Effect of an amino acid on the surface phase behavior of n-hexadecyl phosphate in Gibbs adsorption layers

New methodology to determine equilibrium surfactant adsorption properties from experimental dynamic surface tension data

In this paper, we explore a novel approach to predict equilibrium adsorption properties from experimental dynamic surface tension (DST) data and the known rate-limiting adsorption kinetics mechanism, an approach that has never been pursued in the DST literature. Specifically, we develop a new methodology to predict the equilibrium surface tension versus surfactant bulk solution concentration (ESTC) behavior of nonionic surfactants from experimental DST data when the adsorption kinetics rate-limiting mechanism is diffusion controlled. The new methodology requires the following three inputs: (1) experimental DST data measured at a single surfactant bulk solution concentration, Cb, (2) the diffusion coefficient of the surfactant molecule, D, and (3) a single equilibrium surface tension data point, to predict the entire ESTC curve applicable over a wide range of surfactant bulk solution concentrations which are less than, or equal to, Cb. We demonstrate the applicability of the new methodology by predicting the ESTC curves of the two alkyl poly (ethylene oxide) nonionic surfactants C12E4 and C12E6, and validate the results by comparing the predictions with (a) equilibrium surface tension measurements, (b) surface-expansion measurements, and (c) pendant-bubble dynamic surface tension measurements for t<approximately 100-200 s (when the assumption of diffusive transport of surfactant molecules in the bulk solution is valid). Very good agreement is obtained between the predictions and the measurements in (a), (b), and (c) for both C12E4 and C12E6. On the basis of these results, we conclude that the new methodology presented here represents an efficient method to predict reliable ESTC curves for nonionic surfactants.

Synthesis of one-dimensional silver oxide nanoparticle arrays and silver nanorods templated by Langmuir monolayers

One-dimensional (1D) silver oxide nanoparticle arrays were synthesized by illuminating the composite Langmuir-Blodgett monolayers of porphyrin derivatives/Ag(+) and n-hexadecyl dihydrogen phosphate (n-HDP)/Ag(+) deposited on carbon-coated copper grids with daylight and then exposing them to air. Transmission electron microscopy (TEM) observation shows that the nanoparticle size is around 3 nm, with the separation of about 2-3 nm. High-resolution TEM (HRTEM) investigation indicates that the particles are made up of Ag(2)O. Ag nanorods with the width of 15-35 nm and the length of several hundreds of nanometers were synthesized by irradiating the composite Langmuir monolayers of porphyrin derivatives/Ag(+) and n-HDP/Ag(+) by UV-light directly at the air/water interface at room temperature. HRTEM image and selected-area electron diffraction (SAED) pattern indicate that the nanorods are single crystals with the (110) face of the face-centered cubic (fcc) silver parallel to the air/water interface. The formation of the 1D arrays and the nanorods should be attributed to the templating effect of the linear supramolecules formed by porphyrin derivative or n-HDP molecules in Langmuir monolayers through non-covalent interactions.

New methodology to determine the rate-limiting adsorption kinetics mechanism from experimental dynamic surface tension data

We present a new methodology to determine the rate-limiting adsorption kinetics mechanism (diffusion-controlled vs mixed diffusion-barrier controlled), including deducing the kinetics parameters (the diffusion coefficient, D, and the energy-barrier parameter, beta), from the experimental short-time dynamic surface tension (DST) data. The new methodology has the following advantages over the existing procedure used to analyze the experimental DST data: (a) it does not require using a model for the equilibrium adsorption isotherm, and (b) it only requires using the experimental short-time DST data measured at two initial surfactant bulk solution concentrations. We apply the new methodology to analyze the experimental short-time DST data of the following alkyl poly(ethylene oxide), CiEj, nonionic surfactants: C12E4, C12E6, C12E8, and C10E8 measured using the pendant-bubble apparatus. We find that for C12E4 and C12E6, the effect of the energy barrier on the overall rate of surfactant adsorption can be neglected for surfactant bulk solution concentrations below their respective critical micelle concentrations (CMCs), and therefore, that the rate-limiting adsorption kinetics mechanism for C12E4 and C12E6 is diffusion-controlled at any of their premicellar surfactant bulk solution concentrations. On the other hand, for C12E8 and C10E8, we find that their respective CMC values are large enough to observe a significant effect of the energy barrier on the overall rate of surfactant adsorption. In other words, for C12E8 and C10E8, the rate-limiting adsorption kinetics mechanism shifts from diffusion-controlled to mixed diffusion-barrier controlled as their premicellar surfactant bulk solution concentrations increase. We test the new methodology by predicting the short-time DST profiles at other initial surfactant bulk solution concentrations, and then comparing the predicted DST profiles with those measured experimentally. Very good agreement is obtained for the four CiEj nonionic surfactants considered. We also compare the results of implementing the new methodology with those of implementing the existing procedure, and conclude that using a model for the equilibrium adsorption isotherm can lead not only to different values of D and beta, but it can also lead to a completely different determination of the rate-limiting adsorption kinetics mechanism. Since the new methodology proposed here does not require using a model for the equilibrium adsorption isotherm, we conclude that it should provide a more reliable determination of the rate-limiting adsorption kinetics mechanism, including the deduced kinetics parameters, D and beta.