Bimetallic CoNiSe2/C nanosphere anodes derived from Ni-Co-metal-organic framework precursor towards higher lithium storage capacity

MOF-Derived Bimetallic Selenide CoNiSe2 Nanododecahedrons Encapsulated in Porous Carbon Matrix as Advanced Anodes for Lithium-Ion Batteries

Transition metal selenides have received considerable attention as promising candidates for lithium-ion battery (LIB) anode materials due to their high theoretical capacity and safety characteristics. However, their commercial viability is hampered by insufficient conductivity and volumetric fluctuations during cycling. To address these issues, we have utilized bimetallic metal-organic frameworks to fabricate CoNiSe2/C nanodecahedral composites with a high specific surface area, abundant pore structures, and a surface-coated layer of the carbon-based matrix. The optimized material, CoNiSe2/C-700, exhibited impressive Li+ storage performance with an initial discharge specific capacity of 2125.5 mA h g-1 at 0.1 A g-1 and a Coulombic efficiency of 98% over cycles. Even after 1000 cycles at 1.0 A g-1, a reversible discharge specific capacity of 549.9 mA h g-1 was achieved. The research highlights the synergistic effect of bimetallic selenides, well-defined nanodecahedral structures, stable carbon networks, and the formation of smaller particles during initial cycling, all of which contribute to improved electronic performance, reduced volume change, increased Li+ storage active sites, and shorter Li+ diffusion paths. In addition, the pseudocapacitance behavior contributes significantly to the high energy storage of Li+. These features facilitate rapid charge transfer and help maintain a stable solid-electrolyte interphase layer, which ultimately leads to an excellent electrochemical performance. This work provides a viable approach for fabricating bimetallic selenides as anode materials for high-performance LIBs through architectural engineering and compositional tailoring.

Significant Strain Dissipation via Stiff-Tough Solid Electrolyte Interphase Design for Highly Stable Alloying Anodes

The pulverization of alloying anodes significantly restricts their use in lithium-ion batteries (LIBs). This study presents a dual-phase solid electrolyte interphase (SEI) design that incorporates finely dispersed Al nanoparticles within the LiPON matrix. This distinctive dual-phase structure imparts high stiffness and toughness to the integrated SEI film. In comparison to single-phase LiPON film, the optimized Al/LiPON dual-phase SEI film demonstrates a remarkable increase in fracture toughness by 317.8 %, while maintaining stiffness, achieved through the substantial dissipation of strain energy. Application of the dual-phase SEI film on an Al anode leads to a 450 % enhancement in cycling stability for lithium storage in dual-ion batteries. A similar enhancement in cycling stability for silicon anodes, which face severe volume expansion issues, is also observed, demonstrating the broad applicability of the dual-phase SEI design. Specifically, homogeneous Li-Al alloying has been observed in conventional LIBs, even when paired with a high mass loading LiNi0.5 Co0.3 Mn0.2 O2 cathode (7 mg cm-2 ). The dual-phase SEI film design can also accelerate the diffusion kinetics of Li-ions through interface electronic structure regulation. This dual-phase design can integrate stiffness and toughness into a single SEI film, providing a pathway to enhance both the structural stability and rate capability of alloying anodes.

Bimetallic Cobalt-Nickel Selenide Nanocubes Embedded in a Nitrogen-Doped Carbon Matrix as an Excellent Li-Ion Battery Anode

Lithium-ion batteries (LIBs) have been widely used for portable electronics and electric vehicles; however, the low capacity in the graphite anode limits the improvement of energy density. Transition-metal selenides are promising anode material candidates due to their high theoretical capacity and controllable structure. In this study, we successfully synthesize a bimetallic transition-metal selenide nanocube composite, which is well embedded in a nitrogen-doped carbon matrix (denoted as CoNiSe₂/NC). This material shows a high capacity and excellent cycling for Li-ion storage. Specifically, the reversible capacity approaches ∼1245 mA h g^-1 at 0.1 A g^-1. When cycled at 1 A g^-1, the capacity still remains at 642.9 mA h g^-1 even after 1000 cycles. In-operando XRD tests have been carried out to investigate the lithium storage mechanism. We discover that the outstanding performance is due to the unique CoNiSe₂/NC nanocomposite characteristics, such as the synergistic effect of bimetallic selenide on lithium storage, the small particle size, and the stable and conductive carbon structure. Therefore, this morphology structure not only reduces the volume change of metal selenides but also produces more lithium storage active sites and shortens lithium diffusion paths, which results in high capacity, good rate, and long cycling.