Enhanced ultraviolet photoresponse in Au/ZnO nanorods

Donor-Acceptor Compensated ZnO Semiconductor for Photoelectrochemical Biosensors

Hindering the recombination of a photogenerated carrier is a crucial method to enhance the photoelectrochemical performance of ZnO due to its high exciton binding energy. Herein, the intramolecular donor-acceptor compensated semiconductor ZnO (I-D/A ZnO), introducing C dopants and oxygen vacancies, was prepared with the assistance of ascorbic acid (AA). According to the DFT calculations, the asymmetry DOS could lead to the longer carrier lifetime and the smaller electron transfer resistance. Then, the photoelectrochemical biosensor toward glucose was regarded as a model to discuss the application of ZnO in biosensors. As a result, the biosensor based on I-D/A ZnO showed good performance with high sensitivity, low limit of detection, and fine anti-interference, meaning that I-D/A ZnO is a promising semiconductor for photoelectrochemical biosensors.

Two Hybrid Au-ZnO Heterostructures with Different Hierarchical Structures: Towards Highly Efficient Photocatalysts

A new paradigm for photocatalysts based on two different hierarchically structured honeycomb and porous cylindrical Au-ZnO heterostructures was successfully developed via a straightforward and cost-effective hydrothermal method under different preparation conditions, which can be promising for industrial applications. The photocatalytic performance of all as-prepared samples under the illumination of sunlight was evaluated by the photocatalytic degradation of rhodamine B (RhB) and malachite green (MG) aqueous solutions. The results show that the photocatalytic degradation efficiency of RhB and MG was 55.3% and 40.7% for ZnO, 95.3% and 93.4% for the porous cylindrical Au-ZnO heterostructure, and 98.6% and 99.5% for the honeycomb Au-ZnO heterostructure, respectively. Compared with those from the ZnO, the results herein demonstrate an excellent reduction in the photoluminescence and improvement in the photocatalysis for the Au-ZnO hybrids with different morphologies. These results were attributed not only to the greatly improved sunlight utilization efficiency due to the surface plasmon resonance (SPR) absorption of Au nanoparticles in the visible region coupled with the UV light utilization by the ZnO nanostructures and multi-reflections of the incident light in the pore structures of their interior cavities but also to the high charge separation efficiency and low Schottky barrier generated by the combination of Au nanoparticles and ZnO micromaterials. Moreover, the honeycomb Au-ZnO heterostructure had a high Au content, surface area and surface oxygen vacancy (O_V), which enabled photocatalytic properties that were higher than those of the porous cylindrical Au-ZnO heterostructures. In addition, two different formation mechanisms for the morphology and possible photocatalytic mechanisms are proposed in this paper.

Broad-band three dimensional nanocave ZnO thin film photodetectors enhanced by Au surface plasmon resonance

ZnO semiconductor films with periodic 3D nanocave patterns were fabricated by the thermal nanoimprinting technology, which is promising for photodetectors with enhanced light harvesting capability. The Au nanoparticles were further introduced into the ZnO films, which boosts the UV response of ZnO films and extends the photodetection to visible regions. The best UV photoresponse was detected on the 3D nanocave ZnO-Au hybrid films, attributing to the light trapping mechanism of 3D periodic structures and the driving force of the Schottky barrier at the ZnO/Au interface, while the high visible photoresponse of ZnO-Au hybrid films mainly results from the hot electron generation and injection process over the Schottky junctions mediated by Au surface plasmon resonances. The work provides a cost-effective pathway to develop large-scale periodic 3D nanopatterned thin film photodetectors and is promising for the future deployment of high performance optoelectronic devices.