Facile fabrication of ZnO nanorods modified with RGO for enhanced photodecomposition of dyes

Construction and mechanistic insights of a novel ZnO functionalized rGO composite for efficient adsorption and reduction of Cr(VI)

A series of ZnO decorated reduced graphene oxide (rGO) (ZnrGOx) with different doping ratios were synthesized by the alkaline hydrothermal method using graphene oxide (GO) and Zn(NO3)2·6H2O as precursors, and subsequently used for the adsorption study of Cr(VI) in water. The morphology, crystalline phase structure, and surface elemental properties of ZnrGOx composites were revealed by XRD, SEM, BET, FT-IR, and XPS characterizations. The results showed that ZnO nanoparticles can be clearly seen on the surface of layered rGO. Meanwhile, as the doping rate increased, the C = C double bonds were broken and more carboxylic acid groups formed in ZnrGOx. In addition, the ZnrGO0.1 composite had the most excellent adsorption performance and good stability, and reusability. The adsorption removal rate of Cr(VI) can reach 99%, and the maximum adsorption amount of Cr(VI) was 68.9655 mg/g in 3 h. The isothermal and kinetic model simulations showed that Cr(VI) adsorption on ZnrGO0.1 composite is a chemical adsorption process, spontaneous and endothermic. Based on the concentrations of different valence states of Cr in the solid and liquid phases, 40% of Cr(VI) was reduced to Cr(III) on the surface of ZnrGO0.1 composite. Moreover, the adsorption-reduction mechanisms of Cr(VI) on ZnrGO0.1 composite were further elucidated. The ZnrGO0.1 composite manifested great potential as an efficient adsorbent for Cr(VI) removal.

Removal of Methylene Blue from Aqueous Solution by Mixture of Reused Silica Gel Desiccant and Natural Sand or Eggshell Waste

The purpose of this work was to develop, characterize and test new low-cost materials suitable for removing methylene blue dye from water and wastewater by adsorption. The solid materials consisted of silica gel powder (SG), silica gel mixed with eggshell powder (SG-ES) and a mixture of silica gel with sand from the western Iraqi desert (SG-SI). The samples were milled by using an electrical mixer and a ball mill, followed by a drying step. In addition, desert sand was acid-treated in order to remove impurities. The structure and chemical composition of the samples were investigated by X-ray diffraction (XRD), a scanning electron microscopy technique equipped with an energy-dispersive X-ray spectrometer (SEM-EDX), a low-temperature nitrogen adsorption (BET) technique, thermo-analytical (TG/TGA) measurements and Fourier-transformed infrared spectroscopy (FTIR). The previously mentioned materials were tested to remove methylene blue from an aqueous solution. The adsorption experiments were monitored by ultraviolet-visible (UV-Vis) spectrophotometry and showed that SG and SG-ES gave promising results for the methylene blue removal from water. After 40 min of treatment of the aqueous solution containing 10 mg/L of MB at room temperature, the tested SG, SG-ES and SG-SI materials were found to have 86%, 80% and 57% dye adsorption efficiency, respectively. Taking into consideration not only the adsorption activity of the studied material but their availability, cost and concepts of cleaner production and waste minimization, the developed silica gel with eggshell can be considered as a good, cost-effective alternative to commercially available activated-carbon-based adsorbents. Different kinetic and isotherm models were fitted to the experimental results. A pseudo-second-kinetics-order model revealed high correlation fitting, while the Freundlich model was found to appropriately describe the adsorption isotherm. The thermal stability during the possible regeneration process of the SG-ES adsorbent mixture and its interaction mechanism with cationic dye was discussed.

Viscosity Simulation of Glass Microfiber and an Unusual Air Filter with High-Efficiency Antibacterial Functionality Enabled by ZnO/Graphene-Modified Glass Microfiber

The current global pandemic of new coronary pneumonia clearly reveals the importance of developing highly efficient filtration and fast germicidal performance of multifunctional air filters. In this study, a novel air filter with a controllable morphology based on the rod-like to flower-like zinc oxide/graphene-based photocatalytic composite particles loaded on glass microfiber was prepared by one-step microwave rapid synthesis. The multifunctional air filter shows the following special functions: the 10 mg·L^-1 organic pollutant solution RhB was completely degraded within 2 h under a 500 W xenon lamp, and also 99% of Escherichia coli and Staphylococcus aureus were inactivated under a 60 W light-emitting diode lamp. Furthermore, after introducing the controllable morphology zinc oxide/graphene-based photocatalytic composite particles, the filtration efficiency of the multifunctional air filter was also kept at the same level (99.8%) as the one without any addition, indicating no loss of high-efficiency filtration while obtaining the rapid bactericidal function. The rapid antibacterial principle of the multifunctional air filter has also been proposed through the UV-vis spectroscopies, photoluminescence, and electron-spin resonance spectrum. The zinc oxide/graphene-based photocatalytic composite particles tightly coated on the glass microfiber surface could increase the active sites by changing the morphology of zinc oxide and, in the meantime, promote the separation of zinc oxide photo-generated electron-hole pairs to improve the rapid sterilization ability of the multifunctional air filters. In addition, an empirical formula to evaluate the relationship between the composition, viscosity, and viscosity modulus of glass microfiber was proposed by testing the viscosity of glass microfiber composed of 14 different compositions at 1300 and 1400 °C, which can be used as a criterion to evaluate the production technology of glass microfiber filters.

Synthesis and characterization of ZnO decorated reduced graphene oxide (ZnO-rGO) and evaluation of its photocatalytic activity toward photodegradation of methylene blue

Photocatalytic treatment is one of the techniques used for the treatment of dyes-contaminated wastewater. It is important to develop an effective visible-light-driven catalyst for the treatment of dyes-contaminated wastewater. This study reports the synthesis of ZnO-reduced graphene oxide catalyst for the degradation of methylene blue. Graphene oxide was prepared by Hammer and Offeman process, while ZnO-rGO (1:1) was prepared by the chemical reduction method. The prepared ZnO-rGO composite was characterized by XRD, TEM, SEM, UV-Vis, DRS, N₂ adsorption-desorption, FTIR, and XPS analyses. The photocatalytic activity was evaluated by photodegradation of methylene blue solution under irradiation. It was found that ZnO-rGO is capable of removing the dye from water and achieved the highest dye degradation efficiency of ~99% within 60 min. Furthermore, the ZnO-rGO was recycled in degradation experiments without any loss in its catalytic performance. The reaction kinetics was described in terms of the Langmuir-Hinshelwood mechanism, one of the kinetics mechanisms of surface catalyzed reaction. 36.2 and 13.1 kJ/mol were calculated as the apparent and true activation energy for photodegradation of methylene blue respectively.

Enhancing the Conductivity of the Nanostructured ZnO Thin Film by Vacuum Annealing

ZnO thin films were successfully synthesized using a facile chemical route and were characterized employing X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM) and photoluminescence (PL) analysis. The obtained precursor was spin-coated on Si(100)/SiO2 wafers, then the substrates were divided into two groups for the thermal annealing at ambient and vacuum conditions. Morphological characterization showed the formation of nanoflowers and porous structures at different annealing conditions. The effect of vacuum annealing on the current-voltage characterization of ZnO thin film has been presented to inspect the role of annealing condition in device fabrication. The electrical properties of the ZnO thin films were performed in the temperature range of 75–[Formula: see text]C. At [Formula: see text]C, the ambient annealed sample presents the current value of 10[Formula: see text][Formula: see text]A for 5[Formula: see text]V, and the vacuum annealed sample reaches the maximum current of 3.1[Formula: see text]mA for the same operating voltage. The presence of oxygen vacancies notably affects the electrical properties of ZnO thin films.

Biological mediated synthesis of RGO-ZnO composites with enhanced photocatalytic and antibacterial activity

In this study, we reported the biological approach to synthesis of ZnO nanorod (NR) on the reduced graphene oxide (RGO) for photocatalytic, antibacterial activity and hydrogen production under sunlight. Bacillus subtilis played a vital role in the production of biogenic ammonia from synthetic urine and utilized for the synthesis of ZnONR on the RGO sheet. The morphological study revealed that RGO sheets displayed a tremendous role in anchoring ZnONR. XRD patterns showed the ZnO crystal phase on the RGO sheets. XPS and Raman spectra confirmed that the bio-hydrothermal method as suitable for GO converted into RGO. The transient photocurrent and I/V measurement are exhibited as an increment on the RGO-ZnONR compared to ZnONR. The RGO-ZnONR composites showed excellent performance with decolorization of MB and textile dyes and efficient control of the E. coli and S. aureus. RGO-ZnONR exhibited remarkable noted as a higher photocatalytic hydrogen evolution rate (940 μmol/h/g_cat) than the ZnONR (369.5 μmol/h/g _cat). As a result of photocatalytic performance to correlate with sunlight intensity was extensively studied. RGO plays an essential role in interface electron transfer from sunlight to ZnONR for enhancing •OH radical formation to cleavage of dye color substance and eradicated bacterial cells.

Photocatalytic processes for biomass conversion

This review focuses on the photocatalytic conversion of biomass, emphasizing several types of systems, including different photocatalysts and biomass derivatives.

Effect of Zn precursor concentration in the synthesis of rGO/ZnO composites and their photocatalytic activity

This work focuses on the synthesis of composite materials based on reduced graphene oxide reinforced with zinc oxide.