Simple and rapid method for 336 multiresidual pesticide analysis in saliva, determination of their chemical stabilities, and biomonitoring of farmers

A surface-enhanced infrared absorption spectroscopy (SEIRA) multivariate approach for atrazine detection

A green, fast and effective multivariate method for the determination of atrazine (ATZ) was developed using conventional infrared equipment furnished with an attenuated total reflectance module (ATR-IR), providing limit of detection (LOD) and limit of quantification (LOQ) in the ranges from 1.9 to 4.6 µg/mL and from 5.6 to 14 µg/mL, respectively. Furthermore, the surface-enhanced infrared absorption (SEIRA) approach was investigated to improve the sensitivity of the measurements and detect ATZ at low concentrations, addressing the compatibility with reference methods. To this end, a substrate formed by silver selenide quantum dots stabilized with mercaptopropionic acid (Ag2Se/MPA), synthesized in aqueous medium by an one-pot synthesis, was used. The spectral data were investigated by univariate and multivariate calibrations, allowing to calculate the enhancement factor (EF) and the multivariate enhancement factor (MEF), respectively. The SEIRA strategy proved to be able to enhance the atrazine signal up to 86-fold, allowing the detection of ATZ at concentrations as low as 0.001 µg/mL.

Simultaneous analytical method for 296 pesticide multiresidues in root and rhizome based herbal medicines with GC-MS/MS

A method for the simultaneous analysis of pesticide multiresidues in three root/rhizome-based herbal medicines (Cnidium officinale, Rehmannia glutinosa, and Paeonia lactiflora) was developed with GC-MS/MS. To determine the concentrations of pesticide residues, 5 g of dried samples were saturated with distilled water, extracted with 10 mL of 0.1% formic acid in acetonitrile/ethyl acetate (7:3, v/v), and then partitioned using magnesium sulfate and sodium chloride. The organic layer was purified with Oasis PRiME HLB plus light, followed by a cleanup with dispersive solid-phase extraction containing alumina. The sample was then injected into GC-MS/MS (2 μL) using a pulsed injection mode at 15 psi and analyzed using multiple reaction monitoring (MRM) modes. The limit of quantitation for the 296 target pesticides was within 0.002-0.05 mg/kg. Among them, 77.7-88.5% showed recoveries between 70% and 120% with relative standard deviations (RSDs) ≤20% at fortified levels of 0.01, and 0.05 mg/kg. The analytical method was successfully applied to real herbal samples obtained from commercial markets, and 10 pesticides were quantitatively determined from these samples.

LC-MS/MS Method Minimizing Matrix Effect for the Analysis of Bifenthrin and Butachlor in Chinese Chives and Its Application for Residual Study

The matrix effect refers to the change in the analytical signal caused by the matrix in which the sample is contained, as well as the impurities that are co-eluted with the target analyte. In crop sample analysis using LC-MS/MS, the matrix effect can affect the quantification results. Chinese chives are likely to exhibit a strong matrix effect when co-extracted with bifenthrin and butachlor due to the presence of phytochemicals and chlorophyll. A novel analytical method was developed to reduce the matrix effects of bifenthrin and butachlor to a negligible level in Chinese chives. The established method had a limit of quantitation of 0.005 mg/kg and correlation coefficients greater than 0.999 within the range of 0.005-0.5 mg/kg. Matrix effects were found to be negligible, with values ranging from -18.8% to 7.2% in four different sources of chives and two leafy vegetables. Compared to conventional analytical methods for the LOQ and matrix effect, the established method demonstrated improved performances. The analytical method was further applied in a residual study in chive fields. The active ingredient of butachlor 5 granule (GR) was not detected after soil admixture application, while that of bifenthrin 1 emulsifiable concentrate (EC) showed a range from 1.002 to 0.087 mg/kg after foliar spraying. The dissipation rate constant (k) of bifenthrin was determined to be 0.115, thus its half-life was calculated to be 6.0 days. From the results, PHI and safety use standards of both pesticides were suggested. The developed analytical method can be applied to accurately determine bifenthrin and butachlor residues in Chinese chives and provides a foundation for further research on the fate and behavior of these pesticides in the environment.

A high-performance Calix@ZnO based bifunctional nanomaterial for selective detection and degradation of toxic azinphos methyl in environmental samples

One of the key tenets of sustainable agriculture and food safety is the removal of toxic pesticides from the environment. However, developing reliable, affordable, and efficient methods for detecting and degrading pesticides into non-toxic degradable products remains an immediate matter of concern. Herein, we attempt to develop a strategy for the detection as well as degradation of highly toxic phosphorodithioate pesticide, Azinphos methyl (AZM), using hybrid zinc oxide nanoparticles (ZnO NPs). Considering the non-selectivity of bare ZnO and receptor R1, we have fabricated the heterocalixarene-based Calix (R1) over zinc oxide (ZnO) surface in situ via the sol-gel process. The synthesized heterocaliaxrene-modified ZnO (R1@ZnO) NPs show an excellent affinity for the selective and sensitive detection of AZM with a tremendously low limit of detection (68 mg L^-1) and no interference from other pesticides. Degradation of AZM was fully supported by fluorescence spectroscopy, scanning electron microscopy (SEM), ¹H NMR titrations, FTIR spectroscopy, cyclic voltammetry, and mass spectroscopy, which unequivocally confirmed the formation of non-toxic products. According to our findings, R1@ZnO NPs are sustainable nanomaterials that can be employed for environmental remediation since they operate in an aqueous medium.