A novel amphiphilic Janus nano-silica for enhanced oil recovery in low-permeability reservoirs: An experimental study

Assessment of heavy oil recovery mechanisms using in-situ synthesized CeO2 nanoparticles

This project investigated the impact of low-temperature, in-situ synthesis of cerium oxide (CeO2) nanoparticles on various aspects of oil recovery mechanisms, including changes in oil viscosity, alterations in reservoir rock wettability, and the resulting oil recovery factor. The nanoparticles were synthesized using a microemulsion procedure and subjected to various characterization analyses. Subsequently, these synthesized nanoparticles were prepared and injected into a glass micromodel, both in-situ and ex-situ, to evaluate their effectiveness. The study also examined the movement of the injected fluid within the porous media. The results revealed that the synthesized CeO2 nanoparticles exhibited a remarkable capability at low temperatures to reduce crude oil viscosity by 28% and to lighten the oil. Furthermore, the addition of CeO2 nanoparticles to the base fluid (water) led to a shift in the wettability of the porous medium, resulting in a significant reduction in the oil drop angle from 140° to 20°. Even a minimal presence of CeO2 nanoparticles (0.1 wt%) in water increased the oil production factor from 29 to 42%. This enhancement became even more pronounced at a concentration of 0.5 wt%, where the oil production factor reached 56%. Finally, it was found that the in-situ injection, involving the direct synthesis of CeO2 nanoparticles within the reservoir using precursor salts solution and reservoir energy, led to an 11% enhancement in oil production efficiency compared to the ex-situ injection scenario, where the nanofluid is prepared outside the reservoir and then injected into it.

Enhancing Oil Recovery in Low-Permeability Reservoirs Using a Low-Molecular Weight Amphiphilic Polymer

Polymer flooding has achieved considerable success in medium-high permeability reservoirs. However, when it comes to low-permeability reservoirs, polymer flooding suffers from poor injectivity due to the large molecular size of the commonly used high-molecular-weight (high-MW) partially hydrolyzed polyacrylamides (HPAM). Herein, an amphiphilic polymer (LMWAP) with a low MW (3.9 × 106 g/mol) was synthesized by introducing an amphiphilic monomer (Allyl-OP-10) and a chain transfer agent into the polymerization reaction. Despite the low MW, LMWAP exhibited better thickening capability in brine than its counterparts HPAM-1800 (MW = 1.8 × 107 g/mol) and HPAM-800 (MW = 8 × 106 g/mol) due to the intermolecular hydrophobic association. LMWAP also exhibited more significant shear-thinning behavior and stronger elasticity than the two counterparts. Furthermore, LMWAP possesses favorable oil-water interfacial activity due to its amphiphilicity. The oil-water interfacial tension (IFT) could be reduced to 0.88 mN/m and oil-in-water (O/W) emulsions could be formed under the effect of LMWAP. In addition, the reversible hydrophobic association endows the molecular chains of LMWAP with dynamic association-disassociation transition ability. Therefore, despite the similar hydrodynamic sizes in brine, LMWAP exhibited favorable injectivity under low-permeability conditions, while the counterpart HPAM-1800 led to fatal plugging. Furthermore, LMWAP could enhance oil recovery up to 21.5%, while the counterpart HPAM-800 could only enhance oil recovery by up to 11.5%, which could be attributed to the favorable interfacial activity of LMWAP.