Coagulation and charging of latex particles in the presence of imogolite

The heteroaggregation behavior of nanoplastics on goethite: Effects of surface functionalization and solution chemistry

Nanoplastics have attracted extensive attention in recent years. However, little is known about the heteroaggregation behavior of nanoplastics on goethite (FeOOH), especially the contribution of surface functional groups. In this study, the heteroaggregation behavior between polystyrene nanoplastics (PSNPs) and FeOOH was systematically investigated under different reaction conditions. Moreover, the effect of different functional groups (-NH₂, -COOH, and bare) of PSNPs and solution chemistry was evaluated. The results showed that PSNPs could heteroaggregate with FeOOH, and the heteroaggregation rate of PSNPs with surface functionalization was significantly faster. The removal of suspended PSNPs was enhanced with increasing NaCl or CaCl₂ concentration. However, heteroaggregation was significantly inhibited with the increase of solution pH. The zeta potentials analysis, time-resolved dynamic light scattering (DLS) and heteroaggregation experiments suggested that the electrostatic force affected the heteroaggregation process significantly. Fourier transform infrared (FTIR) spectra proved that the adsorption affinity between PSNPs and FeOOH was stronger after surface functionalization, especially for CH, O-C=O, and -CH₂- groups, indicating that chemical bonding also made a contribution during the heteroaggregation process. This work is expected to provide a theoretical basis for predicting the environmental behavior between PSNPs and FeOOH.

Influence of typical clay minerals on aggregation and settling of pristine and aged polyethylene microplastics

Microplastics (MPs) are emerging as a class of pollutants that are a potential threat to biological and human health. Aggregation and settling are crucial to controlling MPs transport and environmental fate. However, the influence of clay minerals in the aqueous environment on the aggregation-settling processes of larger size MPs and its mechanisms remain unclear. In this study, homoaggregation of pristine and aged polyethylene microplastics (PEs) and heteroaggregation-settling of PEs with typical clay minerals (chlorite, illite, kaolinite, montmorillonite) under different hydrochemical conditions (NaCl, CaCl₂, MgCl₂) were systematically investigated. The results showed that the cation type has a greater influence on the homoaggregation system. In detail, the aged PEs is more stable than pristine PEs in monovalent electrolyte solutions, but not in divalent electrolytes. In heteroaggregation systems, electrostatic repulsion dominates the interaction of PEs (pristine, aged) with clay minerals. However, the settling ratio of PEs (pristine, aged) contributed by clay minerals is not very dependent on the clay mineral type. Conversely, high NaCl concentrations are more conducive to the heteroaggregation-settling of PEs, which can be explained by the DLVO theory. The findings of this study provide new insights into the environmental fate and distribution of MPs in natural waters.

Sepiolite-Hydrogels: Synthesis by Ultrasound Irradiation and Their Use for the Preparation of Functional Clay-Based Nanoarchitectured Materials

Sepiolite and palygorskite fibrous clay minerals are 1D silicates featuring unique textural and structural characteristics useful in diverse applications, and in particular as rheological additives. Here we report on the ability of grinded sepiolite to generate highly viscous and stable hydrogels by sonomechanical irradiation (ultrasounds). Adequate drying of such hydrogels leads to low-density xerogels that show extensive fiber disaggregation compared to the starting sepiolite—whose fibers are agglomerated as bundles. Upon re-dispersion in water under high-speed shear, these xerogels show comparable rheological properties to commercially available defibrillated sepiolite products, resulting in high viscosity hydrogels that minimize syneresis. These colloidal systems are thus very interesting as they can be used to stabilize many diverse compounds as well as nano-/micro-particles, leading to the production of a large variety of composites and nano/micro-architectured solids. In this context, we report here various examples showing how colloidal routes based on sepiolite hydrogels can be used to obtain new heterostructured functional materials, based on their assembly to solids of diverse topology and composition such as 2D and 1D kaolinite and halloysite aluminosilicates, as well as to the 2D synthetic Mg,Al-layered double hydroxides (LDH).

Characterization of volcanic ash nanoparticles and study of their fate in aqueous medium by asymmetric flow field-flow fractionation-multi-detection

Dimensional and elemental characterization of environmental nanoparticles is a challenging task that requires the use of a set of complementary analytical methods. Asymmetric flow field-flow fractionation coupled with UV-Vis, multi-angle laser light scattering and ICP-MS detection was applied to study the nanoparticle fraction of a volcanic ash sample, in a Milli-Q water suspension at pH 6.8. It has been shown that the separated by sedimentation nanoparticle fraction of the Klyuchevskoy volcano ash suspension contains 3 polydisperse populations for which size ranges (expressed in gyration radius, rG), hydrodynamic behaviours (evaluated via shape index) and elemental compositions are different. These 3 populations did not dissolve over the 72-h study but aggregated and settled out differently. Thus, the population of particles with gyration radii <140 nm (P1), which contained 6% Al₂O₃ and represented approximately 20% by mass of the nanoparticle fraction, remained in suspension without observable aggregation. The populations P2 and P3, which represented 67% and 13% by mass in the initial suspension, covered the rG range 25-250 nm and contained 17% and 15% Al₂O₃, respectively. Over time, populations P2 and P3 aggregated and their concentration in suspension at 72 h decreased by approximately 40% compared with the initial suspension. The decrease of these nanoparticle populations occurred either from the beginning of the temporal monitoring (P2) or after 30 h (P3). Aggregation generated a new population (P4) in suspension with rG up to 300 nm and mostly consisting of P2. This population represented only up to 6 to 7% of the nanoparticle fraction and decreased beyond 50 h. As a result, the trace elements present in the nanoparticle fraction and monitored (Cu and La) were also no longer found in the suspension. The results obtained can offer additional insights into the fate of volcanic ash nanoparticles in the environment.

Application of Poly-γ-Glutamic Acid Flocculant to Flocculation–Sedimentation Treatment of Ultrafine Cement Suspension

We examined the effect of poly-γ-glutamic acid flocculant (PGAF) on the removal of ultrafine cement (UFC) particles stabilized by a poly-carboxylate co-polymer, which is a superplasticizer (SP). The flocculation–sedimentation treatment with PGAF successfully removed the SP-stabilized cement particles through the gravitational settling of the formed flocs. The removal efficiency reduced with the increase in the ionic strength, probably because of the shrunk form of poly-γ-glutamic acid (γ-PGA) at high ionic strengths. Increasing the mixing intensity during rapid mixing improved the removal efficiency. A series of flocculation–sedimentation experiments provided a diagram showing the relationship between ionic strengths and the addition amount of PGAF. Our results suggest that PGAF is a good candidate for the purification of cement suspension by flocculation–sedimentation, and a better removal performance can be obtained at lower ionic strengths with intense rapid mixing. From the diagram of the control charts presented in this study, we can determine the optimal addition amount of PGAF for achieving the target removal rate for cement suspension under any ionic strength.

Design of latex-layered double hydroxide composites by tuning the aggregation in suspensions

Colloidal stability of polymeric latex particles was studied in the presence of oppositely charged layered double hydroxide (LDH) platelets of different interlayer anions. Adsorption of the LDH particles led to charge neutralization and to overcharging of the latex at appropriate concentrations. Mixing stable colloidal suspensions of individual particles results in rapid aggregation once the LDH adsorption neutralizes the negative charges of the polymer spheres, while stable suspensions were observed at high and low LDH doses. The governing interparticle interactions included repulsive electrical double layer forces as well as van der Waals and patch-charge attractions, whose strength depended on the amount of LDH particles adsorbed on the latex surface. The type of the LDH interlayer anions did not affect the colloidal stability of the samples. Structural investigation of the obtained latex-LDH composites revealed that the polymer spheres were completely coated with the inorganic platelets once their concentration was sufficiently high. These results are especially important for designing synthetic routes for hybrid systems in suspensions, where stable colloids are required for uniform film-formation and for the homogeneous distribution of the inorganic filler within the composite materials.