Facile-fabricated iron oxide nanorods as a catalyst for hydrogenation of nitrobenzene

Support Morphology Effect on Selective Hydrogenation of 3-Nitrostyrene to 3-Vinylaniline over Pt/α-Fe2 O3 Catalysts

Selective hydrogenation of substituted nitroaromatic compounds is an extremely important and challenging reaction. Supported metal catalysts attract much attention in this reaction because the properties of metal nanoparticles (NPs) can be modified by the nature of the support. Herein, the support morphology on the catalytic performance of selective hydrogenation of 3-nitrostyrene to 3-vinylaniline was investigated. Pt NPs supported on octadecahedral α-Fe₂ O₃ supports with a truncated hexagonal bipyramid shape (Pt/α-Fe₂ O₃ -O) and rod-shaped α-Fe₂ O₃ supports (Pt/α-Fe₂ O₃ -R) were prepared by glycol reduction method. Detailed characterizations reveal that the electronic structure and dispersion of Pt NPs can be modified by the supports. The Pt/α-Fe₂ O₃ -O catalyst exhibited superior catalytic performance for hydrogenation of 3-nitrostyrene because of its low coordinated Pt sites and the small Pt NPs size, which is benefit from the high-index exposed surfaces of truncated hexagonal bipyramid-shaped α-Fe₂ O₃ support. The structural evolution during the catalytic reaction was investigated in detail by identical location transmission electron microscopy (IL-TEM) method, which found that the high cycling activity of Pt/α-Fe₂ O₃ -O catalyst during the cycle experiment results from the stability of Pt NPs.

The growth behavior of brain-like SnO2 microspheres under a solvothermal reaction with tetrahydrofuran as a solvent and their gas sensitivity

In this paper, the growth behavior of brain-like SnO2 microspheres synthesized by a tetrahydrofuran (THF) solvothermal method was studied. Unlike water or ethanol as the solvent, THF is a medium polar and aprotic solvent. Compared with other common polar solvents, the THF has no strong irregular effects on the growth process of SnO2. In addition, the viscosity of THF also helps the SnO2 to form a regular microstructure. The growth behavior of the brain-like SnO2 microspheres is controlled by changing the synthesis temperature of the reaction. The SEM and TEM results reveal that the SnO2 forms particles first (125 °C/3 h), and then these nanoparticles connect to each other forming nanowires and microspheres (diameter ≈ 1-2 μm) at 135 °C for 3 h; finally the microspheres further aggregate to form double or multi-sphere structures at 180 °C for 3 h. In this paper, the brain-like SnO2 microspheres obtained at 125 °C for 3 h were selected as sensitive materials to test their gas sensing performance at different operating temperature (50 °C and 350 °C). The H2S was tested at 50 °C which is the lowest operating temperature for the sensor. The combustible gas (H2/CH4/CO) was measured at 350 °C which is the highest temperature for the sensor. They all have extremely high sensitivity, but only H2S has excellent selectivity.

Biomedical Applications of Chinese Herb-Synthesized Silver Nanoparticles by Phytonanotechnology

Recent advances in nanotechnology have opened up new avenues for the controlled synthesis of nanoparticles for biomedical and pharmaceutical applications. Chinese herbal medicine is a natural gift to humanity, and it has long been used as an antibacterial and anticancer agent. This study will highlight recent developments in the phytonanotechnological synthesis of Chinese herbal medicines to utilize their bioactive components in biomedical and therapeutic applications. Biologically synthesized silver nanoparticles (AgNPs) have emerged as a promising alternative to chemical and physical approaches for various biomedical applications. The comprehensive rationale of combinational or synergistic effects of Chinese herb-based AgNPs synthesis was investigated with superior physicochemical and biological properties, and their biomedical applications, including antimicrobial and anticancer activity and wound healing properties. AgNPs can damage the cell ultrastructure by triggering apoptosis, which includes the formation of reactive oxygen species (ROS), DNA disintegration, protein inactivation, and the regulation of various signaling pathways. However, the anticancer mechanism of Chinese herbal medicine-based AgNPs is more complicated due to the potential toxicity of AgNPs. Further in-depth studies are required to address Chinese herbs' various bioactive components and AgNPs as a synergistic approach to combat antimicrobial resistance, therapeutic efficiency of drug delivery, and control and prevention of newly emerged diseases.

Development of Highly Efficient, Glassy Carbon Foam Supported, Palladium Catalysts for Hydrogenation of Nitrobenzene

Glassy carbon foam (GCF) catalyst supports were synthesized from waste polyurethane elastomers by impregnating them in sucrose solution followed by pyrolysis and activation (AC) using N₂ and CO₂ gas. The palladium nanoparticles were formed from Pd(NO₃)₂. The formed palladium nanoparticles are highly dispersive because the mean diameters are 8.0 ± 4.3 (Pd/GCF), 7.6 ± 4.2 (Pd/GCF-AC1) and 4.4 ± 1.6 nm (Pd/GCF-AC2). Oxidative post-treatment by CO₂ of the supports resulted in the formation of hydroxyl groups on the GCF surfaces, leading to a decrease in zeta potential. The decreased zeta potential increased the wettability of the GCF supports. This, and the interactions between -OH groups and Pd ions, decreased the particle size of palladium. The catalysts were tested in the hydrogenation of nitrobenzene. The non-treated, glassy-carbon-supported catalyst (Pd/GCF) resulted in a 99.2% aniline yield at 293 K and 50 bar hydrogen pressure, but the reaction was slightly slower than other catalysts. The catalysts on the post-treated (activated) supports showed higher catalytic activity and the rate of hydrogenation was higher. The maximum attained aniline selectivities were 99.0% (Pd/GCF-AC1) at 293 K and 98.0% (Pd/GCF-AC2) at 323 K.

Size Tuned Synthesis of FeOOH Nanorods toward Self-Assembled Nanoarchitectonics

Various studies were performed to fabricate self-assembling nanoobjects out of noble metals, but a few efforts were made for engineering iron-based nanorods toward sell-assembling blocks. In this regard β-FeOOH nanorods were fabricated in various sizes to achieve iron-based rod nanoblocks with self-assembling potential. Hydrolysis of ferric ions in various concentrations was successfully developed as a novel approach to control the growth of β-FeOOH crystals and tuning the length of rods in the nano range, below 100 nm. It was found that the concentration of ferric ion has no effect on the widths of nanorods, but the length was affected. By increasing the concentration of ferric ions, an increase in the length of nanorods and an increase of aspect ratio occurred. All sizes of the resulting FeOOH nanorods exhibited mesoporous feature, but interestingly the hysteresis loops were different due to different pore patterns. In fact, pores on the larger particles were more uniform in size and shape. Nanorods of small length did not make suitable interactions toward ordered phase formation, but rods with the mean length of about 90 nm or longer, at a certain concentration, were able to form nematic phases. The large (∼+40 mV) zeta-potential of nanorods prevents formation of dense arrays, and just bundle-like structures were observed. These findings highlight the importance of size, surface charge, and concentration of nanoobjects in the formation of 3D structures. The developed technique in the fabrication of β-FeOOH nanorods provides pure structures that are free from any size-controlling agent. These pure structures are suitable for further functionalization or coating. Self-assembling nanoobjects is a developing field in nanotechnology, and therefore studies can help our understanding over the assembling process.

Finely Controlled Platinum Nanoparticles over ZnO Nanorods for Selective Hydrogenation of 3-Nitrostyrene to 3-Vinylaniline

Metallic platinum nanocatalysts play a key role in the liquid-phase selective hydrogenation of substrates with more than one unsaturated bond. However, the commonly applied explanation for the effects of different electronic and geometric properties of catalysts on reactions remains of a heuristic nature due to the difficulties involved in preparing catalysts with precise structure. In this work, we have directly loaded pre-synthesized metallic platinum nanoparticles onto well-structured ZnO nanorods and then subjected them to thermal treatment in a reductive atmosphere for different temperatures. The effects of the different electronic and geometric properties of the catalysts on the selective reduction of 3-nitrostyrene to 3-vinylaniline as a model reaction have been rigorously explored through an analysis of the catalyst structures and the activity and selectivity profiles. Both the electron transfer from zinc to platinum and the decreased platinum surface density as a result of the formation of PtZn intermetallic compounds are key factors for improving the selectivity for the desired 3-vinylaniline. Azobenzene was detected in the reaction with all the Pt/ZnO catalysts after 10-90 min, which indicates that the reaction follows a condensation mechanism.