Study on the volatility of halogenated fluorenes

Calculation of the Vapour Pressure of Organic Molecules by Means of a Group-Additivity Method and Their Resultant Gibbs Free Energy and Entropy of Vaporization at 298.15 K

The calculation of the vapour pressure of organic molecules at 298.15 K is presented using a commonly applicable computer algorithm based on the group-additivity method. The basic principle of this method rests on the complete breakdown of the molecules into their constituting atoms, further characterized by their immediate neighbour atoms. The group contributions are calculated by means of a fast Gauss-Seidel fitting algorithm using the experimental data of 2036 molecules from literature. A ten-fold cross-validation procedure has been carried out to test the applicability of this method, which confirmed excellent quality for the prediction of the vapour pressure, expressed in log(pa), with a cross-validated correlation coefficient Q² of 0.9938 and a standard deviation σ of 0.26. Based on these data, the molecules' standard Gibbs free energy ΔG°_vap has been calculated. Furthermore, using their enthalpies of vaporization, predicted by an analogous group-additivity approach published earlier, the standard entropy of vaporization ΔS°_vap has been determined and compared with experimental data of 1129 molecules, exhibiting excellent conformance with a correlation coefficient R² of 0.9598, a standard error σ of 8.14 J/mol/K and a medium absolute deviation of 4.68%.

Estimations of the thermodynamic properties of halogenated benzenes as they relate to their environment mobility

In this work, several simple new equations for predicting important environmental mobility properties, at T = 298.15 K, were derived for halogenated benzenes: standard Gibbs energy of hydration, aqueous solubility, octanol-water partition coefficients, and Henry's law constants. A discussion on our previous estimates of other related properties (standard Gibbs energy and vapor pressure of sublimation and of vaporization) and their relation with entropy of fusion is also presented. As we aimed to estimate these properties for any of the ca. 1500 halogenated benzenes that may exist theoretically, an equation for estimating the temperature of fusion was also derived, since some of the proposed predictive equations (solubility of solids and Gibbs energy of sublimation) require its knowledge. For the other estimated properties just the number of each halogen that replaces hydrogen atoms in the halogenated benzene is needed. It was found that the coefficients that multiply the number of halogen atoms in the predictive equations vary linearly with the volume of the halogen atom.

Calculation of Five Thermodynamic Molecular Descriptors by Means of a General Computer Algorithm Based on the Group-Additivity Method: Standard Enthalpies of Vaporization, Sublimation and Solvation, and Entropy of Fusion of Ordinary Organic Molecules and Total Phase-Change Entropy of Liquid Crystals

The calculation of the standard enthalpies of vaporization, sublimation and solvation of organic molecules is presented using a common computer algorithm on the basis of a group-additivity method. The same algorithm is also shown to enable the calculation of their entropy of fusion as well as the total phase-change entropy of liquid crystals. The present method is based on the complete breakdown of the molecules into their constituting atoms and their immediate neighbourhood; the respective calculations of the contribution of the atomic groups by means of the Gauss-Seidel fitting method is based on experimental data collected from literature. The feasibility of the calculations for each of the mentioned descriptors was verified by means of a 10-fold cross-validation procedure proving the good to high quality of the predicted values for the three mentioned enthalpies and for the entropy of fusion, whereas the predictive quality for the total phase-change entropy of liquid crystals was poor. The goodness of fit (Q²) and the standard deviation (σ) of the cross-validation calculations for the five descriptors was as follows: 0.9641 and 4.56 kJ/mol (N = 3386 test molecules) for the enthalpy of vaporization, 0.8657 and 11.39 kJ/mol (N = 1791) for the enthalpy of sublimation, 0.9546 and 4.34 kJ/mol (N = 373) for the enthalpy of solvation, 0.8727 and 17.93 J/mol/K (N = 2637) for the entropy of fusion and 0.5804 and 32.79 J/mol/K (N = 2643) for the total phase-change entropy of liquid crystals. The large discrepancy between the results of the two closely related entropies is discussed in detail. Molecules for which both the standard enthalpies of vaporization and sublimation were calculable, enabled the estimation of their standard enthalpy of fusion by simple subtraction of the former from the latter enthalpy. For 990 of them the experimental enthalpy-of-fusion values are also known, allowing their comparison with predictions, yielding a correlation coefficient R² of 0.6066.