Dielectric analysis of the [Bmim][PF6]/TX-100/ethyleneglycol nonaqueous microemulsions: Microstructures and percolation

Dielectric Depiction of 1-Butyl-3-methylimidazolium Tetrafluoroborate/1-Butyl-3-methylimidazolium 1,4-Bis(2-ethylhexyl) Sulfosuccinate/Benzene Microemulsions: Percolation, Interface Polarization, and Electrical Parameters

Two dielectric relaxations located at approximately 10 and 300 MHz were analyzed in the microemulsion composed of the polar ionic liquid (PIL) 1-butyl-3-methylimidazolium tetrafluoroborate ([bmim][BF4]), the surface-active ionic liquid (SAIL) 1-butyl-3-methylimidazolium 1,4-bis(2-ethylhexyl) sulfosuccinate ([bmim][AOT]), and benzene. The curve of the dc conductivity vs PIL weight fraction shows two inflection points, namely, 16.69 and 27.90 wt %, which are used to divide the PIL/O, bicontinuous (B.C.), and O/PIL subregions. The critical exponents of percolation u = 0.75, 0.79, and 0.80 are suggested from the scaling dependence of dc conductivity on the PIL weight fraction, together with frequency dependences of both permittivity and loss angle, which all infer that static percolation occurs in the microemulsion. Only one dielectric relaxation at high frequency was observed in the PIL/O subregion, when the concentration increased to the boundary between the PIL/O and B.C. subregions; the second dielectric relaxation appeared at low frequency. The high-frequency relaxation is caused by interfacial polarization. The low-frequency relaxation is attributed to the dipole-oriented polarization of AOT-. When the oil content of the system was reduced, the interface became softer to allow more AOT- to rotate, and the cation shifted from moving around its long axis to rotating along its short axis. The static dielectric constant of [bmim][AOT] was given. The dielectric constants and conductivity of the dispersed and continuous phases in the PIL/O and O/PIL subregions were calculated from the dielectric parameters of high-frequency relaxation.

Biocompatible Solvents and Ionic Liquid-Based Surfactants as Sustainable Components to Formulate Environmentally Friendly Organized Systems

In this review, we deal with the formation and application of biocompatible water-in-oil microemulsions commonly known as reverse micelles (RMs). These RMs are extremely important to facilitate the dissolution of hydrophilic and hydrophobic compounds for biocompatibility in applications in drug delivery, food science, and nanomedicine. The combination of two wisely chosen types of compounds such as biocompatible non-polar solvents and ionic liquids (ILs) with amphiphilic character (surface-active ionic liquids, SAILs) can be used to generate organized systems that perfectly align with the Green Chemistry concepts. Thus, we describe the current state of SAILs (protic and aprotic) to prepare RMs using non-polar but safe solvents such as esters derived from fatty acids, among others. Moreover, the use of the biocompatible solvents as the external phase in RMs and microemulsions/nanoemulsions with the other commonly used biocompatible surfactants is detailed showing the diversity of preparations and important applications. As shown by multiple examples, the properties of the RMs can be modified by changes in the type of surfactant and/or external solvents but a key fact to note is that all these modifications generate novel systems with dissimilar properties. These interesting properties cannot be anticipated or extrapolated, and deep analysis is always required. Finally, the works presented provide valuable information about the use of biocompatible RMs, making them a green and promising alternative toward efficient and sustainable chemistry.

Dielectric analysis of the percolation, interface polarization, and phase behavior of 1-butyl-3-methylimidazolium tetrafluoroborate/TX-100/triethylamine microemulsions

Structure transitions, interface distinction and electrical parameters of a nonaqueous ionic liquid microemulsion reflected by concentration-dependent frequency domain dielectric spectroscopy.

Versatile surface-active ionic liquid: construction of microemulsions and their applications in light harvesting

This article outlines a sustainable method towards the synthesis of advanced materials such as core/shell Quantum Dots (QDs) and their in situ stabilization using microemulsions (MEs). QDs are versatile materials which show unusual optical properties. We have constructed MEs consisting of an Ionic Liquid (IL) based surfactant i.e. choline dioctylsulfosuccinate, [Cho][AOT] as an emulsifier, toluene as a nonpolar phase and water as a polar phase. The system forms a large single-phase region in the phase diagram without any co-surfactant. Spontaneous formation of micelles has been observed and studied through tensiometry and fluorescence and isothermal titration calorimetry (ITC). The exceptional swelling behaviour of the MEs was studied using Dynamic Light Scattering (DLS) and small angle neutron scattering (SANS). In ME droplets, i.e. Reverse Micelles (RMs), we successfully synthesized spherical core/shell QDs (size ∼3 to ∼6 nm) with precise control over the size and morphology. The QDs have been characterized using Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM) and Powder X-ray Diffraction (PXRD). QDs stabilized in MEs exhibited excellent optical properties and can be suitably used as light harvesting materials for diverse applications.

Ionic liquids: green and tailor-made solvents in drug delivery

Beyond their traditional use as green solvents, new applications have become available for ionic liquids (ILs) in drug delivery. Their flexible tunability enables task-specific optimization of ILs at molecular level. Thus, ILs have been exploited to improve the solubility and permeability of drugs and relieve the polymorphic problems associated with crystalline active pharmaceutical ingredients (APIs). Controlled preparation of drug nanocarriers are also achieved by using ILs either as media or as functional agents. Here, we highlight the importance and advantages of ILs in pharmaceutics and look towards the future of IL-based drug delivery.

Thermally Stable Ionic Liquid-Based Microemulsions for High-Temperature Stabilization of Lysozyme at Nanointerfaces

The development of new strategies for thermal stability and storage of enzymes is very important, considering the nonretention of catalytic activity by enzymes under harsh conditions of temperature. Following this, herein, a new approach based on the interfacial adsorption of lysozyme (LYZ) at nanointerfaces of ionic liquid (IL)-based microemulsions, for enhanced thermal stability of LYZ, is reported. Microemulsions (MEs) composed of dialkyl imidazolium-based surface active ILs (SAILs) as surfactants, ILs as the nonpolar phase, and ethylene glycol (EG) as the polar phase, without any cosurfactants, have been prepared and characterized in detail. Various regions corresponding to polar-in-IL, bicontinuous, and IL-in-polar phases have been characterized using conductivity measurements. Dynamic light scattering (DLS) measurements have provided insights into the size distribution of microdroplets, whereas temperature-dependent DLS measurements established the thermal stability of the MEs. Nanointerfaces formed by SAILs with EG in thermally stable reverse MEs act as fluid scaffolds to adsorb and provide thermal stability, up to 120 °C, to LYZ. Thermally treated LYZ upon extraction into a buffer shows enzyme activity owing to negligible change in the active site of LYZ, as marked by retention of microenvironment of Trp residues present in the active site of LYZ. The present work is expected to establish a new platform for the development of novel nanointerfaces utilizing biobased components for other biomedical applications.

Demonstration of a Novel Charge-Free Reverse Wormlike Micelle System

We demonstrate a novel charge-free reverse wormlike micelle (RWLM) consisting of a ternary mixture of a nonionic amphiphilic block copolymer, fatty acid alkyl ester oil, and water under ambient conditions. Nonionic amphiphile tetra-[poly(oxyethylene)-poly(oxybutylene)]pentaerythrityl ether (TEBPE) self-assembled into spheroid-type micelles in nonaqueous media isopropyl myristate (IPM) with viscosity comparable to that of IPM. The addition of water increases viscosity only slightly up to a certain concentration of water and then drastically, demonstrating the sphere-to-wormlike micelle transition as confirmed by small-angle X-ray scattering. Further increase in water decreases the viscosity after attaining a maximum value. The zero shear viscosity (η₀) of the 10 wt % TEBPE/IPM system reached the maximum at 2.6 wt % water and ca. 56 Pa·s, which is ∼fivefold higher than that of water. Dynamic rheological measurements on the highly viscous solutions confirmed the viscoelastic behavior and could be described by the Maxwell model. Conductivity, measured in the presence of a conductive probe, 1-ethyl-3-methylimidazolium tetrafluoroborate, was found to be higher for viscous samples compared to the nonviscous samples, suggesting the static percolation caused by the RWLM formation. Decrease in η₀ and conductivity beyond a maximum suggests the shortening of reverse micelles. A similar behavior has been observed in other fatty acid alkyl ester oils of different alkyl chain lengths. Note that most of the RWLM systems previously reported are based on phosphatidylcholine (PC). Formulation and structure-properties related to non-PC-based RWLMs have been rarely explored. Non-PC-based RWLMs using chemically stable and low-cost synthetic molecules can be applied not only in pharmaceuticals and cosmetics but also in a wide range of applications including drag reduction agents for nonaqueous fluids and as a template for nanomaterial synthesis.

Dielectric relaxation of nonaqueous ionic liquid microemulsions: polarization, microstructure, and phase transition

Two nonaqueous ionic liquid (IL) microemulsions (toluene/TX-100/[bmim][PF₆] and [bmim][BF₄]/TX-100/benzene) were studied by dielectric spectroscopy covering a wide frequency range (40 Hz to 110 MHz).

Transport properties of aqueous ionic liquid microemulsions: influence of the anion type and presence of the cosurfactant

Transport properties, viz. specific conductivity, dynamic viscosity and apparent diffusion coefficients, were measured as a function of water content in aqueous ionic liquid microemulsions containing 1-butyl-3-methylimidazolium hexafluorophosphate, [BMIM][PF6] and bis(trifluoromethanesulphonyl)imide, [BMIM][Tf2N], stabilized by the nonionic surfactant TX-100, or its mixture with a cosurfactant, i.e. butanol. The investigation covered the whole water content range through various (Winsor I-III and dissolved solution) structures of the system. The comparative approach allowed closer inspection into phenomena being on the background of observed transport properties behavior taking into account the influence of the cosurfactant. The addition of butanol offers considerable advantages, such as an increase in conductivity, especially in systems containing ionic liquids with lower conductivity. This is accompanied by a significant decrease in viscosity, even to values that are comparable with those of molecular solvents. Moreover, the reasons for the surprisingly higher conductivity of [BMIM][PF6]-based systems were provided, and the conclusions were supported by cyclic voltammetry as well as spectrophotometric and dynamic light scattering measurements.