Enhanced Fenton-like catalysis for pollutants removal via MOF-derived CoxFe3-xO4 membrane: Oxygen vacancy-mediated mechanism

Pilot-scale and large-scale Fenton-like applications with nano-metal catalysts: From catalytic modules to scale-up applications

Recently, great efforts have been made to advance the pilot-scale and engineering-scale applications of Fenton-like processes using various nano-metal catalysts (including nanosized metal-based catalysts, smaller nanocluster catalysts, and single-atom catalysts, etc.). This step is essential to facilitate the practical applications of advanced oxidation processes (AOPs) for these highly active nano-metal catalysts. Before large-scale implementation, these nano-metal catalysts must be converted into the effective catalyst modules (such as catalytic membranes, fluidized beds, or polypropylene sphere suspension systems), as it is not feasible to use suspended powder catalysts for large-scale treatment. Therefore, the pilot-scale and engineering applications of nano-metal catalysts in Fenton-like systems in recent years is exciting. In addition, the combination of life cycle assessment (LCA) and techno-economic analysis (TEA) can provide a useful support tool for engineering scale Fenton-like applications. This paper summarizes the designs and fabrications of various advanced modules based on nano-metal catalysts, analyzes the advantages and disadvantages of these catalytic modules, and further discusses their Fenton-like pilot scale or engineering applications. Concepts of future Fenton-like engineering applications of nano-metal catalysts were also discussed. In addition, current challenges and future expectations in pilot-scale or engineering applications are assessed in conjunction with LCA and TEA. These challenges require further technological advances to enable larger scale engineering applications in the future. The aim of these efforts is to increase the potential of nanoscale AOPs for practical wastewater treatment.

Facile synthesis of NaA zeolite supported Co2Fe1 for highly efficient degradation of Acid Orange 7 by activation of peroxymonosulfate

The development of heterogeneous Co-based catalysts with an effective combination mode of Co/Fe and supporter, a facile synthetic method, and a low treatment cost is an important environment challenge for azo dyes degradation by peroxymonosulfate (PMS) activation. In this study, NaA zeolite supported CoxFey with various molar ratio of Fe/Si and Co/Fe was synthesized by a facile hydrothermal process, and used to activate PMS for Acid Orange 7 (AO7) degradation. NaA zeolite supported Co2Fe1 with the Fe/Si molar ratio of 1:10 showed superior catalytic performance compared with other NaA zeolite supported CoxFey. In a system containing 0.6 g/L catalysts, 4 mM PMS, pH 5 and T = 30℃, 95.8% AO7 and 79.1% COD conversion could be achieved at 20 and 60 min, respectively, and the first order kinetic rate constant reached 0.14795 min-1. Moreover, NaA zeolite supported Co2Fe1/PMS system exhibited excellent catalytic effect in a wide pH range of 3-9. Temperature had an obvious effect on AO7 degradation, and the activation energy was 31.36 kJ/mol. HCO3- demonstrated an obvious depression on AO7 degradation, while Cl-, SO42- and H2PO4- had a relatively poor impact. Quenching experiments showed that both sulfate radicals ([Formula: see text]) and hydroxyl radicals (·OH) were generated in the PMS reaction system, and the [Formula: see text] was the dominant active radical. During 3 cycles experiments, an acceptable AO7 conversion ratio (91.8%) within 30 min arrived, suggesting the good stability of NaA zeolite supported Co2Fe1.

Research progress of MOF-based membrane reactor coupled with AOP technology for organic wastewater treatment

MOF-based catalytic membrane reactor (MCMR), which can simultaneously achieve membrane separation and chemical catalytic degradation in an integrated system, is a cutting-edge technology for effective treatment of organic pollutants in water. The coupling of MCMR and advanced oxidation process (AOP) not only significantly improves the pollutant removal efficiency but also inhibits the membrane pollution through self-cleaning effect, thus improving the stability of MCMR. This paper reviews different MCMR systems combined with photocatalysis, Fenton oxidation, and persulfate activation, elucidates the reaction mechanism, discusses key issues to improve system effectiveness, and suggests future challenges and research directions.

Cobalt mediated perovskite as efficient Fenton-like catalysts for the tetracycline removal over a neutral condition: The importance of superoxide radical

Cobalt mediated perovskite oxides (Ca-Fe-Co-x) were prepared for heterogeneous Fenton-like, which exhibited excellent tetracycline (TC) degradation efficiency and wider pH suitability (3-11). Experimental results showed that Ca-Fe-Co-1.0 sample displayed the highest degradation rate could reach 80.5% under neutral conditions, and maintain at around 80% after four cycles. The analysis of degradation mechanism showed that the redox of Fe²⁺/Fe³⁺ and Co²⁺/Co³⁺ significant enhanced the activation of H₂O₂ to superoxide radical (∙O₂^-). Meanwhile, the hydroxyl radical (∙OH) was also detected by ESR analysis. In addition, the possible degradation pathway and mechanism of TC were deduced via UPLC-QTOF/MS analysis and density functional theory (DFT) calculations. The toxicity of TC and its intermediates were also evaluated by the ECOSAR software. The Ca-Fe-Co-1.0/nanocellulose aerogel (NCA) displayed highly removal efficiency of TC wastewater in the long-term operation conduction. This study provided a feasible method to design and synthesis heterogeneous Fenton-like catalysts for antibiotic degradation.

Catalytic Activation of Hydrogen Peroxide Using Highly Porous Hydrothermally Modified Manganese Catalysts for Removal of Azithromycin Antibiotic from Aqueous Solution

Hydrogen peroxide catalytic activation holds great promise in the treatment of persistent pollutants. In this study, the novel Mn-Acacair/Al, Mn-Acacarg/Al and Mn-BTCarg/Al catalysts, supported on Al2O3, were applied for rapid hydrogen peroxide activation and azithromycin antibiotic removal. The catalysts were prepared by the calcination-hydrothermal method under air or argon atmosphere. The characterization confirmed that the modification of manganese with acetylacetonate and benzene-1,3,5-tricarboxylic acid (H3BTC) O-donor ligands highly improves the catalyst porosity, amorphousity, and abundance of coordinately unsaturated sites, which facilitate the generation of reactive oxygen species. The hydrogen peroxide activation and azithromycin removal reached 98.4% and 99.3% after 40 min using the Mn-BTCarg/Al catalyst with incredible stability and reusability. Only a 5.2% decrease in activity and less than 2% manganese releasing in solutions were detected after five regeneration cycles under the optimum operating conditions. The removal intermediates were identified by LC-MS/MS analysis, and the pathways were proposed. The hydroxylation and decarboxylation reactions play a key role in the degradation reaction.

Two novel zinc-based MOFs as luminescence sensors to detect phenylglyoxylic acid

Automobile exhaust gases, plastic pollutants, smoking, and other harmful substances can cause serious harm to human beings and the environment. Styrene, as a common airborne toxin, enters the human body through breathing or the skin and is discharged in the form of phenylglyoxylic acid (PGA). Therefore, specific, sensitive and trace detection of PGA is particularly important. Here, two zinc-based metal-organic frameworks {[Zn₂L₁(DMF)₂H₂O](DMF)₂H₂O}_n, {[Zn₄(L₂)₂(DMF)₂(H₂O)₃](DMF)₈}_n (L₁ = 2,5-bis((3-carboxylphenyl)amino)terephthalic acid, L₂ = 2,5-bis((4-carboxyphenyl)amino)terephthalic acid) have been reported as 1 and 2, respectively. Both 1 and 2 present 3D structures, which can both be simplified as 4,4,4-c net topology. It is worth mentioning that 2 has two different kinds of Zn SBUs as connecting nodes in the structure. Besides, compared with the other materials for the detection of PGA, 1 and 2 exhibit relatively low detection limits (LODs), both in water and in urine (where the LODs for 1 in water and urine were 0.33 μM and 0.43 μM in the range of 0-0.39 mM, and those for 2 were 0.28 μM and 0.49 μM in the range of 0-0.59 mM, respectively). In addition, the sensors have excellent anti-interference ability, high stability, rapid response, and can easily distinguish between different concentrations of PGA with the naked eye. The developed paper probes were suitable for practical sensing applications for portable detection of PGA in urine.