Electrochemical determination of anaerobic microbial decay coefficients

Application of the International Water Association activated sludge models to describe aerobic sludge digestion

Batch and semi-continuous flow aerobic digesters were used to stabilize thickened waste-activated sludge at different initial conditions and mean solids retention times. Under dynamic conditions, total suspended solids, volatile suspended solids (VSS) and total and particulate chemical oxygen demand (COD and PCOD) were monitored in the batch reactors and effluent from the semi-continuous flow reactors. Activated Sludge Model (ASM) no. 1 and ASM no. 3 were applied to measured data (calibration data set) to evaluate the consistency and performances of models at different flow regimes for digester COD and VSS modelling. The results indicated that both ASM1 and ASM3 predicted digester COD, VSS and PCOD concentrations well (R2, Ra2 > or = 0.93). Parameter estimation concluded that compared to ASM1, ASM3 parameters were more consistent across different batch and semi-continuous flow runs with different operating conditions. Model validation on a data set independent from the calibration data successfully predicted digester COD (R2 = 0.88) and VSS (R2 = 0.94) concentrations by ASM3, while ASM1 overestimated both reactor COD (R2 = 0.74) and VSS concentrations (R2 = 0.79) after 15 days of aerobic batch digestion.

Electricity production by an overflow-type wetted-wall microbial fuel cell

An overflow-type wetted-wall MFC (WWMFC) was developed to generate a stable voltage from acetate-based substrates. The maximum power density of 18.21 W/m(3) was obtained. The power generation showed a saturation-type relationship as a function of initial COD, with a maximum power density (P(max)) of 18.82 W/m(3) and a saturation constant (K(s)) of 227.4 mg/l. Forced air flowing through the cathode chamber had a negligible effect on power generation. Influent flow rate could greatly affect the power generation. The maximum power density was increased by 72.8% when the influent flow rate increased from 5 to 30 ml/min. In addition, increasing ionic strength did not affect the power density and internal resistance. Oxygen could be restrained to diffuse into the anode chamber effectively in the overflow-type WWMFC. And the overflow-type WWMFC could be scaled up conveniently in practical application.

Simultaneous cellulose degradation and electricity production by Enterobacter cloacae in a microbial fuel cell

Electricity can be directly generated by bacteria in microbial fuel cells (MFCs) from many different biodegradable substrates. When cellulose is used as the substrate, electricity generation requires a microbial community with both cellulolytic and exoelectrogenic activities. Cellulose degradation with electricity production by a pure culture has not been previously demonstrated without addition of an exogenous mediator. Using a specially designed U-tube MFC, we enriched a consortium of exoelectrogenic bacteria capable of using cellulose as the sole electron donor. After 19 dilution-to-extinction serial transfers of the consortium, 16S rRNA gene-based community analysis using denaturing gradient gel electrophoresis and band sequencing revealed that the dominant bacterium was Enterobacter cloacae. An isolate designated E. cloacae FR from the enrichment was found to be 100% identical to E. cloacae ATCC 13047(T) based on a partial 16S rRNA sequence. In polarization tests using the U-tube MFC and cellulose as a substrate, strain FR produced 4.9 +/- 0.01 mW/m(2), compared to 5.4 +/- 0.3 mW/m(2) for strain ATCC 13047(T). These results demonstrate for the first time that it is possible to generate electricity from cellulose using a single bacterial strain without exogenous mediators.