Micelle controlled release of 5-fluorouracil: Follow the guideline for good polymer–drug compatibility

Synergistic anticancer effect of Pistacia lentiscus essential oils and 5-Fluorouracil co-loaded onto biodegradable nanofibers against melanoma and breast cancer

Chemoresistance and severe toxicities represent major drawbacks of chemotherapy. Natural extracts, including the essential oils of Pistacia lentiscus (PLEO), exhibit substantial anticancer and anti-inflammatory activities where different cancers are reported to dramatically recess following targeting with PLEO. PLEO has promising antimicrobial, anticancer, and anti-inflammatory properties. However, the therapeutic properties of PLEO are restricted by limited stability, bioavailability, and targeting ability. PLEO nanoformulation can maximize their physicochemical and therapeutic properties, overcoming their shortcomings. Hence, PLEO was extracted and its chemical composition was determined by GC-MS. PLEO and 5-Fluorouracil (5FU) were electrospun into poly-ε-caprolactone nanofibers (PCL-NFs), of 290.71 nm to 680.95 nm diameter, to investigate their anticancer and potential synergistic activities against triple-negative breast cancer cells (MDA-MB-231), human adenocarcinoma breast cancer cells (MCF-7), and human skin melanoma cell line (A375). The prepared nanofibers (NFs) showed enhanced thermal stability and remarkable physical integrity and tensile strength. Biodegradability studies showed prolonged stability over 42 days, supporting the NFs use as a localized therapy of breast tissues (postmastectomy) or melanoma. Release studies revealed sustainable release behaviors over 168 h, with higher released amounts of 5FU and PLEO at pH 5.4, indicating higher targeting abilities towards cancer tissues. NFs loaded with PLEO showed strong antioxidant properties. Finally, NFs loaded with either PLEO or 5FU depicted greater anticancer activities compared to free compounds. The highest anticancer activities were observed with NFs co-loaded with PLEO and 5FU. The developed 5FU-PLEO-PCL-NFs hold potential as a local treatment of breast cancer tissues (post-mastectomy) and melanoma to minimize their  possible recurrence.

Layered double hydroxides - poloxamer 188 nanocomposites based on exfoliation reassembling for improved cellular uptake and controlled delivery of methotrexate

Exploitation of advanced methotrexate (MTX) delivery with nanocomposites has important clinical application value. Poloxamer 188 micelle and layered double hydroxide loaded with MTX (LDH-MTX) by exfoliation reassembling were used to prepare LDH-MTX-poloxamer 188 nanocomposites with good dispersibility and efficient cellular uptake for controlled drug delivery. The LDH-MTX-poloxamer 188 nanocomposites with sphere-like morphology, of which the average hydrodynamic diameter was <100 nm, were shown to have better dispersion state than naked LDH-MTX. Importantly, the LDH-MTX-poloxamer 188 nanocomposites could achieve significant sustained drug release and have obvious pH dependent responsive release ability. In addition, these nanocomposites also exhibited long-term and excellent in vitro antitumor efficacy as opposed to pure MTX or LDH-MTX as evident from cell viability. More interestingly, compared to pure FITC used to simulate MTX, LDH nanocomposites labeled with FITC were considered to have better cell adhesion through cell uptake. Therefore, the studied nanocomposites of LDH-MTX-poloxamer 188 can be further used as a new advanced MTX delivery nanovehicles with desired properties in future therapeutic aspects.

5-fluorouracil-caffeic acid cocrystal delivery agent with long-term and synergistic high-performance antitumor effects

Aim: To explore how to transform cocrystals of the anticancer drug 5-fluorouracil (FL) with caffeic acid (CF; FL-CF-2H₂O) into a nanoformulation, a self-assembly strategy of cocrystal-loaded micelles is proposed. Methods: Nanomicelles were assembled to deliver cocrystal FL-CF-2H₂O with synergistic activity, and their in vitro/vivo properties were evaluated by combining theoretical and experimental methods. Result: More cocrystal was packed into the polymers due to the stronger interaction energy during micellar assembly, producing excellent cytotoxicity and pharmacokinetic behavior, especially synergistic abilities and long-term therapy. Conclusion: This case exemplifies the particular benefits of the self-assembly strategy of cocrystal-loaded micelles in keeping a delicate balance between long-term effects and high efficiency for FL, and offers a feasible technical scheme for cocrystal delivery agents for antitumor drugs.

Rational Mitomycin Nanocarriers Based on Hydrophobically Functionalized Polyelectrolytes and Poly(lactide-co-glycolide)

Encapsulation of hydrophilic and amphiphilic drugs in appropriate colloidal carrier systems for sustained release is an emerging problem. In general, hydrophobic bioactive substances tend to accumulate in water-immiscible polymeric domains, and the release process is controlled by their low aqueous solubility and limited diffusion from the nanocarrier matrix. Conversely, hydrophilic/amphiphilic drugs are typically water-soluble and insoluble in numerous polymers. Therefore, a core-shell approach─nanocarriers comprising an internal core and external shell microenvironments of different properties─can be exploited for hydrophilic/amphiphilic drugs. To produce colloidally stable poly(lactic-co-glycolic) (PLGA) nanoparticles for mitomycin C (MMC) delivery and controlled release, a unique class of amphiphilic polymers─hydrophobically functionalized polyelectrolytes─were utilized as shell-forming materials, comprising both stabilization via electrostatic repulsive forces and anchoring to the core via hydrophobic interactions. Undoubtedly, the use of these polymeric building blocks for the core-shell approach contributes to the enhancement of the payload chemical stability and sustained release profiles. The studied nanoparticles were prepared via nanoprecipitation of the PLGA polymer and were dissolved in acetone as a good solvent and in an aqueous solution containing hydrophobically functionalized poly(4-styrenesulfonic-co-maleic acid) and poly(acrylic acid) of differing hydrophilic-lipophilic balance values. The type of the hydrophobically functionalized polyelectrolyte (HF-PE) was crucial for the chemical stability of the payload─derivatives of poly(acrylic acid) were found to cause very rapid degradation (hydrolysis) of MMC, in contrast to poly(4-styrenesulfonic-co-maleic acid). The present contribution allowed us to gain crucial information about novel colloidal nanocarrier systems for MMC delivery, especially in the fields of optimal HF-PE concentrations, appropriate core and shell building materials, and the colloidal and chemical stability of the system.

Biocompatible poly(ethylene succinate) polyester with molecular weight dependent drug release properties

In the present study, we demonstrate that well-known molecular weight-dependent solubility properties of a polymer can also be used in the field of controlled drug delivery. To prove this, poly(ethylene succinate) (PES) polyesters with polycondensation time regulated molecular weights were synthesized via catalyst-free direct polymerization in an equimolar ratio of ethylene glycol and succinic acid monomers at 185 °C. DSC and contact angle measurements revealed that increasing the molecular weight (M_w, 4.3-5.05 kDa) through the polymerization time (40-80 min) increased the thermal stability (T_m= ∼61-80 °C) and slightly the hydrophobicity (Θ_w= ∼27-41°) of the obtained aliphatic polyester. Next, this biodegradable polymer was used for the encapsulation of Ca²⁺ channel blocker Nimodipine (NIMO) to overcome the poor water solubility and enhance the bioavailability of the drug. The drug/ polymer compatibility was proved by the means of solubility (δ) and Flory-Huggins interaction (miscibility) parameters (χ). The nanoprecipitation encapsulation of NIMO into PES with increasing M_w resulted in the formation of spherical 270 ± 103 nm NIMO-loaded PES nanoparticles (NPs). Furthermore, based on the XRD measurements, the encapsulated form of NIMO-loaded PES NPs showed lower drug crystallinity, which enhanced not only the water solubility but even the water stability of the NIMO in an aqueous medium. The in-vitro drug release experiments demonstrated that the release of NIMO drug could be accelerated or even prolonged by the molecular weights of PES as well. Due to the low crystallinity of PES polyester and low particle size of the encapsulated NIMO drug led to enhance solubility and releasing process of NIMO from PES with lower M_w (4.3 kDa and 4.5 kDa) compared to pure crystalline NIMO. However, further increasing the molecular weight (5.05 kDa) was already reduced the amount of drug release that provides the prolonged therapeutic effect and enhances the bioavailability of the NIMO drug.

Mixed poly(vinyl pyrrolidone)-based drug-loaded nanomicelles shows enhanced efficacy against pancreatic cancer cell lines

We report in this paper on the enhanced efficacy of a physical mixture of two single anti-cancer loaded nanomicelles against PANC-1 and BxPC-3. Poly(vinyl pyrrolidone-b-polycaprolactone) (PVP-b-PCL) and poly(vinyl pyrrolidone-b-poly(dioxanone-co-methyl dioxanone)) (PVP-b-P(DX-co-MeDX)) were synthesized and successfully loaded with various anti-cancer drugs - gemcitabine (GEM), doxorubicin.HCl (DOX.HCl), doxorubicin.NH₂ (DOX), 5-fluorouracil (5-FU) and paclitaxel (PTX). Spherical micelles of size 160-477 nm were obtained as characterized by DLS while sizes determined by TEM were in the range 140-250 nm. The hydrophobic drugs had a higher loading percentage efficiency compared to hydrophilic drugs in the trend PTX>DOX>5-FU>GEM>DOX.HCl whereas the drug release pattern followed the reverse trend in accordance with decreased polymer-drug interaction as quantified by the binding constant and micellar drug location. Cellular uptake studies showed that nanomicelles are taken up by pancreatic cancer cells into the cytoplasm and nucleus. The free nanomicelles were confirmed to be non-cytotoxic. A physical mixture of GEM loaded micelles and DOX.HCl loaded micelles of comparable size showed significantly higher cytotoxicity than either the free drug mixture or the individual single drug loaded micelles as confirmed by their IC₅₀ values.

Amphiphilic block copolymers from a renewable ε-decalactone monomer: prediction and characterization of micellar core effects on drug encapsulation and release

Here we describe a methoxy poly(ethyleneglycol)-b-poly(ε-decalactone) (mPEG-b-PεDL) copolymer and investigate the potential of the copolymer as a vehicle for solubilisation and sustained release of indomethacin (IND). The indomethacin loading and release from mPEG-b-PεDL micelles (amorphous cores) was compared against methoxy poly(ethyleneglycol)-b-poly(ε-caprolactone)(mPEG-b-PCL) micelles (semicrystalline cores). The drug-polymer compatibility was determined through a theoretical approach to predict drug incorporation into hydrated micelles. Polymer micelles were prepared by solvent evaporation and characterised for size, morphology, indomethacin loading and release. All the formulations generated spherical micelles but significantly larger mPEG-b-PεDL micelles were observed compared to mPEG-b-PCL micelles. A higher compatibility of the drug was predicted for PCL cores based on Flory-Huggins interaction parameters (χ_sp) using the Hansen solubility parameter (HSP) approach, but higher measured drug loadings were found in micelles with PεDL cores compared to PCL cores. This we attribute to the higher amorphous content in the PεDL-rich regions which generated higher micellar core volumes. Drug release studies showed that the semicrystalline PCL core was able to release IND over a longer period (80% drug release in 110 h) compared to PεDL core micelles (80% drug release in 72 h).

Well-defined labile diselenide-centered poly(ε-caprolactone)-based micelles for activated intracellular drug release

Diselenide groups were introduced into aliphatic polyesters to develop a novel well-defined reduction-labile biodegradable diselenide-containing polymeric drug delivery system (mPEG–PCL–Se)₂.

Synthesis of functionalized Pluronic-b-poly(ε-caprolactone) and the comparative study of their pendant groups on the cellular internalization behavior

This study focuses on the synthesis of Pluronic-b-poly(ε-caprolactone) bearing benzyl-oxycarbonylmethyl and carboxylic groups and the comparative study to investigate the influence of the different pendant groups on the cellular behavior. The functionalized Pluronic-b-poly(ε-caprolactone) bearing two kinds of pendant groups are synthesized via ring-opening polymerization of ε-caprolactone and 6-(benzyl-oxycarbonyl methyl)-ε-caprolactone and followed by deprotection respectively. The structure of the copolymers is confirmed and the polymeric micelles are formed by an emulsion/solvent evaporation technique. The critical micelle concentrations are improved compared with Pluronic F127, the morphologies of the micelles are spherical with the diameter on nano scale and good colloidal stability. The copolymers have good cytocompatibility and the comparative study reveals that cellular internalization, digesting by lysosome and intracellular distribution are affected by the pendant groups, moreover, the endocytosis pathway is determined by the pendant groups. Therefore, the definite internalization mechanism is beneficial for the design of polymeric micellar carriers to achieve intra- or extracellular modes of drug delivery and provide better access to either cell membrane or intracellular organelles.

Redox-sensitive hyaluronic acid–paclitaxel conjugate micelles with high physical drug loading for efficient tumor therapy

Characterization of targeted redox-sensitive micelles self-assembled from polymer–drug conjugates exhibiting conspicuous drug loading capabilities, selective cellular uptake, rapid intracellular disassembly and drug release is presented.

Functionalized Pluronic-b-poly(ε-caprolactone) based nanocarriers of paclitaxel: solubilization, antiproliferative efficacy and in vivo pharmaceutic kinetics

Novel paclitaxel (PTX) nanocarriers were developed based on the Pluronic-based pentablock copolymer and their pharmaceutical behaviours were thoroughly evaluated.