Substituent effects on furan-phenylene copolymer for photovoltaic improvement: A density functional study

Preparation of UV-cured cellulose nanocrystal-filled epoxidized natural rubber and its application in a triboelectric nanogenerator

Cellulose nanocrystal (CNC) is an abundant biopolymer possessing high strength and biodegradability. In the present work, the extraction of CNCs from Napier grass stems was carried out. The CNCs were subsequently modified by maleic anhydride, called M-CNC, before being incorporated into the epoxidized natural rubber (ENR). The compounds were later cured by ultraviolet (UV) irradiation under various conditions. The obtained optimum condition was then used to fabricate the biocomposites filled with various CNC and M-CNC loadings for triboelectric nanogenerator (TENG) performance measurements. Output voltage and current increased continuously with increasing filler loading. Regardless of the filler type, an increase in filler loading enhanced TENG output. ENR/M-CNC exhibited a superior TENG output to ENR/CNC due to the greater electron transfer capability of the biocomposites, as proven by the reduction in the ionization potential (IP) value obtained from the quantum calculation. In this study, ENR/M-CNC5 exhibited the maximum output voltage (80.3 V), current (7.4 μA), and power density (1.32 W/m2) at a load resistance of 9 MΩ.

Modification of NFA-Conjugated Bridges with Symmetric Structures for High-Efficiency Non-Fullerene PSCs

As electron acceptors, non-fullerene molecules can overcome the shortcomings of fullerenes and their derivatives (such as high cost, poor co-solubility, and weak light absorption). The photoelectric properties of two potential non-fullerene polymer solar cells (PSCs) PBDB-T:IF-TN (PB:IF) and PBDB-T:IDT-TN (PB:IDT) are studied by density functional theory (DFT) and time-dependent DFT (TD-DFT). Based on the optimized structure of the ground state, the effects of the electron donor (D) and electron acceptor (A) (D/A) interfaces PBDB-T/IF-TN (PB/IF) and PBDB-T/IDT-TN (PB/IDT) are studied by a quantum-chemical method (QM) and Marcus theory. Firstly, for two non-fullerene acceptors (NFAs) IF-TN and IDT-TN, the NFA IDT-TN has better optical absorption ability and better electron transport ability than IF-TN. Secondly, for the D/A interfaces PB/IF and PB/IDT, they both have high optical absorption and electron transfer abilities, and PB/IDT has better optical absorption and lower exciton binding energy. Finally, some important parameters (open-circuit voltage, voltage loss, fill factor, and power conversion efficiency) are calculated and simulated by establishing the theoretical model. From the above analysis, the results show that the non-fullerene PSC PB:IDT has better photoelectric characteristics than PB:IF.