Superheated water chromatography on phenyl bonded hybrid stationary phases

Studies on the stability of preservatives under subcritical water conditions

OBJECTIVE

The goal of this work was to further validate the subcritical water chromatography (SBWC) methods for separation and analysis of preservatives through the evaluation of analyte stability in subcritical water.

METHODS

In this study, the degradation of preservatives was investigated at temperatures of 100-200°C using two different approaches. First, the peak areas obtained by SBWC at high temperatures were compared with those achieved using the traditional high-performance liquid chromatography (HPLC) at 25°C. In the second approach, several preservatives and water were loaded into a vessel and heated at high temperatures for 30 or 60 min. The heated mixtures were then analysed by GC/MS to determine the stability of preservatives.

RESULTS

The t- and F-test on the results of the first approach reveal that the peak areas achieved by HPLC and SBWC are not significantly different at the 95% confidence level, meaning that the preservatives studied are stable during the high-temperature SBWC runs. Although the results of the second approach show approximately 10% degradation of preservatives into mainly p-hydroxybenzoic acid and phenol at 200°C, the preservatives studied are stable at 100 and 150°C. This is in good agreement with the validation results obtained by the first approach.

CONCLUSION

The findings of this work confirm that SBWC methods at temperatures up to 150°C are reliable for separation and analysis of preservatives in cosmetic and other samples.

High-temperature reversed-phase liquid chromatography coupled to isotope ratio mass spectrometry

Compound-specific isotope analysis (CSIA) by liquid chromatography coupled to isotope ratio mass spectrometry (LC/IRMS) has until now been based on ion-exchange separation. In this work, high-temperature reversed-phase liquid chromatography was coupled to, and for the first time carefully evaluated for, isotope ratio mass spectrometry (HT-LC/IRMS) with four different stationary phases. Under isothermal and temperature gradient conditions, the column bleed of XBridge C(18) (up to 180 °C), Acquity C(18) (up to 200 °C), Triart C(18) (up to 150 °C), and Zirchrom PBD (up to 150 °C) had no influence on the precision and accuracy of δ(13) C measurements, demonstrating the suitability of these columns for HT-LC/IRMS analysis. Increasing the temperature during the LC/IRMS analysis of caffeine on two C(18) columns was observed to result in shortened analysis time. The detection limit of HT-RPLC/IRMS obtained for caffeine was 30 mg L(-1) (corresponding to 12.4 nmol carbon on-column). Temperature-programmed LC/IRMS (i) accomplished complete separation of a mixture of caffeine derivatives and a mixture of phenols and (ii) did not affect the precision and accuracy of δ(13)C measurements compared with flow injection analysis without a column. With temperature-programmed LC/IRMS, some compounds that coelute at room temperature could be baseline resolved and analyzed for their individual δ(13)C values, leading to an important extension of the application range of CSIA.