Novel amphiphiles with preorganized functionalities-formation of Langmuir-films and efficiency in mineral flotation

Monolayer formed by l-Asp-based gemini surfactants self-assembled in 1D nanostructures

Herein, studies on the surface activities of newly synthesized l-Asp-based gemini surfactants, both nonionic and anionic, are presented. Conductometry, tensiometry, and the Langmuir-Blodgett (LB) film technique were applied for this purpose. π-A isotherms were obtained with a Langmuir trough and Wilhelmy balance. The structures of the monolayers assembled at the air/water interface and those deposited as LB films were studied via Brewster angle microscopy (BAM) and atomic force microscopy (AFM). The 2D films formed by the anion-active compounds show a well-known pattern of a monolayer film, whereas the nonionogenic amphiphiles have been found to be 1D structures with nano-widths and micro-lengths that align with each other during the process of compression; this is the first study where the organization of 1D fibrils in 2D films during compression is reported. The scanning electron microscopy (SEM) study reveals that 1D nanostructure formation is an intrinsic tendency of these molecules as not only nonionogenic surfactants, but also the anion active representatives have been constructed in the solid state by fibrillary structures.

Gemini surfactants from natural amino acids

In this review, we report the most important contributions in the structure, synthesis, physicochemical (surface adsorption, aggregation and phase behaviour) and biological properties (toxicity, antimicrobial activity and biodegradation) of Gemini natural amino acid-based surfactants, and some potential applications, with an emphasis on the use of these surfactants as non-viral delivery system agents. Gemini surfactants derived from basic (Arg, Lys), neutral (Ser, Ala, Sar), acid (Asp) and sulphur containing amino acids (Cys) as polar head groups, and Geminis with amino acids/peptides in the spacer chain are reviewed.

Synthesis, characterization, adsorption, and interfacial rheological properties of four-arm anionic fluorosurfactants

Four-arm oligo(fluorooxetane) tetraols containing -CF3 and -C2F5 groups were prepared in reasonable yields by cationic, ring-opening polymerization of fluorinated oxetane monomers using a tetrafunctional, alkoxylated polyol as initiator and BF3.THF as catalyst. The tetraols were then converted to ammonium sulfate salts using oleum followed by neutralization with ammonium hydroxide in excellent yields. The four-arm oligo(fluorooxetane) sulfates (1=-CF3, 2=-C2F5) have an architecture characterized by a hydrophobic core of oligo(fluorooxetane) arms with a hydrophilic sulfate shell and initiator. The four-arm anionic oligo(fluorooxetane)s are surface active with critical micelle concentration values approximately 4.2x10(-6) and 2.4x10(-6) mol/L for 1 and 2, respectively. Surface tension isotherms in pH 8 buffered solution were measured and data fitted parametrically to the Davies surface tension isotherm equation. Molecular areas at saturation were estimated to be approximately 89 and approximately 85 A2 with DeltaGads=-12.7 and -13.2 kcal/mol for 1 and 2, respectively. The results are compared to two-arm, bolaamphiphilic analogues of 1 and 2 and a small molecule, long perfluoroalkyl-chain (-C8F17), anionic fluorosurfactant (Kausch, C. M.; Kim, Y.; Russell, V. M.; Medsker, R. E.; Thomas, R. R. Langmuir 2003, 19, 7182). Dynamic surface tension data for 1 and 2 were analyzed using the Ward-Tordai mass transport equation to yield concentration-dependent diffusion coefficients. In the concentration range approximately 10(-6) mol/L, diffusion coefficients were estimated to be approximately 1-3x10(-5) cm2/s. Dilational interfacial rheological parameters for 1 and 2 were measured. Values of |E| and E' were found to be larger than those of the two-arm analogues of the same perfluoroalkyl chain length while E' 'and phi were found to be smaller. The magnitude of these values reflects the difference in adsorption strength and mass transport and/or relaxation between the two different architectures.

Regulation of Aggregation and Morphology of Cyanine Dyes on Monolayers via Gemini Amphiphiles

The aggregation of dyes is of considerable importance in relating to their functions and applications. In this paper, we have investigated the regulation on the aggregation and morphology of two cyanine dyes, 3,3'-disulfopropyl-4,5,4',5'-dibenzo-9-methylthiacarbocyanine triethylammonium salt (MTC) and 3,3'-disulfopropyl-4,5,4',5'-dibenzo-9-phenylthiacarbocyanine triethylammonium salt (PTC), using a series of gemini amphiphiles (bis(2'-heptadecyl-3'-ethylimidazolium)-1,n-alkane dibromide, abbreviated as Gn, n=2, 4, 6, 8, 10). It has been found that both of the dyes could be adsorbed onto the monolayers of the gemini amphiphiles through the electrostatic and pi-pi interaction and stacked into H- or J-aggregate. The spacer of the gemini amphiphile showed good control over the aggregation of MTC: H-aggregate was favored when gemini amphiphiles with short spacer were applied, while J-aggregation was preferred in the case of longer spacer. Only J-aggregate was observed for PTC on gemini monolayer, regardless of the structure of the gemini amphiphiles. Interesting morphologies were observed for all the gemini/dye complex monolayers. Network structure and nanofibers were formed for the gemini/MTC films transferred below the plateau surface pressure and close to the collapse pressure, respectively. The ability of the complex monolayers to form nanofibers strongly depended on the component amphiphiles, G2>G4>G6, and no nanofibers were observed for G8/MTC and G10/MTC after the collapse. Only squared domains were observed for gemini/PTC monolayers. When both G2 and G10 were mixed, an individual control of the gemini amphiphiles over the aggregation of MTC in the complex monolayers was observed. The relationship among the spacer, dye structure, and aggregation was revealed.

Design and Interfacial Assembly of a New Series of Gemini Amphiphiles with Hydrophilic Poly(ethyleneamine) Spacers

A new series of gemini amphiphiles containing two Schiff base moieties linked by the poly(ethyleneamine) with different lengths were designed, and their interfacial assemblies were investigated. Condensed monolayers were obtained on nearly neutral subphase where the hydrophilic spacers were found to immerse into the subphase. On strong alkaline and acidic subphase, the headgroup and the spacer of the gemini amphiphiles underwent dissociation and protonation, respectively, resulting in the enlargement of the molecular areas. Flat and uniform domains were obtained for the monolayers from nearly neutral subphase; flower-like or dendritic domains were observed for the films transferred from strong acidic subphase. On the other hand, when an anionic tetrakis(4-sulfonatonphenyl)porphine (TPPS) was added into an acidic subphase, an in situ complex formation between the gemini amphiphiles and TPPS occurred. The complex monolayers were transferred onto solid substrate and TPPS existed predominantly as J-aggregate in the complex films. Due to the multisited positive charges in the spacer on acidic subphase, the complex films of gemini amphiphiles with TPPS appeared as short fiber or nanorod structures and formed two-dimensional (2D) conglomerate chiral domains.