Rapid determination of ethylene oxide with fiber-packed sample preparation needle

Determination of Polychlorinated Biphenyls in Water Samples Using a Needle Trap Device Combined with Gas Chromatography

In this study, a fiber-packed needle trap device (NTD) was developed by packing heat-resistant fibers with a polyethylene glycol sol-gel coating into a 21-gauge, stainless steel needle. The polyethylene glycol sol-gel coating has numerous advantages, including uniform roughness and a large specific surface area. The prepared NTD was used for headspace extraction of five polychlorinated biphenyls (PCBs) in water samples, determined by gas chromatography with a flame ionization detector (GC-FID). The main experimental parameters, including the extraction and desorption conditions, ionic strength, and fiber bundles, were investigated to improve the extraction efficiency. After optimization, satisfactory linearity (r > 0.99) in the concentration range of 0.02–500 μg/L was obtained, and the enrichment factor of NTD for the five PCBs was between 1150 and 9537 times. The limit of detection (S/N = 3) of five PCBs were measured in ranges of 0.0021–0.01 μg/L. Furthermore, the fiber-packed NTD has excellent durability, and can be reused for 60 cycles. After being stored at room temperature for three days, the storage ability of the NTD had a loss of PCBs less than 10%, and the relative standard deviation (RSD) was less than 10%. When analyzing the PCBs in real water samples, good accuracies (spiked recoveries were in the range of 92.19–98.56%) and precision (the RSD was lower than 12.8%) was obtained.

Rapid Determination of Ethylene Oxide and 75 VOCs in Ambient Air with Canister Sampling and Associated Growth Issues

A canister-based sampling method along with preconcentrator-Gas chromatography-Mass Spectrometry (GC-MS) analysis was applied to ethylene oxide (EtO or EO) and 75 other volatile organic compounds (VOCs) in ambient air. Ambient air can contain a large variety of VOCs, and thorough analysis requires non-discriminatory sampling and a chromatographic method capable of resolving a complex mixture. Canister collection of whole air samples allows for the collection of a wide range of volatile compounds, while the simultaneous analysis of ethylene oxide and other VOCs allows for faster throughput than separate methods. The method presented is based on US EPA Method TO-15A and allows for the detection of EtO from 18 to 2500 pptv. The method has an average accuracy of 104% and precision of 13% relative standard deviation (RSD), with an instrument run time of 32 min. In addition, a link between canister cleanliness and ethylene oxide growth is observed, and potential mechanisms and cleaning strategies are addressed.

A novel switchable solvent liquid-phase microextraction technique based on the solidification of floating organic droplets: HPLC-FLD analysis of polycyclic aromatic hydrocarbon monohydroxy metabolites in urine samples

A novel switchable solvent liquid-phase microextraction technique, based on the solidification of floating organic droplets (SS-LPME-SFO), was developed for the pretreatment of aqueous samples.

A novel aptamer-based online magnetic solid phase extraction method for simultaneous determination of urinary 8-hydroxy-2'-deoxyguanosine and monohydroxylated polycyclic aromatic hydrocarbons

In this work, an innovative aptamer-based magnetic adsorbent (Fe₃O₄@PDA-aptamer MNPs) was prepared by hydrothermal synthesis method followed by the surface functionalization of nanoparticles. After fixing in a steel stainless tube as sorbent of magnetic solid phase extraction (MSPE), an online magnetic solid phase extraction-high performance liquid chromatography-mass spectrometry (online-MSPE-HPLC-MS) method was developed and applied for the determination of 8-hydroxy-2'-deoxyguanosine (8-OHdG) and monohydroxylated polycyclic aromatic hydrocarbons (OH-PAHs) simultaneously in urine. The synthesized sorbent presented outstanding features, including large specific surface area, high enrichment capacity and excellent stability. High throughput analysis can be achieved by affinity-specific adsorption of 8-OHdG and non-specific adsorption of OH-PAHs at the same time. In addition, online MSPE can greatly simplify the analysis process, reduce human errors and enhance the sensitivity. When compared with offline MSPE, a sensitivity enhancement of 30-400 times was obtained for the online method. Some experimental parameters such as the amount of the sorbent, sampling flow rate and sample volume, were optimized systematically. Under the optimal conditions, the limits of detection (LOD) were in the range of 0.028-0.114 ng mL^-1, and the correlation coefficients (R²) were higher than 0.9962. The relative standard deviations (RSDs) were less than 16.1% (n = 5) and the recoveries ranged from 71% to 116%. The above results show that the rapid, sensitive and automated online-MSPE-HPLC-MS method has potential application in the simultaneous determination of 8-OHdG and PAHs in complex sample matrix to assess the environmental exposure level.

Preconcentration of Aromatic Compounds in Aqueous Samples with a Polymer-coated Fiber-packed Capillary and Subsequent Temperature-programmed Elution with Water for Pseudo-2D LC Separations

A bundle of polymer-coated filaments was successfully introduced as an extraction medium for the preconcentration of an aqueous solution of aromatic compounds. The extraction was simply carried out with pumping the aqueous sample solution to the extraction capillary at ambient temperature. The extracted analytes were sequentially eluted with a flow of pure water using temperature-programmed heating of the extraction capillary in an oven. The results clearly suggest that the polymer-coated fiber-packed capillary could be employed in the sample preparation process for the analysis of various aqueous samples. Introducing the fractions eluted from the fiber-packed capillary to a conventional microcolumn liquid chromatography (micro-LC) system via a home-made valve-based modulator, an on-line coupled extraction/separation system was developed and a possibility to a pseudo-two-dimensional (pseudo-2D) LC separation of aromatic compounds in aqueous matrices has also been demonstrated.

Optimization of the in-needle extraction device for the direct flow of the liquid sample through the sorbent layer

In-needle extraction was applied for preparation of aqueous samples. This technique was used for direct isolation of analytes from liquid samples which was achieved by forcing the flow of the sample through the sorbent layer: silica or polymer (styrene/divinylbenzene). Specially designed needle was packed with three different sorbents on which the analytes (phenol, p-benzoquinone, 4-chlorophenol, thymol and caffeine) were retained. Acceptable sampling conditions for direct analysis of liquid sample were selected. Experimental data collected from the series of liquid samples analysis made with use of in-needle device showed that the effectiveness of the system depends on various parameters such as breakthrough volume and the sorption capacity, effect of sampling flow rate, solvent effect on elution step, required volume of solvent for elution step. The optimal sampling flow rate was in range of 0.5-2 mL/min, the minimum volume of solvent was at 400 µL level.

High-temperature separations on a polymer-coated fibrous stationary phase in microcolumn liquid chromatography

Novel polymer-coated fiber-packed microcolumns in liquid chromatography (LC) have been developed. Typical polymeric materials, such as polydimethylsiloxane and polyethyleneglycol, which are conventional stationary phases of capillary columns in gas chromatography (GC), have been employed as coating materials onto the surface of fine filaments. Packed longitudinally with a bundle of polymer-coated filaments into a stainless-steel capillary of 0.8 mm i.d., 150 mm length, several types of polymer-coated fiber-packed columns were prepared, and the retention behavior of aromatic compounds on these columns has been studied. A good linear relationship was obtained for van't Hoff plots over the temperature range between 0 and 200 °C, clearly indicating an excellent heat-resistant property of these polymer-coated fibrous stationary phases. Taking advantage of the heat-resistant feature of the fibrous stationary phases, the separation of several test mixtures with temperature-programmed elution was studied, where a solvent gradient program was additionally introduced if needed. Separation was also carried out with pure water as the mobile phase using an appropriate temperature program.