Sorbent trapping solid-phase microextraction of fragrance allergens in indoor air

Analytical Determination of Allergenic Fragrances in Indoor Air

Among all the emerging contaminants, fragrances are gaining more relevance for their proven allergenic and, in some cases, endocrine-disrupting properties. To date, little information exists on their concentration in the air. This study aims to fill this gap by developing a method for the determination of semivolatile fragrances in the indoor gaseous phase with sampling protocols usually adopted for the collection of atmospheric particulate matter (sampling time 24 h, flow rate 10 L min−1) and instrumental analysis by gas chromatography coupled with mass spectrometry. The method was developed on 66 analytes and tested at three concentration levels: 20 compounds showed analytical recoveries ≥72% with percentage standard deviations always better than 20%. For most compounds, negligible sampling breakthroughs were observed. The method was then applied to real samples collected in a coffee bar and in a private house. Considering the fragrances for which the method has shown good effectiveness, the highest concentrations were observed for carvone in the coffee bar (349 ng m−3) and camphor in the house (157 ng m−3). As concerns certain or suspected endocrine disruptors, lilyal and galaxolide were detected at both sites, α-isomethylionone was the second most concentrated compound in the house (63.2 ng m−3), musk xylene and musk ketone were present at lower concentration (≈ 1 or 2 ng m−3).

Determination of Droplet-Bound and Free Gas-Phase Fragrances Using a Filter-Incorporated Needle-Trap Device and Solid-Phase Microextraction Technologies

Some of the fragrance compounds in aerosols tend to remain trapped inside the droplets. The ability to capture these droplets would make it possible to desorb and transfer the analytes dissolved within for determination. In this study, we design a novel filter-incorporated needle-trap device and use it to capture fragrance compounds in droplets as well as the gas phase of seven aerosol spray samples. For comparison, thin-film and solid-phase microextraction were also employed to extract gas-phase-borne fragrances from the same sprays. The results revealed that the filter-incorporated needle-trap device enables the extraction of total concentrations due to its ability to trap fragrance-containing droplets, whereas thin-film and solid-phase microextraction are only able to extract unbound compounds present in the gas phase. In addition, the developed needle-trap device provided acceptable results, proving its applicability for the analysis of aroma in other samples, such as beer and soda.

Analysis of volatile organic compounds in indoor environments using thermal desorption with comprehensive two-dimensional gas chromatography and high-resolution time-of-flight mass spectrometry

Building-related health effects are frequently observed. Several factors have been listed as possible causes including temperature, humidity, light conditions, presence of particulate matter, and microorganisms or volatile organic compounds. To be able to link exposure to specific volatile organic compounds to building-related health effects, powerful and comprehensive analytical methods are required. For this purpose, we developed an active air sampling method that utilizes dual-bed tubes loaded with TENAX-TA and Carboxen-1000 adsorbents to sample two parallel air samples of 4 L each. For the comprehensive volatile organic compounds analysis, an automated thermal desorption comprehensive two-dimensional gas chromatography high-resolution time-of-flight mass spectrometry method was developed and used. It allowed targeted analysis of approximately 90 known volatile organic compounds with relative standard deviations below 25% for the vast majority of target volatile organic compounds. It also allowed semiquantification (no matching standards) of numerous nontarget air contaminants using the same data set. The nontarget analysis workflow included peak finding, background elimination, feature alignment, detection frequency filtering, and tentative identification. Application of the workflow to air samples from 68 indoor environments at a large hospital complex resulted in a comprehensive volatile organic compound characterization, including 178 single compounds and 13 hydrocarbon groups.

Effects by inhalation of abundant fragrances in indoor air - An overview

Odorous compounds (odors) like fragrances may cause adverse health effects. To assess their importance by inhalation, we have reviewed how the four major abundant and common airborne fragrances (α-pinene (APN), limonene (LIM), linalool (LIL), and eugenol (EUG)) impact the perceived indoor air quality as odor annoyance, sensory irritation and sensitization in the airways. Breathing and cardiovascular effects, and work performance, and the impact in the airways of ozone-initiated gas- and particle phase reactions products have also been assessed. Measured maximum indoor concentrations for APN, LIM and LIL are close to or above their odor thresholds, but far below their thresholds for sensory irritation in the eyes and upper airways; no information could be traced for EUG. Likewise, reported risk values for long-term effects are far above reported indoor concentrations. Human exposure studies with mixtures of APN and LIM and supported by animal inhalation models do not support sensitization of the airways at indoor levels by inhalation that include other selected fragrances. Human exposure studies, in general, indicate that reported lung function effects are likely due to the perception rather than toxic effects of the fragrances. In general, effects on the breathing rate and mood by exposure to the fragrances are inconclusive. The fragrances may increase the high-frequency heart rate variability, but aerosol exposure during cleaning activities may result in a reduction. Distractive effects influencing the work performance by fragrance/odor exposure are consistently reported, but their persistence over time is unknown. Mice inhalation studies indicate that LIM or its reaction mixture may possess anti-inflammatory properties. There is insufficient information that ozone-initiated reactions with APN or LIM at typical indoor levels cause airway effects in humans. Limited experimental information is available on long-term effects of ozone-initiated reaction products of APN and LIM at typical indoor levels.

Application of a β-cyclodextrin/graphene oxide-modified fiber for solid-phase microextraction of six fragrance allergens in personal products

A novel β-cyclodextrin/graphene oxide-coated SPME fiber was prepared and used for extraction of fragrance allergens in personal products.

Ozone-initiated terpene reaction products in five European offices: replacement of a floor cleaning agent

Cleaning agents often emit terpenes that react rapidly with ozone. These ozone-initiated reactions, which occur in the gas-phase and on surfaces, produce a host of gaseous and particulate oxygenated compounds with possible adverse health effects in the eyes and airways. Within the European Union (EU) project OFFICAIR, common ozone-initiated reaction products were measured before and after the replacement of the regular floor cleaning agent with a preselected low emitting floor cleaning agent in four offices located in four EU countries. One reference office in a fifth country did not use any floor cleaning agent. Limonene, α-pinene, 3-carene, dihydromyrcenol, geraniol, linalool, and α-terpineol were targeted for measurement together with the common terpene oxidation products formaldehyde, 4-acetyl-1-methylcyclohexene (4-AMCH), 3-isopropenyl-6-oxo-heptanal (IPOH), 6-methyl-5-heptene-2-one, (6-MHO), 4-oxopentanal (4-OPA), and dihydrocarvone (DHC). Two-hour air samples on Tenax TA and DNPH cartridges were taken in the morning, noon, and in the afternoon and analyzed by thermal desorption combined with gas chromatography/mass spectrometry and HPLC/UV analysis, respectively. Ozone was measured in all sites. All the regular cleaning agents emitted terpenes, mainly limonene and linalool. After the replacement of the cleaning agent, substantially lower concentrations of limonene and formaldehyde were observed. Some of the oxidation product concentrations, in particular that of 4-OPA, were also reduced in line with limonene. Maximum 2 h averaged concentrations of formaldehyde, 4-AMCH, 6-MHO, and IPOH would not give rise to acute eye irritation-related symptoms in office workers; similarly, 6-AMCH, DHC and 4-OPA would not result in airflow limitation to the airways.

Development and application of chemometric-assisted dispersive liquid-liquid microextraction for the determination of suspected fragrance allergens in water samples

A simple and green method based on dispersive liquid-liquid microextraction, mated to chemometrics and followed by mass spectrometric detection for the determination of suspected fragrance allergens in water samples is developed and assessed in this work. Volume of extraction and disperser solvent, pH, ionic strength, extraction time, sample volume, as well as centrifugation time were initially optimized in a fractional factorial design. The obtained significant factors were optimized by using a central composite design and the quadratic model between the dependent and the independent variables was built. The obtained optimal conditions were: aqueous sample of 3.8 mL, 100 μL chloroform, 1.40 mL acetone, 4 min centrifugation time, natural pH containing 5% (w/v) NaCl, and centrifugation speed 4000 rpm. Method proved to be linear over a wide range of concentration for all analytes with R(2) between 0.9807 and 0.9959. The repeatability and reproducibility of the proposed method, expressed as relative standard deviation, varied between 3-13% and 4-16%, respectively. The limits of detection ranged from 0.007 to 1.0 μg L(-1) . The recommended method was applied to water samples including baby bath as well as swimming pool water samples and was compared with a previously reported method.

Considerations on the application of miniaturized sample preparation approaches for the analysis of organic compounds in environmental matrices

The miniaturization and improvement of sample preparation is a challenge that has been fulfilled up to a point in many fields of analytical chemistry. Particularly, the hyphenation of microextraction with advanced analytical techniques has allowed the monitoring of target analytes in a vast variety of environmental samples. Several benefits can be obtained when miniaturized techniques such as solid-phase microextraction (SPME) or liquid-phase microextraction (LPME) are applied, specifically, their easiness, rapidity and capability to separate and pre-concentrate target analytes with a negligible consumption of organic solvents. In spite of the great acceptance that these green sample preparation techniques have in environmental research, their full implementation has not been achieved or even attempted in some relevant environmental matrices. In this work, a critical review of the applications of LPME and SPME techniques to isolate and pre-concentrate traces of organic pollutants is provided. In addition, the influence of the environmental matrix on the effectiveness of LPME and SPME for isolating the target organic pollutants is addressed. Finally, unsolved issues that may hinder the application of these techniques for the extraction of dissolved organic matter from environmental samples and some suggestions for developing novel and less selective enrichment and isolation procedures for natural organic matter on the basis of SPME and LPME are included.

Multicomponent analytical methodology to control phthalates, synthetic musks, fragrance allergens and preservatives in perfumes

A simple, fast, robust and reliable multicomponent analytical method applicable in control laboratories with a high throughput level has been developed to analyze commercial brands of perfumes. Contents of 52 cosmetic ingredients belonging to different chemical families can be determined in a single run. Instrumental linearity, precision of the method and recovery studies in real samples showed excellent results, so that quantification by external calibration can be effectively applied. Relevant limits of detection and quantification were obtained for all the targets considered, far below the legal requirements and amply adequate for its accurate analytical control. A survey of 70 commercial perfumes and colognes has been performed, in order to verify whether these products complied with the recent changes in European legislation: regarding the maxima allowed concentrations of the ingredients and/or ingredient labelling. All samples contained some of the target ingredients. Several samples do not comply with the regulations concerning the presence of phthalates. Musks data confirmed the trend about the replacement of nitromusks by polycyclic musks; as well as the noticeable introduction of macrocyclic musks in the perfumes composition. The prohibited musk moskene has been detected in one sample in an appreciable concentration. The average number of fragrance allergens is twelve per sample; their presence must be indicated in the list of ingredients when its concentration exceeds the 0.001%, but values higher than 1% have been found in some samples. Preservatives data show that parabens, although ubiquitous in other cosmetic products, are not widely used in perfumery. In contrast, the presence of BHT is indeed widespread. The degree of compliance with the European Regulation on the labelling has been evaluated in a subset of samples, and only about the 38% of the perfumes were properly labelled for the allergens tested.

Development of a solid phase dispersion-pressurized liquid extraction method for the analysis of suspected fragrance allergens in leave-on cosmetics

A new method based on solid phase dispersion-pressurized liquid extraction (PLE) followed by gas chromatography-mass spectrometry (GC-MS) has been developed for the determination of 26 suspected fragrance allergens (all the regulated in the EU Cosmetics Directive amenable by GC, as well as pinene and methyleugenol) in cosmetic samples. The effects of the temperature, extraction time and solvent, and dispersing sorbent, affecting the whole proposed procedure, have been evaluated using a multifactor strategy. The optima conditions after the analysis of main and second order effects entailed the extraction at 120°C for 15 min, using hexane/acetone as solvent, and florisil as dispersing sorbent. The method performance has been studied, showing good linearity (R≥0.996) as well as good precision (RSD≤10%). Detection limits (S/N=3) ranged from 0.000001 to 0.0002% (w/w), values far below the established restrictions as regard labelling in the European Cosmetics Regulation. Reliability was demonstrated through the quantitative recoveries of all the studied compounds. The absence of matrix effects allowed quantification of the compounds by calibration with standard solutions. The analysis of 10 samples (several moisturizing and anti-wrinkle creams and lotions, hand creams, and sunscreen and after-sun creams), covering very different matrices, showed the presence of suspected allergens in all the analyzed samples; in fact, half of the samples contained an elevated number of them. Although the ubiquity of these compounds was demonstrated, labelling was in all cases in consonance with the European Cosmetics Regulation.