Interfacial self-assembled thioxathone monolayers on the surfaces of silica nanoparticles as efficient heterogeneous photocatalysts for the selective oxidation of aromatic thioethers under air atmosphere

Interfacial Self-Assembly of Organized Ultrathin Films of Tripodal Metal-Terpyridyl Coordination Polymers as Luminophores and Heterogeneous Catalysts for Photocatalytic CO2 Reduction

Metal-directed interfacial self-assembly of well-defined coordination polymer (CP) ultrathin films can control the metal complex arrangement and distribution at the molecular level, providing a convenient route for the design and fabrication of novel opto-electrical devices and heterogeneous catalysts. Here, we report the assembly of two series of CP multilayers with the transition-metal ions of Fe²⁺, Co²⁺, Zn²⁺ and Tb³⁺ as connectors and tripodal terpyridyl ligands of 4,4',4″-(1,3,5-triazine-2,4,6-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyTa) and 4,4',4″-(benzene-1,3,5-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyBen) as linkers at the air-water interface. The as-prepared Langmuir-Blodgett (LB) films display strong luminescence, with the emission wavelength and relative intensity dependent on both the metal ions and linkers; among them, the Zn-TerPyTa and Zn-TerPyBen CPs give off the strongest luminescent emission centered at about 370 nm with an emission lifetime of approximately 0.2-0.3 ns. The Tb-TerPyTa CPs can give off emission at approximately 490, 546, 586, and 622 nm, attributed to the ⁵D₄ to ⁷F_3-6 electron transitions of typical Tb³⁺ ions. Finally, these CP LB films can act as efficient heterogeneous photocatalysts for the CO₂ reduction to selectively produce CO. The catalytic efficiency can be optimized by adjusting the experimental conditions (light sensitizer, electron donor, and water content) and CP composition (metal ion and ligand) with an excellent yield of up to 248.1 mmol g^-1. In particular, it is revealed that, under the same conditions, the catalytic efficiency of the Fe-TerPyTa CP LB film is nearly 2 to 3 orders of magnitude higher than that of the other metalated complexes investigated in the homogeneous system. UV-vis spectroscopy and cyclic voltammetry studies demonstrated that the dual active sites of Fe-terpyridine and TerPyTa units contribute to the enhanced catalytic activity. This work provides an effective method to introduce the earth-abundant metal complexes into CP films to construct efficient noble-metal-free photocatalysts for the CO₂ reduction.

Exceptional Light Sensitivity by Thiol-Ene Click Lithography

Lithographic patterning, which utilizes the solubility switch of photoresists to convert optical signals into nanostructures on the substrate, is the primary top-down approach for nanoscale fabrication. However, the low light/electron-energy conversion efficiency severely limits the throughput of lithography. Thiol-ene reaction, as a photoinitiated radical addition reaction, is widely known as click reaction in the field of chemistry due to its extremely high efficiency. Here, we introduce a click lithography strategy utilizing the rapid thiol-ene click reaction to realize ultraefficient nanofabrication. This novel approach facilitated by the implementation of ultrahigh-functionality material designs enables high-contrast patterning of metal-containing nanoclusters under an extremely low deep-ultraviolet exposure dose, e.g., 7.5 mJ cm^-2, which is 10-20 times lower than the dose used in the photoacid generator-based photoresist system. Meanwhile, 45 nm dense patterns were also achieved at a low dose using electron beam lithography, revealing the great potential of this approach in high-resolution patterning. Our results demonstrated the high-sensitivity and high-resolution features of click lithography, providing inspiration for future lithography design.