Permeation kinetics of active drugs through lanolin-based artificial membranes

Optimization of Sodium Iodide-Based Root Filling Material for Clinical Applications: Enhancing Physicochemical Properties

Premature loss of root canal-treated primary teeth has long been a concern in dentistry. To address this, researchers developed a sodium iodide-based root canal-filling material as an alternative to traditional iodoform-based materials. The goal of this study was to improve the physicochemical properties of the sodium iodide-based material to meet clinical use standards. To resolve high solubility issues in the initial formulation, researchers adjusted component ratios and added new ingredients, resulting in a new paste called L5. This study compared L5 with L0 (identical composition minus lanolin) and Vitapex as controls, conducting physicochemical and antibacterial tests. Results showed that L5 met all ISO 6876 standards, demonstrated easier injection and irrigation properties than Vitapex, and exhibited comparable antibacterial efficacy to Vitapex, which is currently used clinically. The researchers conclude that if biological stability is further verified, L5 could potentially be presented as a new option for root canal-filling materials in primary teeth.

A Synthetic Model of the Mucosa for Oral Penetration Studies

The main objective of this study is the evaluation of the use of a synthetic membrane, Nuclepore, as a model for permeation studies through sublingual mucosa. The permeability of two types of membranes, porcine sublingual oral mucosa and a synthetic Nuclepore membrane, to water was compared. Moreover, the water permeability of membranes modified with waterproofing formulations was measured to study their ability to protect against the penetration of viruses, toxins, etc. A relatively high correlation (R2 0.88) was obtained between the transmucosal water loss (TMWL) values of the artificial membrane and the mucosa. These results support the possible use of this synthetic membrane in the screening of the water permeability of formulations. In addition, studies of the permeation of different actives, drugs, and biocides through the two membranes were carried out, and these results were compared with their skin permeation data. The synthetic membrane does not seem to discern between compounds in terms of permeability. However, the permeation of caffeine through intact or modified membranes incorporating waterproofing formulations presents similar permeation profiles through the synthetic membrane and mucosa. The results from these assays should lend support to the use of this synthetic membrane when screening formulations to be applied in oral penetration studies.

Curcumin-loaded microemulsion: formulation, characterization, and in vitro skin penetration

OBJECTIVE

Formulation of curcumin in a microemulsion with a high loading capacity and that favors its penetration into the skin.

SIGNIFICANCE

Take advantage of the properties of microemulsions to promote the penetration of curcumin into the skin, with the aim of enhancing its therapeutic effects.

METHODS

Curcumin was formulated in microemulsions based on oleic acid (oil phase), Tween® 80 (surfactant), and Transcutol^® HP (cosurfactant). The microemulsion formation area was mapped by constructing pseudo-ternary diagrams for surfactant:co-surfactant ratios 1:1, 1:2, and 2:1. Microemulsions were characterized through measurements of specific weight, refractive index, conductivity, viscosity, droplet size, and in vitro skin permeation studies.

RESULTS

Nine microemulsions were prepared and characterized, showing clear, stable formulations with globule size dependent on the proportion of the components. The microemulsion with the highest loading capacity (60 mg/mL), based on Tween^® 80, Transcutol^® HP, oleic acid, and water (40:40:10:10) was able to penetrate the viable epidermis, finding a total amount of curcumin in the receptor medium at 24 h of 10.17 ± 9.7 µg/cm². The distribution of curcumin in the skin, visualized by confocal laser scanning microscopy, showed that the maximum amount was located between 20 and 30 µm.

CONCLUSION

The inclusion of curcumin in a microemulsion allows its passage into and through the skin. The localization of curcumin, especially in the viable epidermis, would be important for those cases where local conditions are sought to be treated.

Development and Characterization of Cyclodextrin-Based Nanogels as a New Ibuprofen Cutaneous Delivery System

Nanogels combine the properties of hydrogels and nanocarrier systems, resulting in very effective drug delivery systems, including for cutaneous applications. Cyclodextrins (CDs) have been utilised to enhance the nanogels' loading ability towards poorly soluble drugs and promote/sustain drug release. However, formation of CD-based nanogels requires the use of specially modified CDs, or of crosslinking agents. The aim of this work was to develop a CD-based nanogel to improve the cutaneous delivery of ibuprofen by using the soluble β-cyclodextrin/epichlorohydrin polymer (EPIβCD) without adding any potentially toxic crosslinker. The use of EPIβCD enabled increasing ibuprofen loading due to its complexing/solubilizing power towards the poorly soluble drug and prolonging drug release over time due to the nanogel formation. DLS analysis proved that EPIβCD allowed the formation of nanostructures ranging from 60 up to 400 nm, depending on the gelling agent type and the gel preparation method. EPIβCD replacement with monomeric HPβCD did not lead in any case to nanogel formation. Permeation experiments using skin-simulating artificial membranes proved that the EPIβCD-based nanogel enhanced ibuprofen solubility and release, increasing its permeation rate up to 3.5 times, compared to a reference formulation without CD and to some commercial gel formulations, and also assured a sustained release. Moreover, EPIβCD replacement with HPβCD led to a marked increase in drug solubility and initial release rate, but did not provide a prolonged release due to the lack of a nano-matrix structure controlling drug diffusion.

Monoketonic Curcuminoid-Lidocaine Co-Deliver Using Thermosensitive Organogels: From Drug Synthesis to Epidermis Structural Studies

Organogels (ORGs) are remarkable matrices due to their versatile chemical composition and straightforward preparation. This study proposes the development of ORGs as dual drug-carrier systems, considering the application of synthetic monoketonic curcuminoid (m-CUR) and lidocaine (LDC) to treat topical inflammatory lesions. The monoketone curcuminoid (m-CUR) was synthesized by using an innovative method via a NbCl₅–acid catalysis. ORGs were prepared by associating an aqueous phase composed of Pluronic F127 and LDC hydrochloride with an organic phase comprising isopropyl myristate (IPM), soy lecithin (LEC), and the synthesized m-CUR. Physicochemical characterization was performed to evaluate the influence of the organic phase on the ORGs supramolecular organization, permeation profiles, cytotoxicity, and epidermis structural characteristics. The physico-chemical properties of the ORGs were shown to be strongly dependent on the oil phase constitution. Results revealed that the incorporation of LEC and m-CUR shifted the sol-gel transition temperature, and that the addition of LDC enhanced the rheological G′/G″ ratio to higher values compared to original ORGs. Consequently, highly structured gels lead to gradual and controlled LDC permeation profiles from the ORG formulations. Porcine ear skin epidermis was treated with ORGs and evaluated by infrared spectroscopy (FTIR), where the stratum corneum lipids were shown to transition from a hexagonal to a liquid crystal phase. Quantitative optical coherence tomography (OCT) analysis revealed that LEC and m-CUR additives modify skin structuring. Data from this study pointed ORGs as promising formulations for skin-delivery.

Lanolin-Based Synthetic Membranes for Transdermal Permeation and Penetration Drug Delivery Assays

Due to the high similarity in composition and structure between lanolin and human SC lipids, we will work with two models from wool wax. Two types of lanolin were evaluated: one extracted with water and surfactants (WEL) and the other extracted with organic solvents (SEL). Skin permeation and skin penetration studies were performed with two active compounds to study the feasibility of the use of lanolin-based synthetic membranes as models of mammalian skin. Diclofenac sodium and lidocaine were selected as the active compounds considering that they have different chemical natures and different lipophilicities. In the permeation assay with SEL, a better correlation was obtained with the less permeable compound diclofenac sodium. This assay suggests the feasibility of using artificial membranes with SEL as a model for percutaneous absorption studies, even though the lipophilic barrier should be improved. Penetration profiles of the APIs through the SEL and WEL membranes indicated that the two membranes diminish penetration and can be considered good membrane surrogates for skin permeability studies. However, the WEL membranes, with a pH value similar to that of the skin surface, promoted a higher degree of diminution of the permeability of the two drugs, similar to those found for the skin.