Differences in the surface composition of seemingly similar F75 cobalt–chromium micron-sized particulates can affect synovial fibroblast viability

Effect of sanitizing solutions on cobalt-chromium alloys for dental prostheses: A systematic review of in vitro studies

STATEMENT OF PROBLEM

Given the wide use of cobalt-chromium (Co-Cr) alloys, especially for removable partial dentures, and the importance of chemical solutions to complement the cleaning of dental prostheses, safe disinfection products should be identified for the regular decontamination of Co-Cr dental prostheses.

PURPOSE

The purpose of this systematic review of in vitro studies was to determine the effects on the properties of Co-Cr dental alloys of the various chemical agents used to clean dental prostheses.

MATERIAL AND METHODS

In vitro studies were included based on a literature search conducted in March 2022 in the Medline/PubMed, SCOPUS, Web of Science, Virtual Health Library, and Embase databases. Independent reviewers performed the search, selection, extraction, and analysis of the data. The review was performed based on the Preferred Reporting Items for Systematic Review and Meta-Analysis (PRISMA) guidelines. The quality of the included articles was evaluated by using parameters adapted from the Consolidated Standards of Reporting Trials (CONSORT) guidelines, and the risk of bias analysis was performed based on previous studies.

RESULTS

Among the 15 included studies, the chemical agents evaluated were alkaline peroxides and hypochlorites, mouthwashes containing cetylpyridinium chloride and chlorhexidine, diluted acids, and enzymes. Some peroxides produced increased ion release, surface roughness, and mass loss of the alloys. The hypochlorites were responsible for the greatest surface corrosion, yielding dark stains, rough regions, and depressions. Acetic and peracetic acids and mouthwashes containing chlorhexidine and cetylpyridinium did not produce significant changes in Co-Cr alloys. Most studies presented moderate risk of bias.

CONCLUSIONS

According to the included studies, mouth rinses containing cetylpyridinium chloride or chlorhexidine and solutions with acetic and peracetic acid could be safely used to chemically sanitize Co-Cr prostheses. Alkaline peroxides should be used with caution, and alkaline hypochlorite solutions should be avoided.

Systemic toxicity related to metal hip prostheses

INTRODUCTION

One in eight of all total hip replacements requires revision within 10 years, 60% because of wear-related complications. The bearing surfaces may be made of cobalt/chromium, stainless steel, ceramic, or polyethylene. Friction between bearing surfaces and corrosion of non-moving parts can result in increased local and systemic metal concentrations.

OBJECTIVES

To identify and systematically review published reports of systemic toxicity attributed to metal released from hip implants and to propose criteria for the assessment of these patients.

METHODS

Medline (from 1950) and Embase (from 1980) were searched to 28 February 2014 using the search terms (text/abstract) chrom* or cobalt* and [toxic* or intox* or poison* or adverse effect or complication] and [prosthes* or 'joint replacement' or hip or arthroplast*] and PubMed (all available years) was searched using the search term (("Chromium/adverse effects"[Mesh] OR "Chromium/poisoning"[Mesh] OR "Chromium/toxicity"[Mesh]) OR ("Cobalt/adverse effects"[Mesh] OR "Cobalt/poisoning"[Mesh] OR "Cobalt/toxicity"[Mesh])) AND ("Arthroplasty, Replacement, Hip"[Mesh] OR "Hip Prosthesis"[Mesh]). These searches identified 281 unique references, of which 23 contained original case data. Three further reports were identified from the bibliographies of these papers. As some cases were reported repeatedly the 26 papers described only 18 individual cases. Systemic toxicity. Ten of these eighteen patients had undergone revision from a ceramic-containing bearing to one containing a metal component. The other eight had metal-on-metal prostheses. Systemic toxicity was first manifest months and often several years after placement of the metal-containing joint. The reported systemic features fell into three main categories: neuro-ocular toxicity (14 patients), cardiotoxicity (11 patients) and thyroid toxicity (9 patients). Neurotoxicity was manifest as peripheral neuropathy (8 cases), sensorineural hearing loss (7) and cognitive decline (5); ocular toxicity presented as visual impairment (6). All these neurological features, except cognitive decline, have been associated with cobalt poisoning previously. Type of prosthesis and blood metal concentrations. Where blood or serum metal concentrations were reported (n = 17 for cobalt and n = 14 for chromium), the median cobalt concentration was 398 (range, 13.6-6521) μg/L and the median chromium concentration was 48 μg/L (in whole blood) (range, 4.1-221 μg/L including serum and blood values). Those patients reported to have systemic features who had received a metal-on-metal prosthesis (n = 8) had a median peak blood cobalt concentration of 34.5 (range, 13.6-398.6) μg/L; those with a metal-containing revision of a failed ceramic prosthesis (n = 10) had a median blood cobalt concentration of 506 (range, 353-6521) μg/L. Management. The most common treatment was removal of the metal-containing prosthesis, undertaken in all but 2 patients. This was usually associated with a fall in circulating cobalt concentration and improvement in some or all features. Clinical and toxicological assessment of systemic features. We propose the following criteria for assessing the likelihood that clinical features are related to cobalt toxicity: clinical effects consistent with the known neurological, cardiac, or thyroidal effects of cobalt, and for which any other explanation is less likely; increased blood cobalt concentrations (substantially higher than those in patients with well-functioning prostheses) several months after hip replacement; a fall in the blood cobalt concentration, usually accompanied by signs of improvement in features. When judged by these criteria, the systemic features in 10 of the reported cases are likely to be related to cobalt exposure from a metal-containing hip prosthesis.

CONCLUSIONS

Rarely, patients exposed to high circulating concentrations of cobalt from failed hip replacements develop neurological damage, hypothyroidism and/or cardiomyopathy, which may not resolve completely even after removal of the prosthesis. The greatest risk of systemic cobalt toxicity seems to result from accelerated wear of a cobalt-containing revision of a failed ceramic prosthesis, rather than from primary failure of a metal-on-metal prosthesis.

Comparison of the cytotoxic and inflammatory responses of titanium particles with different methods for endotoxin removal in RAW264.7 macrophages

It is generally accepted that periprosthetic bone resorption is initiated through aseptic inflammation aggravated by wear particles that are generated from artificial joint. However, some studies have demonstrated that "endotoxin-free" wear particles are almost completely unable to stimulate the macrophage-mediated production of proinflammatory cytokines. Here, we compare the titanium particles with different methods of endotoxin removal. The results indicated that different titanium particle preparation dosages did not significantly change particle size, morphology, and chemical composition. But it could cause variations in the endotoxin concentration of titanium particles and inflammatory responses in RAW264.7 macrophages. The particles with higher endotoxin levels correlated with more extensive inflammatory responses. When testing endotoxins using the supernatant of particle suspensions, it would lead to false negative results compared with testing the particle themselves. And when using the particles themselves, all the particles should be removed by centrifugation to avoid particle interference before the absorbance value was determined. Therefore, we suggest that research concerning wear particles should completely describe the endotoxin testing process, including endotoxin removal from particles and the details of endotoxin testing. Moreover, future research should focus on the surface of wear particles (the potential role of adherent endotoxin) rather than the particles themselves.

Material attrition and bone micromorphology after conventional and ultrasonic implant site preparation

OBJECTIVES

Little is known about the recently introduced ultrasonic implant site preparation. The purpose of this study was to compare material attrition and micromorphological changes after ultrasonic and conventional implant site preparations.

MATERIAL AND METHODS

Implant site preparations were performed on fresh bovine ribs using one conventional (Straumann, Freiburg, Germany) and two ultrasonic (Piezosurgery; Mectron Medical Technology, Carasco, Italy and Variosurg; NSK, Tochigi, Japan) systems with sufficient saline irrigation. Sections were examined by environmental scanning electron microscopy (ESEM). Energy-dispersive X-ray spectroscopy (EDX) was performed to evaluate the metal attrition within the bone and the irrigation fluid.

RESULTS ESEM

After conventional osteotomy, partially destroyed trabecular structures of the cancellous bone that were loaded with debris were observed, whereas after ultrasonic implant site preparations, the anatomic structures were preserved. EDX: None of the implant site preparation methods resulted in metal deposits in the adjacent bone structures. However, within the irrigation liquid, there was significantly higher metal attrition with ultrasonic osteotomy (P < 0.0001 and P < 0.0001 for Mectron and NSK, respectively). Whereas for Straumann system used, 15.5% of the SEM/EDX findings were drill-origin metals, this percentage increased to 37.3% and 37.9% with the application of Mectron and NSK, respectively.

CONCLUSIONS

Ultrasonic implant site preparation is associated with the preservation of bone microarchitecture and with the increased attrition of metal particles. Therefore, copious irrigation seems to be even more essential for ultrasonic implant site preparation than for the conventional method.