel enhanced visible light absorption BiOCl/AgCl/BiVO₄ heterojunction of photocatalysts could be obtained through a one-pot hydrothermal method used with two different pH solutions. There was a relationship between synthesis pH and the ratio of BiOCl to BiVO₄ in XRD planes and their photocatalytic activity. The visible light photocatalytic performances of photocatalysts were evaluated via degradation of diclofenac (DCFF) as a pharmaceutical model pollutant. Furthermore, kinetic studies showed that DCF degradation followed pseudo-first-order kinetics. The photocatalytic degradation rates of BiOCl/AgCl/BiVO₄ synthesized at pH = 1.2 and pH = 4 for DCF were 72% and 47%, respectively, showing the higher activity of the photocatalyst which was synthesized at a lower pH value. It was concluded that the excellent photocatalytic activity of BiOCl/AgCl/BiVO₄ is due to the enhanced visible light absorption formation of a heterostructure, which increased the lifetime of photo-produced electron–hole pairs by creating a heterojunction. The influence of pH during synthesis on photocatalytic activity in order to create different phases was investigated. This work suggests that the BiOCl/AgCl/BiVO₄ p-n heterojunction is more active when the ratio of BiOCl to BiVO₄ is smaller, and this could be achieved simply by the pH adjustment. This is a promising method of modifying the photocatalyst for the purpose of pollutant degradation under visible light illumination.

Facile synthesis of hierarchically nanostructured bismuth vanadate: An efficient photocatalyst for degradation and detection of hexavalent chromium

Heterostructured nanomaterials can paid more significant attention in environmental safety for the detection and degradation/removal of hazardous toxic chemicals over a decay. Here, we report the preparation of hierarchically nanostructured shuriken like bismuth vanadate (BiVO₄) as a bifunctional catalyst for photocatalytic degradation and electrochemical detection of highly toxic hexavalent chromium (Cr(VI)) using the green deep eutectic solvent reline, which allows morphology control in one of the less energy-intensive routes. The SEM results showed a good dispersion of BiVO₄ catalyst and the HR-TEM revealed an average particle size of ca. 5-10 nm. As a result, the BiVO₄ exhibited good photocatalytic activity under UV-light about 95% reduction of Cr(VI) to Cr(III) was observed in 160 min. The recyclability of BiVO₄ catalyst exhibited an appreciable reusability and stability of the catalyst towards the photocatalytic reduction of Cr(VI). Also, the BiVO₄-modified screen printed carbon electrode (BiVO₄/SPCE) displayed an excellent electrochemical performance towards the electrochemical detection of Cr(VI). Besides, the BiVO₄/SPCE demonstrated tremendous electrocatalytic activity, lower linear range (0.01-264.5 μM), detection limit (0.0035 μM) and good storage stability towards the detection of Cr(VI). Importantly, the BiVO₄ modified electrode was also found to be a good recovery in water samples for practical applications.

Influence of cobalt substitution on the crystal structure, band edges and photocatalytic properties of hierarchical Bi2WO6 microspheres

An efficient Bi₂WO₆ catalyst with Co²⁺ substitution was synthesized via a facile hydrothermal route.