Numerical Simulation of Wake Structure and Particle Entrainment Behavior during A Single Bubble Ascent in Liquid-Solid System

Mechanism of Cuttings Removing at the Bottom Hole by Pulsed Jet

Vibration drilling technology induced by hydraulic pulse can assist the bit in breaking rock at deep formation. Simultaneously, the pulsed jet generated by the hydraulic pulse promotes removal of the cuttings from the bottom hole. Nowadays, the cuttings removal mechanism of the pulsed jet is not clear, which causes cuttings to accumulate at the bottom hole and increases the risk of repeated cutting. In this paper, a pressure-flow rate fluctuation model is established to analyze the fluctuation characteristics of the pulsed jet at the bottom hole. Based on the model, the effects of displacement, well depth, drilling fluid viscosity, and flow area of the pulsed jet tool on the feature of instantaneous flow at the bottom hole are discussed. The results show that the pulsed jet causes flow rate and pressure to fluctuate at the bottom hole. When the displacement changes from 20 L/s to 40 L/s in a 2000 m well, the pulsed jet generates a flow rate fluctuation of 4–9 L/s and pressure fluctuation of 0.1–0.5 MPa at the bottom hole. With the flow area of the tool increasing from 2 cm2 to 4 cm2, the amplitude of flow rate fluctuation decreases by 72.5%, and the amplitude of pressure fluctuation decreases by more than 60%. Combined with the fluctuation feature of the flow field and the water jet attenuation law at the bottom hole, the force acting on the cuttings under the pulsed jet is derived. It is found that flow rate fluctuation improves the mechanical state of cuttings and is beneficial for cuttings tumbled off the bottom hole. This research provides theoretical guidance for pulsed jet cuttings cleaning at the bottom hole.

Entropy Generation Analysis of the Flow Boiling in Microgravity Field

Entropy generation analysis of the flow boiling in microgravity field is conducted in this paper. A new entropy generation model based on the flow pattern and the phase change process is developed in this study. The velocity ranges from 1 m/s to 4 m/s, and the heat flux ranges from 10,000 W/m² to 50,000 W/m², so as to investigate their influence on irreversibility during flow boiling in the tunnel. A phase–change model verified by the Stefan problem is employed in this paper to simulate the phase–change process in boiling. The numerical simulations are carried out on ANSYS-FLUENT. The entropy generation produced by the heat transfer, viscous dissipation, turbulent dissipation, and phase change are observed at different working conditions. Moreover, the Be number and a new evaluation number, E_P, are introduced in this paper to investigate the performance of the boiling phenomenon. The following conclusions are obtained: (1) a high local entropy generation will be obtained when only heat conduction in vapor occurs near the hot wall, whereas a low local entropy generation will be obtained when heat conduction in water or evaporation occurs near the hot wall; (2) the entropy generation and the Be number are positively correlated with the heat flux, which indicates that the heat transfer entropy generation becomes the major contributor of the total entropy generation with the increase of the heat flux; (3) the transition of the boiling status shows different trends at different velocities, which affects the irreversibility in the tunnel; (4) the critical heat flux (CHF) is the optimal choice under the comprehensive consideration of the first law and the second law of the thermodynamics.