Modelling of PFAS-surface interactions: Effect of surface charge and solution ions

Effect of Co-exposure to Additional Substances on the Bioconcentration of Per(poly)fluoroalkyl Substances: A Meta-Analysis Based on Hydroponic Experimental Evidence

A consensus has yet to emerge regarding the bioconcentration responses of per(poly)fluoroalkyl substances under co-exposure with other additional substances in aqueous environments. This study employed a meta-analysis to systematically investigate the aforementioned issues on the basis of 1,085 published datasets of indoor hydroponic simulation experiments. A hierarchical meta-analysis model with an embedded variance covariance matrix was constructed to eliminate the non-independence and shared controls of the data. Overall, the co-exposure resulted in a notable reduction in PFAS bioaccumulation (cumulative effect size, CES =  - 0.4287, p < 0.05) and bioconcentration factor (R2 = 0.9507, k < 1, b < 0) in hydroponics. In particular, the inhibition of PFAS bioconcentration induced by dissolved organic matter (percentage form of the effect size, ESP =  - 48.98%) was more pronounced than that induced by metal ions (ESP =  - 35.54%), particulate matter (ESP =  - 24.70%) and persistent organic pollutants (ESP =  - 18.66%). A lower AS concentration and a lower concentration ratio of ASs to PFASs significantly promote PFAS bioaccumulation (p < 0.05). The bioaccumulation of PFASs with long chains or high fluoride contents tended to be exacerbated in the presence of ASs. Furthermore, the effect on PFAS bioaccumulation was also significantly dependent on the duration of co-exposure (p < 0.05). The findings of this study provide novel insights into the fate and bioconcentration of PFAS in aquatic environments under co-exposure conditions.

Soil amendments reduce PFAS bioaccumulation in Eisenia fetida following exposure to AFFF-impacted soil

The efficacy of RemBind® 300 to immobilize per- and polyfluoroalkyl substances (PFAS) in aqueous film forming foam (AFFF)-impacted soil (∑28 PFAS 1280-8130 ng g-1; n = 8) was assessed using leachability (ASLP) and bioaccumulation (Eisenia fetida) endpoints as the measure of efficacy. In unamended soil, ∑28 PFAS leachability ranged from 26.0 to 235 μg l-1, however, following the addition of 5% w/w RemBind® 300, ∑28 PFAS leachability was reduced by > 99%. Following exposure of E. fetida to unamended soil, ∑28 PFAS bioaccumulation ranged from 18,660-241,910 ng g-1 DW with PFOS accumulating to the greatest extent (15,150-212,120 ng g-1 DW). Biota soil accumulation factors (BSAF) were significantly (p < 0.05) higher for perfluoroalkyl sulfonic acids (PFSA; 13.2-50.9) compared to perfluoroalkyl carboxylic acids (PFCA; 1.2-12.7) while for individual PFSA, mean BSAF increased for C4 to C6 compounds (PFBS: 42.6; PFPeS: 52.7; PFHxS: 62.4). In contrast, when E. fetida were exposed to soil amended with 5% w/w RemBind® 300, significantly lower PFAS bioaccumulation occurred (∑28 PFAS: 339-3397 ng g-1 DW) with PFOS accumulation 23-246 fold lower compared to unamended soil. These results highlight the potential of soil amendments for reducing PFAS mobility and bioavailability, offering an immobilization-based risk management approach for AFFF-impacted soil.

Investigating removal mechanisms of long- and short-chain per- and polyfluoroalkyl substances using specialty adsorbents in a field-scale surface water filtration system

This study assessed the application of two specialty adsorbents, also known as green sorption media (GSM), including clay-perlite and sand sorption media (CPS) and zero-valent iron and perlite green environmental media (ZIPGEM) to remove long- and short-chain per- and polyfluoroalkyl substances (PFAS) at field scale. The field-scale demonstration employed four GSM filter cells installed near the C-23 Canal (St. Lucie County, FL), which discharges water to the ecologically sensitive St. Lucie River estuary and to the Atlantic Ocean finally. Although prior lab-scale experiments had demonstrated the effectiveness of CPS and ZIPGEM in treating long-chain PFAS, their performance in field-scale application warranted further investigation. The study reveals the critical roles of divalent cations such as Ca2+ and monovalent cations such as ammonium and hydronium ions, as well as other water quality parameters, on PFAS removal efficacy. Ammonia, most likely resulting from photo- and bacterial ammonification, gives rise to elevated ammonium ion formation in the wet season due to the decrease in pH, which ultimately worsens PFAS adsorption. Moreover, there is a strong negative correlation between pH and PFAS removal efficiency in the presence of ammonia, as evidenced by the reduced removal of PFAS during events associated with low pH.

Roles of varying carbon chains and functional groups of legacy and emerging per-/polyfluoroalkyl substances in adsorption on metal-organic framework: Insights into mechanism and adsorption prediction

Metal-organic frameworks (MOFs) are promising adsorbents for legacy per-/polyfluoroalkyl substances (PFASs), but they are being replaced by emerging PFASs. The effects of varying carbon chains and functional groups of emerging PFASs on their adsorption behavior on MOFs require attention. This study systematically revealed the structure-adsorption relationships and interaction mechanisms of legacy and emerging PFASs on a typical MOF MIL-101(Cr). It also presented an approach reflecting the average electronegativity of PFAS moieties for adsorption prediction. We demonstrated that short-chain or sulfonate PFASs showed higher adsorption capacities (μmol/g) on MIL-101(Cr) than their long-chain or carboxylate counterparts, respectively. Compared with linear PFASs, their branched isomers were found to exhibit a higher adsorption potential on MIL-101(Cr). In addition, the introduction of ether bond into PFAS molecule (e.g., hexafluoropropylene oxide dimeric acid, GenX) increased the adsorption capacity, while the replacement of CF2 moieties in PFAS molecule with CH2 moieties (e.g., 6:2 fluorotelomer sulfonate, 6:2 FTS) caused a decrease in adsorption. Divalent ions (such as Ca2+ and SO42-) and solution pH have a greater effect on the adsorption of PFASs containing ether bonds or more CF2 moieties. PFAS adsorption on MIL-101(Cr) was governed by electrostatic interaction, complexation, hydrogen bonding, π-CF interaction, and π-anion interaction as well as steric effects, which were associated with the molecular electronegativity and chain length of each PFAS. The average electronegativity of individual moieties (named Me) for each PFAS was estimated and found to show a significantly positive correlation with the corresponding adsorption capacity on MIL-101(Cr). The removal rates of major PFASs in contaminated groundwater by MIL-101(Cr) were also correlated with the corresponding Me values. These findings will assist with the adsorption prediction for a wide range of PFASs and contribute to tailoring efficient MOF materials.

PFAS remediation in soil: An evaluation of carbon-based materials for contaminant sequestration

The presence of per- and poly-fluoroalkyl substances (PFAS) in soils is a global concern as these emerging contaminants are highly resistant to degradation and cause adverse effects on human and environmental health at very low concentrations. Sequestering PFAS in soils using carbon-based materials is a low-cost and effective strategy to minimize pollutant bioavailability and exposure, and may offer potential long-term remediation of PFAS in the environment. This paper provides a comprehensive evaluation of current insights on sequestration of PFAS in soil using carbon-based sorbents. Hydrophobic effects originating from fluorinated carbon (C-F) backbone "tail" and electrostatic interactions deriving from functional groups on the molecules' "head" are the two driving forces governing PFAS sorption. Consequently, varying C-F chain lengths and polar functional groups significantly alter PFAS availability and leachability. Furthermore, matrix parameters such as soil organic matter, inorganic minerals, and pH significantly impact PFAS sequestration by sorbent amendments. Materials such as activated carbon, biochar, carbon nanotubes, and their composites are the primary C-based materials used for PFAS adsorption. Importantly, modifying the carbon structural and surface chemistry is essential for increasing the active sorption sites and for strengthening interactions with PFAS. This review evaluates current literature, identifies knowledge gaps in current remediation technologies and addresses future strategies on the sequestration of PFAS in contaminated soil using sustainable novel C-based sorbents.

Immobilization of per- and polyfluoroalkyl substances (PFAS): Comparison of leaching behavior by three different leaching tests

The evaluation of PFAS immobilization performance in laboratory experiments, especially the long-term stability, is a challenge. To contribute to the development of adequate experimental procedures, the impact of experimental conditions on the leaching behavior was studied. Three experiments on different scales were compared: batch, saturated column, and variably saturated laboratory lysimeter experiments. The Infinite Sink (IS) test - a batch test with repeated sampling - was applied for PFAS for the first time. Soil from an agricultural field amended with paper-fiber biosolids polluted with various perfluoroalkyl acids (PFAAs; 655 μg/kg ∑¹⁸PFAAs) and polyfluorinated precursors (1.4 mg/kg ∑¹⁸precursors) was used as the primary material (N-1). Two types of PFAS immobilization agents were tested: treatment with activated carbon-based additives (soil mixtures: R-1 and R-2), and solidification with cement and bentonite (R-3). In all experiments, a chain-length dependent immobilization efficacy is observed. In R-3, the leaching of short-chain PFAAs was enhanced relative to N-1. In column and lysimeter experiments with R-1 and R-2, delayed breakthrough of short-chain PFAAs (C4) occurred (> 90 days; in column experiments at liquid-to-solid ratio (LS) > 30 L/kg) with similar temporal leaching rates suggesting that leaching in these cases was a kinetically controlled process. Observed differences between column and lysimeter experiments may be attributed to varying saturation conditions. In IS experiments, PFAS desorption from N-1, R-1, and R-2 is higher than in the column experiments (N-1: +44 %; R-1: +280 %; R-2: +162 %), desorption of short-chain PFAS occurred predominantly in the initial phase (< 14 days). Our findings demonstrate that sufficient operating times are essential in percolation experiments, e.g., in column experiments >100 days and LS > 30 L/kg. IS experiments may provide a faster estimate for nonpermanent immobilization. The comparison of experimental data from various experiments is beneficial to evaluate PFAS immobilization and to interpret leaching characteristics.