Phosphorus containing carbon (submicron)fibers as efficient acid catalysts

Adsorption of 2,4-dichlorophenoxyacetic acid on activated carbons from macadamia nut shells

This study reports on the application of activated carbons from macadamia nut shells as adsorbents for the removal of 2,4-dichlorophenoxyacetic acid, a commonly used pesticide, from water. Different activating agents (FeCl3, ZnCl2, KOH and H3PO4) were used to obtain adsorbents within a wide range of porous texture and surface properties. The characterization of the resulting activated carbons was performed by N2 adsorption-desorption, elemental analysis, TG and pHPZC. The adsorption experiments were conducted in batch at 25, 45 and 65 °C. The adsorption kinetics on activated carbons obtained with FeCl3 H3PO4 or KOH was well described by the pseudo-second order model, whereas for the resulting from ZnCl2 activation the experimental data fit better the pseudo-first order model. The equilibrium studies were performed with the KOH- and ZnCl2-activated carbons, the two showing higher surface area values. In both cases, high adsorption capacities were obtained (c.a. 600 mg g-1) and the experimental data were better described by the Langmuir and Toth models. The thermodynamic study allows concluding the spontaneous and endothermic character of the adsorption process, as well as an increase of randomness at the solid/liquid interface. Breakthrough curves were also obtained and fitted to the logistic model.

A Kinetic Model Considering Catalyst Deactivation for Methanol-to-Dimethyl Ether on a Biomass-Derived Zr/P-Carbon Catalyst

A Zr-loaded P-containing biomass-derived activated carbon (ACPZr) has been tested for methanol dehydration between 450 and 550 °C. At earlier stages, methanol conversion was complete, and the reaction product was mainly dimethyl ether (DME), although coke, methane, hydrogen and CO were also observed to a lesser extent. The catalyst was slowly deactivated with time-on-stream (TOS), but maintained a high selectivity to DME (>80%), with a higher yield to this product than 20% for more than 24 h at 500 °C. A kinetic model was developed for methanol dehydration reaction, which included the effect of the inhibition of water and the deactivation of the catalyst by coke. The study of stoichiometric rates pointed out that coke could be produced through a formaldehyde intermediate, which might, alternatively, decompose into CO and H₂. On the other hand, the presence of 10% water in the feed did not affect the rate of coke formation, but produced a reduction of 50% in the DME yield, suggesting a reversible competitive adsorption of water. A Langmuir–Hinshelwood reaction mechanism was used to develop a kinetic model that considered the deactivation of the catalyst. Activation energy values of 65 and 51 kJ/mol were obtained for DME and methane production in the temperature range from 450 °C to 550 °C. On the other hand, coke formation as a function of time on stream (TOS) was also modelled and used as the input for the deactivation function of the model, which allowed for the successful prediction of the DME, CH₄ and CO yields in the whole evaluated TOS interval.

Pulmonary toxicity, cytotoxicity, and genotoxicity of submicron-diameter carbon fibers with different diameters and lengths

Submicron-diameter carbon fibers (SCFs) are a type of fine-diameter fibrous carbon material that can be used in various applications. To accelerate their practical application, a hazard assessment of SCFs must be undertaken. This study demonstrated the pulmonary toxicity, cytotoxicity, and genotoxicity of three types of SCFs with different diameters and lengths. The average diameter and length of SCFs were 259.2 nm and 11.7 μm in SCF1 suspensions, 248.5 nm and 6.7 μm in SCF2 suspensions, and 183.0 nm and 13.7 μm in SCF3 suspensions, respectively. The results of pulmonary inflammation and recovery following intratracheal instillation with SCFs at doses of 0.25, 0.5, or 1.0 mg/kg showed that the pulmonary toxicity of SCFs was SCF3 > SCF1 > SCF2. These results suggest that SCF diameter and length are most likely important contributing factors associated with lung SCF clearance, pulmonary inflammation, and recovery. Furthermore, SCFs are less pulmonary toxic than bent multi-walled carbon nanotubes. Cell viability, pro-inflammatory cytokine and intracellular reactive oxygen species productions, morphological changes, gene expression profiling in NR8383 rat alveolar macrophage cells showed that the cytotoxic potency of SCFs is: SCF3 > SCF1 > SCF2. These results showed that SCFs with small diameters had high cytotoxicity, and SCFs with short lengths had low cytotoxicity. We conclude that pulmonary toxicity and cytotoxicity are associated with the diameter and length distributions of SCFs. In addition, a standard battery for genotoxicity testing, namely the Ames test, an in vitro chromosomal aberration test, and a mammalian erythrocyte micronucleus test, demonstrated that the three types of SCFs did not induce genotoxicity. Our findings provide new evidence for evaluating the potential toxicity of not only SCFs used in this study but also various SCFs which differ depending on the manufacturing processes or physicochemical properties.