Parameters affecting microwave-assisted extraction of organophosphorus pesticides from agricultural soil

Development of an online μ-matrix cartridge extraction method for fipronil extraction in contaminated soils

Nowadays, environment fate and behavior of pesticides in soil is still not fully understood due to the lack of standardized soil extraction method. In this work, a soil-filled micro-matrix cartridge was online combined with high performance liquid chromatography-mass spectrometry (HPLC-MS) through a six-way valve for the simultaneous extraction and determination of residual fipronil in soil. Compared with conventional extraction methods, such as hydroxypropyl-β-cyclodextrin (HPCD) extraction, shaking extraction, ultrasonic-assisted extraction (UAE), three-step extraction and matrix solid phase dispersion (MSPD), the novel, miniaturized, and integrated online micro-matrix cartridge extraction (online μ-MCE) method exhibited better performance in terms of desorption efficiency (99.4%), analysis time, solvent consumption, sensitivity, and automation. In sequential extraction, online μ-MCE could further desorb fipronil from the extracted soil with the percentage of 1.05%-58.55%. High recovery of 92.69% obtained for the ISO certificated test-soil verified the satisfactory accuracy of the method. Besides, its wide universality was also validated in three variables: 1) various pesticides-soil interactions, 2) four types of compounds (aromatic hydrocarbons, carboxylic acids, alcohols and aldehydes), and 3) three types of soils (sandy soil, silty loam and silty clay). The superior desorption capacity might be attributed to the instantaneously increased high-pressure, continuous flow dynamic desorption and short residence time. The present encouraging findings might shed light on new ways to develop a mild, highly efficient, reliable and one-fit-all extraction method toward pesticide contaminated soil.

Critical review and re-assessment of analyte protectants in gas chromatography

Despite nearly 80 years of advancements in gas chromatography (GC), indirect chemical matrix effects (MEs), known as the matrix-induced response enhancement effect, still occur to cause a high bias in the GC analysis of susceptible analytes, unless precautions are taken. Matrix-matched calibration is one common option used in GC to compensate for the MEs, but this approach is usually inconvenient, imprecise, and inefficient. Other options, such as the method of standard additions, surface deactivation techniques, chemical derivatizations, priming the GC, and/or use of internal standards, also have flaws in practice. When methods are accommodating, the use of analyte protectants (APs) can provide the best practical solution to not only overcome MEs, but also to maximize analyte signal by increasing chromatographic and detection efficiencies for the analytes. APs address the source of MEs in every injection by filling active sites in the GC inlet, column, and detector, particularly in GC-MS, rather than the analytes that would otherwise undergo degradation, peak tailing, and/or diminished response due to interactions with the active sites. The addition of an adequate amount of APs (e.g. sugar derivatives) to all calibration standards and final extracts alike often leads to lower detection limits, better accuracy, narrower peaks, and greater robustness than the other options to compensate for MEs in GC. This article consists of a critical review of the scientific literature, proposal of mechanisms and theory, and re-evaluation studies involving APs for the first time in GC-orbitrap and GC-MS/MS with a high-efficiency ion source design. The findings showed that 1 µg each of co-injected shikimic acid and sorbitol in the former case, and 1 µg shikimic acid alone in the latter case, led to high quality results in multi-residue analysis of pesticides and environmental contaminants.

Influence of QuEChERS modifications on recovery and matrix effect during the multi-residue pesticide analysis in soil by GC/MS/MS and GC/ECD/NPD

A QuEChERS extraction followed by GC/MS/MS and GC-μECD/NPD for 216 pesticide and metabolites determination in soil simultaneously were developed and compared. Volume of water, volume and polarity of solvent, and cleanup sorbents (C18, GCB, PSA) were optimized. The QuEChERS with and without purification step were applied to estimate effectiveness of the method. The recovery and matrix effect (ME) were critical parameters within each tested procedure. The optimal method without cleanup was validated. Accuracy (expressed as recovery), precision (expressed as RSD), linearity, LOQ, and uncertainty were determined. The recoveries at the three spiking levels using matrix-matched standards ranged between 65 and 116% with RSD ≤17 and 60-112% with RSD ≤18% for MS/MS and μEC/NP, respectively. The LOQ ranged from 0.005-0.01 mg/kg for MS/MS to 0.05 mg/kg for μEC/NP. The ME for most of pesticides resulted in enhancement of the signal and depended on the analyte and detection system: MS/MS showed ME from -25 to 74%, while μEC/NP from -45 to 96%. A principal component analysis was performed to explain the relationships between physicochemical parameters and ME of 216 pesticides. The QuEChERS protocol without the cleanup step is a promising option to make the method less expensive and faster. This methodology was applied in routine analysis of 263 soil samples in which p,p' DDT was the most frequently detected (23.5% of samples) and pendimethalin with the highest concentration (1.63 mg/kg).

Methyl parathion imprinted polymer nanoshell coated on the magnetic nanocore for selective recognition and fast adsorption and separation in soils

Core-shell magnetic methyl parathion (MP) imprinted polymers (Fe3O4@MPIPs) were fabricated by a layer-by-layer self-assembly process. In order to take full advantage of the synergistic effect of hydrogen-binding interactions and π-π accumulation between host and guest for molecular recognition, methacrylic acid and 4-vinyl pyridine were chosen as co-functional monomers and their optimal proportion were investigated. The core-shell and crystalline structure, morphology and magnetic properties of Fe3O4@MPIPs were characterized. The MP-imprinted nanoshell was almost uniform and about 100nm thick. Binding experiments demonstrated that Fe3O4@MPIPs possessed excellent binding properties, including high adsorption capacity and specific recognition, as well as fast adsorption kinetics and a fast phase separation rate. The equilibration adsorption capacity reached up to 9.1mg/g, which was 12 times higher than that of magnetic non-imprinted polymers, while adsorption reached equilibrium within 5min at a concentration of 0.2mmol/L. Furthermore, Fe3O4@MPIPs successfully provided selective separation and removal of MP in soils with a recovery and detection limit of 81.1-87.0% and 5.2ng/g, respectively.

Analytical methodologies for the determination of endocrine disrupting compounds in biological and environmental samples

Endocrine-disruptor compounds (EDCs) can mimic natural hormones and produce adverse effects in the endocrine functions by interacting with estrogen receptors. EDCs include both natural and synthetic chemicals, such as hormones, personal care products, surfactants, and flame retardants, among others. EDCs are characterised by their ubiquitous presence at trace-level concentrations and their wide diversity. Since the discovery of the adverse effects of these pollutants on wildlife and human health, analytical methods have been developed for their qualitative and quantitative determination. In particular, mass-based analytical methods show excellent sensitivity and precision for their quantification. This paper reviews recently published analytical methodologies for the sample preparation and for the determination of these compounds in different environmental and biological matrices by liquid chromatography coupled with mass spectrometry. The various sample preparation techniques are compared and discussed. In addition, recent developments and advances in this field are presented.

Determination of organophosphorus pesticides using dispersive liquid-liquid microextraction combined with reversed electrode polarity stacking mode-micellar electrokinetic chromatography

A rapid and sensitive method using two preconcentration techniques, dispersive liquid-liquid microextraction (DLLME) followed by reversed electrode polarity stacking mode (REPSM) was developed for the analysis of five organophosphorus pesticides (OPPs) by micellar electrokinetic chromatography (MEKC). Parameters that affect the efficiency of the extraction in DLLME and preconcentration by REPSM, such as the kind and volume of the extraction and disperser solvents, salt addition, sample matrix and injection time were investigated and optimized. Under the optimum conditions, the enrichment factors were obtained in the range from 477 to 635. The linearity of the method for parathion, azinphos and fenitrithion was in the range of 20-1000 ng mL(-1), and for malathion and diazinon in the range of 50-1000 ng mL(-1), with correlation coefficients (r(2)) ranging from 0.9931 to 0.9992. The limits of detecton (LODs) at a signal-to-noice ratio of 3 ranged from 3 to 15 ng mL(-1). The relative recoveries of five OPPs from water samples at spiking levels of 20 and 200 ng mL(-1) for parathion, azinphos and fenitrithion, and 50 and 500 ng mL(-1) for malathion and diazinon, were 69.5-103%. The proposed method provided high enrichment factors, good precision and accuracy with a short analysis time.

Simultaneous determination of organophosphorus pesticides in Chinese herbal medicines by microwave-assisted extraction coupled with dispersive-solid phase extraction and gas chromatography

A reliable, rapid and nontoxic analytical method was proposed for the simultaneous determination of 16 organophosphorus pesticides in Chinese herbal medicines. The pesticides were extracted by ethanol and the experimental variables, such as temperature, extraction time and volume of ethanol, were optimized through orthogonal array experimental design. Cleanup of extracts was performed with dispersive-solid phase extraction using primary secondary amine as the sorbent. The determination of pesticides in the final extracts was carried out by gas chromatography-flame photometric detection. Under optimized conditions the obtained recoveries, except for isocarbophos, were in the range 73.8-123%, with relative standard deviations equal to or lower than 15.2% and limits of detection ranging from 0.001 to 0.009 mg/kg.

Design of experiments in environmental chemistry studies: example of the extraction of triazines from soil after olive cake amendment

The disposal of natural, composted and vermicomposted olive cake for modifying the fate of triazine herbicides with different physicochemical properties (terbuthylazine, cyanazine, simazine and prometryn) has been tested. Experimental design (surface response methodology plus desirability function) to multicriteria optimization was carried out to evaluate both dose and type of amendment to retain the cited analytes and to develop two simple and low cost analytical methods for extracting triazines from soil. From a methodological point of view, classical and D-optimal designs were employed depending on the problem. Thus, the best combination of soil amount and solvent ratio, the most important parameters affecting triazine extraction from soil, was looked for by means of Central Composite Designs. Under the optimized conditions, the range of triazines recovery was 75-85% for shaking extraction and 87-107% for ultrasonic extraction. Regarding the amendment assay, D-optimal design was selected to keep the reliability of the estimations. Natural olive cake added to the soil at a high dose (8%) reduced herbicide recovery to ca. 50-60% for terbuthylazine, prometryn and simazine, while cyanazine recovery was negligible. Design of experiment provides an efficient working strategy to explore those conditions which ensure the optimum or target value of several responses evaluated simultaneously.