Photolysis of sulfadiazine under UV radiation: Effects of the initial sulfadiazine concentration, pH, NO3− and Cd2+

Effects of solution chemistry on dielectric barrier atmospheric non-thermal plasma for operative degradation of antiretroviral drug nevirapine

The global prevalence of human immunodeficiency virus/acquired immunodeficiency syndrome (HIV/AIDS) has been an environmental menace. Tons of drug wastes from antiretroviral therapy are released into the environment annually. We, for the first time, employed the novel dielectric barrier atmospheric non-thermal plasma (DBANP) discharge, to mitigate the inadvertent pollution arising from the antiretroviral therapy. A 40-min treatment of nevirapine achieved >94 % (0.075 min-1) removal efficiency at discharge power of 63.5 W and plasma working gas of atmospheric air. Chemical probes confirmed •OH, ONOO- and eaq- as the dominant reactive species whilst further revealing the reaction acceleration role of NaNO3 and CCl4 which are known reaction terminators. The commonly coexisting inorganic anions potentiated nevirapine removal with over 98 % efficiency, achieving the highest rate constant of 0.148 min-1 in this study. Moreover, the initial solution pH (1.5-11.1) was no limiting factor either. The insensitivity of the DBANP discharge to actual water matrices was an eminent inference of its potential applicability in practical conditions. With reference to data obtained from the liquid chromatography-mass spectrometer analysis, nevirapine degradation pathway was proposed. A nucleophilic attack by ONOO- at the cyclopropyl group and •OH attack at the carbonyl carbon of the amide group, respectively, initiated nevirapine degradation process. It is anticipated that the findings herein, will provide new insights into antiretroviral drug waste management in environmental waters using the innovative and green non-thermal plasma process.

Adsorptive removal of pharmaceutically active compounds from multicomponent system using Azadirachta indica induced zinc oxide nanoparticles: analysis of competitive and cooperative adsorption

In this research, zinc oxide (ZnO) nanoparticles synthesized using neem leaf (Azadirachta indica) extract were used as an adsorbent for removing two widely used pharmaceutical compounds acetaminophen (AMP) and sulfadiazine (SDZ). The synthesized ZnO nanoparticles were characterized using SEM-EDS, FTIR, TEM, BET, and XRD analysis. The synthesized ZnO nanoparticles were found to be in the size range of 10 nm with a surface area of 48.551 m²/g. The adsorptive performance of ZnO nanoparticles in both mono-component (MoS) and multi-component system (MuS) was investigated under various operational parameters viz. contact time, temperature, pH, concentration of pharmaceutical compound and ZnO nanoparticles dose. It was observed that the maximum adsorption capacity of ZnO nanoparticles was 7.87 mg/g and 7.77 mg/g for AMP and SDZ, respectively, under the optimum conditions of 7 pH and 2 g/L adsorbent dosage. The experimental data best-fitted with the pseudo-second-order model and Langmuir model, indicating monolayer chemisorption. Further investigation on removal of AMP and SDZ from multicomponent system was modelled using a Langmuir competitive model. The desorption study has shown 25.28% and 22.4% removal of AMP and SDZ from the surface of ZnO nanoparticles. In general, green synthesized ZnO nanoparticles can be utilized effectively as adsorbent for removal of pharmaceutically active compounds from wastewater.

Behavior of Mebendazole during NF/RO Adsorption and Photolysis

The idea of using drugs from the benzimidazole group as potential antitumor agents is becoming increasingly popular and widespread in research. However, their use as antiparasitics and in cancer treatment will increase their already recorded occurrence in the aquatic environment. In this study, the removal of the anthelmintic mebendazole from aqueous solution was investigated using nanofiltration and reverse osmosis membranes, adsorption on granular activated carbon (GAC), and photolytic degradation. The dense NF90 and reverse osmosis XLE membranes showed almost complete removal (>97.7%), while the NF270 membrane showed a large dependence of removal on initial concentration from 41.9% to 96.6%. Adsorption in the column resulted in complete removal of mebendazole at the highest GAC height used (40 cm) from the solution with the lowest concentration (1 mg/L). Photolytic degradation by artificial light for 2 and 12 h resulted in photodegradation of mebendazole in the range of 23.5−61.4%, forming a new degradation or transformation compound with an m/z ratio of 311. Mebendazole is a photosensitive drug whose photodegradation follows first-order kinetics and depends on the drug concentration. Toxicity was studied with Vibrio fischeri before and after photolysis, and showed a decrease in inhibition after 12 h.

Ultraviolet photolysis of four typical cardiovascular drugs: mechanisms, influencing factors, degradation pathways, and toxicity trends

The cardiovascular drugs (CDDs), such as metoprolol (MET), atenolol (ATE), bezafibrate (BZB), and atorvastatin (ATO), have been frequently detected in the water environment. They can cause potential threats to the ecological environment and human health due to their "pseudo-persistence" effect. In this study, the photolysis kinetics, degradation mechanisms, by-products, influencing factors, and acute toxicity of these four typical CDDs under polychromatic ultraviolet irradiation (200-400 nm) were investigated. The results showed that the photolysis of ATE, BZB, MET, and ATO all followed pseudo-first-order kinetics, and their average photon quantum yields of the wavelength studied were 0.14×10^-2, 0.33×10^-3, 0.78×10^-4, and 0.24×10^-4 mol einstein^-1, respectively. Singlet oxygen (¹O₂), hydroxyl radical (·OH), and the triplet-excited state of the cardiovascular drug (³CDD*) were all involved in the photolysis while ¹O₂ was the dominator. The effects of NO₃^-, Cl^-, HCO₃^-, and humic acid (HA) on the photolysis were the combination of light-shielding, quenching, and excitation of reactive species. Seven, four, four, and nine photolysis products of ATO, BZB, ATE, and MET were identified, respectively, and their possible degradation pathways were proposed. The acute toxicity of ATE was basically unchanged during photolysis; however, ATO, BZB, and MET toxicity all increased due to the generation of ketonization and hydroxylation products.

Photodegradation of Emerging Contaminant 2-(tiocyanomethylthio) Benzothiazole (TCMTB) in Aqueous Solution: Kinetics and Transformation Products

Direct photolysis of the emerging contaminant 2-(thiocyanomethylthio) benzothiazole (TMCTB) was performed in aqueous solution at different concentrations with high-pressure mercury lamp (5.0, 8.0, 13.0, 16.0, 20.0, 23.0, 27.0, 35.0, 40.0, 45.0, and 50.0 mg L^- 1) and with natural sunlight radiation (6.0, 30.0, and 60.0 mg L^- 1). TCMTB underwent rapid degradation by direct photolysis with a high-pressure mercury lamp in aqueous solutions, with 99% removal after 30 min at all concentrations studied. For sunlight photolysis, TCMTB degradation was observed with 96%, 81%, and 64% removal for initial concentrations of 6.0, 30.0, and 60.0 mg L^- 1, respectively, after 7 h of exposure to sunlight. The degradation of TCMTB in lab-scale wastewater had kinetic constant and t_1/2 in the same order when compared to the photodegradation of TCMTB in aqueous solutions. In addition, the results showed that photolysis with a high-pressure mercury lamp and sunlight were governed by the same kinetic order, however the kinetic parameters showed that degradation with sunlight was 40 times slower than photolysis with the mercury lamp. Twelve transformation products (TP) were identified, and eight of the TP have not been described in the literature. Furthermore, prediction of toxicity with ECOSAR software was carried out for fish, daphnids, and green algae species. It showed that photolytic treatment is efficient for reducing the toxicity of the compound, since the degradation formed compounds with lower toxicity than the primary compound. In conclusion, this study suggests that photolysis is an efficient way to remove the studied contaminant, and it highlights the potential of this technique for the degradation of emerging contaminants in industrial wastewater treatment plants.