Computational estimation of fluid mechanical benefits from a fluid deflector at the distal end of artificial vascular grafts

Multi-Objective Optimisation of a Novel Bypass Graft with a Spiral Ridge

The low long-term patency of bypass grafts is a major concern for cardiovascular treatments. Unfavourable haemodynamic conditions in the proximity of distal anastomosis are closely related to thrombus creation and lumen lesions. Modern graft designs address this unfavourable haemodynamic environment with the introduction of a helical component in the flow field, either by means of out-of-plane helicity graft geometry or a spiral ridge. While the latter has been found to lack in performance when compared to the out-of-plane helicity designs, recent findings support the idea that the existing spiral ridge grafts can be further improved in performance through optimising relevant design parameters. In the current study, robust multi-objective optimisation techniques are implemented, covering a wide range of possible designs coupled with proven and well validated computational fluid dynamics (CFD) algorithms. It is shown that the final set of suggested design parameters could significantly improve haemodynamic performance and therefore could be used to enhance the design of spiral ridge bypass grafts.

Study of Hepatic Vascular Dynamics Based on Symmetrical Pulsating Perfusion

Background

The traditionally used perfusion method is constant flow. This study proposes a novel method called Symmetric Pulsating Flow (SPF) and verified that this method is applicable.

Material/Methods

The fluid dynamic behavior of perfusate in the vessel, the shear stress, and the vascular deformation were simulated based on the bi-directional fluid-structure interaction. The differences of the fluid dynamic behaviors and the mechanical characteristics of vascular wall were studied and compared between the 2 methods during the process of hepatic perfusion. The simulations and comparisons were carried out on 3 different vascular models.

Results

Utilizing the constant flow perfusion, a double vortex clearly appeared at the rear end of the foreign matter and reflux retention can be caused by the double vortex. The reflux retention caused lower shear stress against the vascular wall and thus brought new accumulation of foreign matter. The SPF perfusion, however, prevented the double vortex, and avoided such reflux retention during the vascular perfusion. In addition, the SPF can clean the vascular wall better with a slower speed, which causes less injury to the vessel, and the pulsating effect can reduce the accumulation of new foreign matter.

Conclusions

The SPF perfusion can clean the vascular wall more thoroughly with less injury.

The accelerated atherogenesis of venous grafts might be attributed to aggravated concentration polarization of low density lipoproteins: a numerical study

We hypothesize that after implantation the much elevated water filtration rate of venous grafts may cause aggravated concentration polarization of low density lipoproteins (LDLs), in turn lead to the accelerated atherogenesis of the grafts. To verify the hypothesis, we numerically simulated the transport of LDLs in various models of arterial bypasses with different grafts (veins or arteries) and geometrical configurations. The results showed that the venous grafts might endure abnormally high lipid infiltration/accumulation within the vessel wall due to severely elevated luminal surface LDL concentration. When compared to the conventional bypass models, the S-type bypass had the lowest luminal surface LDL concentration along its host artery floor, but the highest degree of risk to develop atherosclerotic lesions in its venous graft. Among the three conventional bypass models, the one with 30° anastomosis had the lowest risk to develop atherosclerosis in the venous graft. In conclusion, when compared with the bypass models with arterial grafts, the venous bypass models had rather high levels of LDL concentration polarization (cw) in the vein grafts, especially at the early stages of implantation. This might result in high infiltration/accumulation of LDLs within the walls of the venous grafts, leading to a fast genesis/development of atherosclerosis there.