Quantum studies of methane-metal inelastic diffraction and trapping: the variation with molecular orientation and phonon coupling

Accurate Reaction Probabilities for Translational Energies on Both Sides of the Barrier of Dissociative Chemisorption on Metal Surfaces

Molecular dynamics simulations are essential for a better understanding of dissociative chemisorption on metal surfaces, which is often the rate-controlling step in heterogeneous and plasma catalysis. The workhorse quasi-classical trajectory approach ubiquitous in molecular dynamics is able to accurately predict reactivity only for high translational and low vibrational energies. In contrast, catalytically relevant conditions generally involve low translational and elevated vibrational energies. Existing quantum dynamics approaches are intractable or approximate as a result of the large number of degrees of freedom present in molecule-metal surface reactions. Here, we extend a ring polymer molecular dynamics approach to fully include, for the first time, the degrees of freedom of a moving metal surface. With this approach, experimental sticking probabilities for the dissociative chemisorption of methane on Pt(111) are reproduced for a large range of translational and vibrational energies by including nuclear quantum effects and employing full-dimensional simulations.

Surface-induced vibrational energy redistribution in methane/surface scattering depends on catalytic activity

Recent state-to-state experiments of methane scattering from Ni(111) and graphene-covered Ni(111) combined with quantum mechanical simulations suggest an intriguing correlation between the surface-induced vibrational energy redistribution (SIVR) during the molecule/surface scattering event and the catalytic activity for methane dissociation of the target surface (Werdecker, Phys. Rev. Res., 2020, 2, 043251). Herein, we report new quantum state and angle-resolved measurements for methane scattering from Ni(111) and Au(111) probing the extent of ν 3 → ν 1 antisymmetric-to-symmetric conversion of methane stretching motion for two surfaces with different catalytic activities. Consistent with the expectations, the extent of SIVR occurring on the more catalytically active Ni(111) surface, as measured by the ν 1 : ν 3 scattered population ratio, is found to be several times stronger than that on the more inert Au(111) surface. We also present additional insights on the rovibrational scattering dynamics contained in the angle- and state-resolved data. The results together highlight the power of state-resolved scattering measurements as a tool for investigating methane-surface interactions.

An examination of phonon-inelastic molecule-metal scattering using reduced density matrix and stochastic wave packet methods

We explore the application of reduced density matrix-based approaches to molecules interacting with the lattice vibrations of metals, an interaction responsible for the temperature dependence of many of the fundamental steps of catalysis. We avoid the use of simple models for the bath and instead use density functional theory to compute all molecule-phonon interactions and the properties of the lattice phonons, for methane scattering from Ir(111). We find that while the large metal mass leads to long bath correlation times, these are not significantly longer than the time over which the reduced density matrix changes due to interactions with the bath. We show that the neglect of memory is reasonable and the use of the Redfield equation is justified. We also show how the commonly used rotating wave approximation is far too severe for this scattering problem. A less restrictive approximation that is nearly exact for our system gives an equation of motion in the Lindblad form. As a result, the Monte Carlo wave packet methods can be used to describe gas-phonon scattering, guaranteeing positivity, and with all couplings derived from first-principles.

The quantum dynamics of H2 on Cu(111) at a surface temperature of 925 K: Comparing state-of-the-art theory to state-of-the-art experiments 2

State-of-the-art 6D quantum dynamics simulations for the dissociative chemisorption of H₂ on a thermally distorted Cu(111) surface, using the static corrugation model, were analyzed to produce several (experimentally available) observables. The expected error, especially important for lower reaction probabilities, was quantified using wavepackets on several different grids as well as two different analysis approaches to obtain more accurate results in the region where a slow reaction channel was experimentally shown to be dominant. The lowest reaction barrier sites for different thermally distorted surface slabs are shown to not just be energetically, but also geometrically, different between surface configurations, which can be used to explain several dynamical effects found when including surface temperature effects. Direct comparison of simulated time-of-flight spectra to those obtained from state-of-the-art desorption experiments showed much improved agreement compared to the perfect lattice BOSS approach. Agreement with experimental rotational and vibrational efficacies also somewhat improved when thermally excited surfaces were included in the theoretical model. Finally, we present clear quantum effects in the rotational quadrupole alignment parameters found for the lower rotationally excited states, which underlines the importance of careful quantum dynamical analyses of this system.

Accurate Description of the Quantum Dynamical Surface Temperature Effects on the Dissociative Chemisorption of H2 from Cu(111)

Accurately describing surface temperature effects for the dissociative scattering of H2 on a metal surface on a quantum dynamical level is currently one of the open challenges for theoretical surface scientists. We present the first quantum dynamical (QD) simulations of hydrogen dissociating on a Cu(111) surface which accurately describe all relevant surface temperature effects, using the static corrugation model (SCM). The reaction probabilities we obtain show very good agreement with those found using quasi-classical dynamics (QCD), both for individual surface slabs and for an averaged, thus Monte-Carlo sampled, set of thermally distorted surface configurations. Rovibrationally elastic scattering probabilities show a much clearer difference between the QCD and QD results, which appears to be traceable back towards thermally distorted surface configurations with very low dissociation probabilities and underlines the importance of investigating more observables than just dissociation. By reducing the number of distorted surface atoms included in the dynamical model, we also show that only including one, or even three, surface atoms is generally not enough to accurately describe the effects of surface temperature on dissociation and elastic scattering. These results are a major step forward in accurately describing hydrogen scattering from a thermally excited Cu(111) surface, and open up a pathway to better describe reaction and scattering from other relevant crystal facets, such as stepped surfaces, at moderately elevated surface temperatures where quantum effects are expected to play a more important role in the dissociation of H2 on Cu.