Difunctional hierarchical porous SiOC composites from silicone resin and rice husk for efficient adsorption and as a catalyst support

Waste expanded polystyrene modified with H2SO4/biodegradable chelating agent for reuse: As a highly efficient adsorbent to remove fluoroquinolone antibiotic from water

Untreated wastewater containing fluoroquinolone antibiotics poses serious hazards to aquatic species and human health; therefore, treatment of waste expanded polystyrene (EPS) is a crucial environmental matter. In this study, waste EPS was modified with a H₂SO₄/biodegradable chelating agent, [S,S]-ethylenediamine-N,N'-disuccinic acid (EDDS), and used for highly efficient adsorption of the fluoroquinolone antibiotic ciprofloxacin. When ciprofloxacin of 25 mg/L was used, the H₂SO₄-modified EPS (EPS_H2SO4) adsorbed 60.5% of the ciprofloxacin. During sulfonation, adding a low dose of EDDS markedly improved the adsorption ability of EPS_H2SO4+EDDS. The optimal modification conditions were 95% H₂SO₄, 0.002 M EDDS, 80 °C, and 40 min. The increased adsorbent doses enhanced the adsorption. Approximately 0.2 g/L of EPS_H2SO4+EDDS could effectively adsorb 97.8% of the ciprofloxacin (554.3 mg/g) within 30 min. Solution pH₀ greatly influenced the adsorption, and the most suitable pH₀ was 6. The Langmuir isotherm accurately described the adsorption behaviors of both EPS_H2SO4 and EPS_H2SO4+EDDS (R² = 0.997-0.998). The adsorption ability of EPS_H2SO4+EDDS (q_max = 1250 mg/g) was 32 times higher than that of EPS_H2SO4 (q_max = 38.6 mg/g). A total of 1 M HCl effectively regenerated the exhausted adsorbent. The optimal solid/liquid ratio and time were 0.08 g/20 mL and 60 min, respectively. The regenerated EPS_H2SO4+EDDS maintained a high adsorption ability (87.2%) after 10 regeneration cycles. The results thus indicate that the EPS_H2SO4+EDDS adsorption-regeneration process is a potential approach to remove ciprofloxacin from water.

Chemical Structure and Microstructure Characterization of Ladder-Like Silsesquioxanes Derived Porous Silicon Oxycarbide Materials

The aim of this work was to synthesize porous ceramic materials from the SiOC system by the sol-gel method and the subsequent pyrolysis. The usage of two types of precursors (siloxanes) was determined by Si/C ratio in starting materials. It allows us to control the size of the pores and specific surface area, which are crucial for the potential applications of the final product after thermal processing. Methyltrimethoxysilane and dimethyldiethoxysilane were mixed in three different molar ratios: 4:1, 2:1, and 1:1 to emphasize Si/C ratio impact on silicon oxycarbide glasses properties. Structure and microstructure were examined both for xerogels and obtained silicon oxycarbide materials. Brunauer-Emmett-Teller (BET) analysis was performed to confirm that obtained materials are porous and Si/C ratio in siloxanes precursors affects porosity and specific surface area. This kind of porous ceramics could be potentially applied as gas sensors in high temperatures, catalyst supports, filters, adsorbents, or advanced drug delivery systems.