Estimation of two wear factors for total hip arthroplasty: A simulation study based on musculoskeletal modelling

Liner orientation change of dual mobility cup determined via 3D ultrasound imaging and motion analysis: A cadaver study

BACKGROUND

A mobile polyethylene liner enables the dual mobility cup (DMC) to contribute to restoring hip joint range-of-motion, decreasing wear and increasing implant stability. However, more data is required on how liner orientation changes with hip joint movement. As a first step towards better understanding liner orientation change in vivo, this cadaver study focuses on quantifying DMC liner orientation change after different hip passive movements, using ultrasound imaging and motion analysis.

HYPOTHESIS

The liner does not always go back to its initial orientation and its final orientation depends mainly on hip movement amplitude.

METHODS

3D ultrasound imaging and motion analysis were used to define liner and hip movements for four fresh post-mortem human subjects with six implanted DMC. Abduction and anteversion angles of the liner plane relative to the pelvis were measured before and after hip flexion, internal rotation, external rotation, abduction, adduction.

RESULTS

Liner orientation changes were generally defined by angle variation smaller than 5°, with the liner nearly going back to its initial orientation. However, hip flexion caused liner abduction and anteversion angle variations greater than 15°. Except for hip adduction, only weak or no correlation was found between the final angle of the liner and the maximal hip joint movement amplitude.

DISCUSSION

This study is the first attempt to quantify liner orientation change for implanted DMC via ultrasound imaging and constitutes a step forward in the understanding of liner orientation change and its relationship with hip joint movement. The hypothesis that the final liner abduction and anteversion angles depend mainly on hip movement amplitude was not confirmed, even if hip flexion was the movement generating the most liner orientation changes over 15°. This approach should be extended to in vivo clinical investigations, as measured liner angle variation could provide important support for the wear and stability claims made for DMC.

LEVEL OF EVIDENCE

IV; cadaveric study.

Quantification of soft tissue artifacts using CT registration and subject-specific multibody modeling

The potential use of gait analysis for quantitative preoperative planning in total hip arthroplasty (THA) has previously been demonstrated. However, the joint kinematic data measured through this process tend to be unreliable for surgical planning due to distortions caused by soft tissue artifacts (STAs). In this study, we developed a novel motion capture framework by combining computed tomography (CT)-based postural calibration and subject-specific multibody dynamics modeling to prevent the effect of STAs in measuring hip kinematics. Three subjects with femoroacetabular impingement syndrome were recruited, and CT data for each patient were collected by attaching marker clusters near the hip. A subject-specific multibody hip joint model was developed based on reconstructed CT data. Spring-dashpot network calculations were performed to minimize the distance between the anatomical landmark and its corresponding infrared reflective marker. The STAs of the thigh was described as six degrees of freedom viscoelastic bushing elements, and their parameter values were identified via smooth orthogonal decomposition. Least squares optimization was used to modify the pelvic rotations to compensate for the rigid components of STAs. The results showed that CT-assisted motion tracking enabled the successful identification of STA influences in gait and squat positions. Furthermore, STA effects were found to alter maximal pelvis tilt and hip rotations during a squat. Compared to other techniques, such as dual fluoroscopic imaging, the adopted framework does not require additional medical imaging for patients undergoing robot-assisted THA surgery and is thus a practical way of evaluating hip joint kinematics for preoperative surgical planning.