Remarkable enhancement of visible light driven photocatalytic performance of TiO2 by simultaneously doping with C, N, and S

From wastewater to clean water: Recent advances on the removal of metronidazole, ciprofloxacin, and sulfamethoxazole antibiotics from water through adsorption and advanced oxidation processes (AOPs)

Antibiotics released into water sources pose significant risks to both human health and the environment. This comprehensive review meticulously examines the ecotoxicological impacts of three prevalent antibiotics-ciprofloxacin, metronidazole, and sulfamethoxazole-on the ecosystems. Within this framework, our primary focus revolves around the key remediation technologies: adsorption and advanced oxidation processes (AOPs). In this context, an array of adsorbents is explored, spanning diverse classes such as biomass-derived biosorbents, graphene-based adsorbents, MXene-based adsorbents, silica gels, carbon nanotubes, carbon-based adsorbents, metal-organic frameworks (MOFs), carbon nanofibers, biochar, metal oxides, and nanocomposites. On the flip side, the review meticulously examines the main AOPs widely employed in water treatment. This includes a thorough analysis of ozonation (O3), the photo-Fenton process, UV/hydrogen peroxide (UV/H2O2), TiO2 photocatalysis, ozone/UV (O3/UV), radiation-induced AOPs, and sonolysis. Furthermore, the review provides in-depth insights into equilibrium isotherm and kinetic models as well as prospects and challenges inherent in these cutting-edge processes. By doing so, this review aims to empower readers with a profound understanding, enabling them to determine research gaps and pioneer innovative treatment methodologies for water contaminated with antibiotics.

A review on led technology in water photodisinfection

The increase in efficiency achieved by UV LED devices has led to a compelling increase in research reports on UV LED water treatment for consumption in the past few years. This paper presents an in-depth review based on recent studies on the suitability and performance of UV LED-driven processes for water disinfection. The effect of different UV wavelengths and their combinations was analysed for the inactivation of various microorganisms and the inhibition of repair mechanisms. Whereas 265 nm UVC LED present a higher DNA damaging potential, 280 nm radiation is reported to repress photoreactivation and dark repair. No synergistic effects have been proved to exist when coupling UVB + UVC whereas sequential UVA-UVC radiation seemed to enhance inactivation. Benefits of pulsed over continuous radiation in terms of germicidal effects and energy consumption were also analysed, but with inconclusive results. However, pulsed radiation may be promising for improving thermal management. As a challenge, the use of UV LED sources introduces significant inhomogeneities in the light distribution, pushing for the development of adequate simulation methods to ensure that the minimum target dose required for the target microbes is achieved. Concerning energy consumption, selecting the optimal wavelength of the UV LED needs a compromise between the quantum efficiency of the process and the electricity-to-photon conversion. The expected development of the UV LED industry in the next few years points to UVC LED as a promising technology for water disinfection at a large scale that could be competitive in the market in the near future.

Heterogeneous photocatalytic oxidation for the removal of organophosphorus pollutants from aqueous solutions: A review

Organophosphorus pollutants (OPs), which are compounds containing carbon‑phosphorus bonds or phosphate derivatives containing organic groups, have received much attention from researchers because of their persistence in the aqueous environment for long periods of time and the threat they pose to human health. Heterogeneous photocatalysis has been widely applied to the removal of OPs from aqueous solutions due to its better removal effect and environmental friendliness. In this review, the removal of OPs from aqueous matrices by heterogeneous photocatalysis was presented. Herein, the application and the heterogeneous photocatalysis mechanism of OPs were described in detail, and the effects of catalyst types on degradation effect are discussed categorically. In particular, the heterojunction type photocatalyst has the most excellent effect. After that, the photocatalytic degradation pathways of several OPs were summarized, focusing on the organophosphorus pesticides and organophosphorus flame retardants, such as methyl parathion, dichlorvos, dimethoate and chlorpyrifos. The toxicity changes during degradation were evaluated, indicating that the photocatalytic process could effectively reduce the toxicity of OPs. Additionally, the effects of common water matrices on heterogeneous photocatalytic degradation of OPs were also presented. Finally, the challenges and perspectives of heterogeneous photocatalysis removal of OPs are summarized and presented.

A Simple Fabrication of Sb2S3/TiO2 Photo-Anode with Long Wavelength Visible Light Absorption for Efficient Photoelectrochemical Water Oxidation

An Sb₂S₃-sensitized TiO₂ (Sb₂S₃/TiO₂) photo-anode (PA) exhibiting a high photo-electrochemical (PEC) performance in water oxidation has been successfully prepared by a simple chemical bath deposition (CBD) technique. Herein, the Raman spectra and XPS spectrum of Sb₂S₃/TiO₂ confirmed the formation of Sb₂S₃ on the TiO₂ coatings. The Sb₂S₃/TiO₂ photo-anode significantly shifted the absorption edge from 395 nm (3.10 eV) to 650 nm (1.90 eV). Furthermore, the Sb₂S₃/TiO₂ photo-anode generated a photo-anodic current under visible light irradiation below 650 nm due to the photo-electrochemical action compared with the TiO₂ photo-anode at 390 nm. The incident photon-to-current conversion efficiency (IPCE = 7.7%) at 400 nm and -0.3 V vs. Ag/AgCl was 37 times higher than that (0.21%) of the TiO₂ photo-anodes due to the low recombination rate and acceleration of the carriers of Sb₂S₃/TiO₂. Moreover, the photo-anodic current and photostability of the Sb₂S₃/TiO₂ photo-anodes improved via adding the Co²⁺ ions to the electrolyte solution during photo-electrocatalysis.

Process monitoring of photocatalytic degradation of 2,4-dinitrotoluene by Au-decorated Fe3O4@TiO2 nanoparticles: surface-enhanced Raman scattering method

Recently, the degradation and detection of 2,4-dinitrotoluene (2,4-DNT) capable of producing 2,4,6-trinitrotoluene (TNT) for environmental and human health risks have been developed. We prepared photoresponsive Au-decorated Fe₃O₄@TiO₂ nanoparticles (Fe₃O₄@TiO₂-Au NPs) under sunlight simulated Xe lamp irradiation. The photodegradation process of 2,4-DNT by Fe₃O₄@TiO₂-Au NPs was successfully monitored by surface-enhanced Raman scattering (SERS). Since SERS monitoring shows intrinsic information about the molecular structure, it was possible to predict the photodegradation of 2,4-DNT. The 2,4-DNT photodegradation mechanism based on two-dimensional correlation spectroscopy (2D-COS), which provides very beneficial information for a deeper understanding of systems, has been identified. We confirmed that Fe₃O₄@TiO₂-Au NPs can be widely used in organic pollutant degradation under sunlight. Furthermore, the combination of SERS based process monitoring and 2D-COS can be a convincing analytical technique for photodegradation studies of organic pollutants.

Novel N,C,S-TiO2/WO3/rGO Z-scheme heterojunction with enhanced visible-light driven photocatalytic performance

Novel N,C,S-TiO₂/WO₃/rGO Z scheme photocatalyst was successfully synthesized from graphite, TIOT, and ammonium metatungstate precursors. Material characteristics such as crystal structure, surface morphology, functional groups, specific surface area, elemental composition, band gap energy, and electron-hole recombination were characterized by XRD, TEM, BET, SEM/EDX, FT-IR, UV-VIS, and PL methods. The as-synthesized novel N,C,S-TiO₂/WO₃/rGO Z-scheme heterojunction photocatalyst exhibited visible light-driven photocatalytic activity (the band gap energy = 2.24 eV), could generate both effective electrons and holes, and presented the lowest electron-hole recombination rate compared to all individual components. Different factors impacting the photocatalytic decomposition of Direct Blue 71 (DB 71) by the N,C,S-TiO₂/WO₃/rGO system were studied. The results showed that pH of the solution, catalyst load, DB 71 initial concentration, and reaction time affected the DB 71 photocatalytic degradation efficiency. The DB 71 degradation completed after 100 min with a typical efficiency of over 91%, which was much better than other photocatalytic systems. The DB 71 degradation process followed the pseudo-first-order kinetics model with coefficients of determination > 0.95 for all conditions. The photocatalyst was easily regenerated, and exhibited a very good stability, with a photocatalytic degradation efficiency of over 83.0% after 3 cycles.