Some aspects of speciation and reactivity of mercury in various matrices

Development of a green and low-cost method to determine mercury content in sediments affected by oil spill on the Brazilian coast

Tons of crude oil were found on the Brazilian coast in 2019, and studies assessing its chemical composition are still scarce. This study aimed to develop a new and simple technique of cold vapor generation using infrared irradiation coupled with atomic absorption spectrometry to determine mercury content in sediments contaminated by crude oil. Experimental conditions were evaluated, including formic acid concentration, reactor temperature, and carrier gas flow rate. The accuracy of the method was validated by comparison with mercury contents in a certified reference material (PACS-2). The detection limit was found to be 0.44 μg kg-1. The developed method was applied to determine the total mercury content in marine sediment samples collected from beaches in Ceará State. Mercury concentrations ranged from 0.41 to 0.95 mg kg-1. The proposed method is efficient, simple, low-cost, and adequate for its purpose.

Adapted Sequential Extraction Protocol to Study Mercury Speciation in Gold Mining Tailings: Implications for Environmental Contamination in the Amazon

Artisanal small-scale gold mining (ASGM), an increasingly prevalent activity in South America, generates mercury-contaminated tailings that are often disposed of in the environment, leading to the introduction of mercury into ecosystems and the food web, where it bioaccumulates. Therefore, studying the geochemical processes involved in the desorption and dissolution of mercury in these tailings is essential for critical risk evaluations in the short and long term. For this purpose, sequential extraction procedures (SEPs) can be useful because they help to identify the phases to which Hg is associated, although they also have limitations such as a lack of selectivity and specificity. In this work, we propose a modified four-step SEP: exchangeable mercury (F1), oxidizable mercury (F2), mercury bound to Fe oxides (F3), and strongly bound mercury (F4). To test this adapted sequential extraction method, we evaluated the Hg contamination in mercury-contaminated tailings of the Amazon basin. The results revealed a total mercury concentration of 103 ± 16 mg·kg-1 in the tailings, with a significant portion in F1 (28% of the total), where Hg was bioavailable. The large Hg concentration in F3 (36%) suggested that Fe oxides likely contribute to mercury retention. Together, the SEP results emphasize the urgent need for improved surveillance of gold mining activities and responsible tailings management practices to mitigate environmental contamination and safeguard the health of the Amazon ecosystem.

Mobility and bioavailability of mercury in sediments of the southern Baltic sea in relation to the chemical fractions of iron: Spatial and temporal patterns

Marine sediments play a significant role as reservoirs for mercury (Hg), a bioaccumulative toxic pollutant that poses risks to human and ecosystem health. Iron (Fe) has been recognized as an influential factor in the complexation and bioavailability of Hg in sediments. However, limited studies have investigated the interactions between the chemical fractions of these elements in natural settings. This study aims to examine the fractions of Hg and Fe in sediments of the Baltic Sea, a region historically impacted by Hg pollution. The Hg fractions were determined using the thermodesorption technique, while sequential extraction was employed to identify the Fe fractions. The findings confirm the crucial role of Fe in the formation, as well as the horizontal and vertical distribution of labile and stable Hg in marine sediments. Factors such as the contribution of organic matter, the presence of reactive Fe, and Fe associated with sheet silicates emerged as significant drivers that positively influenced the content of the most labile Hg fractions, potentially affecting the mobility and bioavailability of Hg in the marine environment.

Quantitative Proteomic Analysis of Cyanide and Mercury Detoxification by Pseudomonas pseudoalcaligenes CECT 5344

The cyanide-degrading bacterium Pseudomonas pseudoalcaligenes CECT 5344 uses cyanide and different metal-cyanide complexes as the sole nitrogen source. Under cyanotrophic conditions, this strain was able to grow with up to 100 μM mercury, which was accumulated intracellularly. A quantitative proteomic analysis by liquid chromatography-tandem mass spectrometry (LC-MS/MS) has been applied to unravel the molecular basis of the detoxification of both cyanide and mercury by the strain CECT 5344, highlighting the relevance of the cyanide-insensitive alternative oxidase CioAB and the nitrilase NitC in the tolerance and assimilation of cyanide, independently of the presence or absence of mercury. Proteins overrepresented in the presence of cyanide and mercury included mercury transporters, mercuric reductase MerA, transcriptional regulator MerD, arsenate reductase and arsenical resistance proteins, thioredoxin reductase, glutathione S-transferase, proteins related to aliphatic sulfonates metabolism and sulfate transport, hemin import transporter, and phosphate starvation induced protein PhoH, among others. A transcriptional study revealed that from the six putative merR genes present in the genome of the strain CECT 5344 that could be involved in the regulation of mercury resistance/detoxification, only the merR2 gene was significantly induced by mercury under cyanotrophic conditions. A bioinformatic analysis allowed the identification of putative MerR2 binding sites in the promoter regions of the regulatory genes merR5, merR6, arsR, and phoR, and also upstream from the structural genes encoding glutathione S-transferase (fosA and yghU), dithiol oxidoreductase (dsbA), metal resistance chaperone (cpxP), and amino acid/peptide extruder involved in quorum sensing (virD), among others. IMPORTANCE Cyanide, mercury, and arsenic are considered very toxic chemicals that are present in nature as cocontaminants in the liquid residues generated by different industrial activities like mining. Considering the huge amounts of toxic cyanide- and mercury-containing wastes generated at a large scale and the high biotechnological potential of P. pseudoalcaligenes CECT 5344 in the detoxification of cyanide present in these industrial wastes, in this work, proteomic, transcriptional, and bioinformatic approaches were used to characterize the molecular response of this bacterium to cyanide and mercury, highlighting the mechanisms involved in the simultaneous detoxification of both compounds. The results generated could be applied for developing bioremediation strategies to detoxify wastes cocontaminated with cyanide, mercury, and arsenic, such as those generated at a large scale in the mining industry.

Current understanding of the ecological risk of mercury from subsea oil and gas infrastructure to marine ecosystems

Many oil and gas fields are nearing production cessation and will require decommissioning, with the preferred method being complete infrastructure removal in most jurisdictions. However, decommissioning in situ, leaving some disused components in place, is an option that may be agreed to by the regulators and reservoir titleholders in some circumstances. To understand this option's viability, the environmental impacts and risks of any residual contaminants assessed. Mercury, a contaminant of concern, is naturally present in hydrocarbon reservoirs, may contaminate offshore processing and transmission infrastructure, and can biomagnify in marine ecosystems. Mercury's impact is dependent on its speciation, concentration, and the exposure duration. However, research characterising and quantifying the amount of mercury in offshore infrastructure and the efficacy of decontamination is limited. This review describes the formation of mercury-contaminated products within oil and gas infrastructure, expected exposure pathways after environmental release, possible impacts, and key research gaps regarding the ecological risk of in situ decommissioned contaminated infrastructure. Suggestions are made to overcome these gaps, improving the in situ mercury quantification in infrastructure, understanding environmental controls on, and forecasting of, mercury methylation and bioaccumulation, and the cumulative impacts of multiple stressors within decommissioned infrastructures.

A critical review of mercury speciation, bioavailability, toxicity and detoxification in soil-plant environment: Ecotoxicology and health risk assessment

Environmental contamination by a non-essential and non-beneficial, although potentially toxic mercury (Hg), is becoming a great threat to the living organisms at a global scale. Owing to its various uses in numerous industrial processes, high amount of Hg is released into different environmental compartments. Environmental Hg contamination can result in food chain contamination, especially due to its accumulation in edible plant parts. Consumption of Hg-rich food is a key source of Hg exposure to humans. Since Hg does not possess any identified biological role and has genotoxic and carcinogenic potential, it is critical to monitor its biogeochemical behavior in the soil-plant system and its influence in terms of possible food chain contamination and human exposure. This review traces a plausible link among Hg levels, its chemical speciation and phytoavailability in soil, accumulation in plants, phytotoxicity and detoxification of Hg inside the plant. The role of different enzymatic (peroxidase, catalase, ascorbate peroxidase, superoxide dismutase, glutathione peroxidase) and non-enzymatic (glutathione, phytochelatins, proline and ascorbic acid) antioxidants has also been elucidated with respect to enhanced generation of reactive radicles and resulting oxidative stress. The review also outlines Hg build-up in edible plant tissues and associated health risks. The biogeochemical role of Hg in the soil-plant system and associated health risks have been described with well summarized and up-to-date data in 12 tables and 4 figures. We believe that this comprehensive review article and meta-analysis of Hg data can be greatly valuable for scientists, researchers, policymakers and graduate-level students.

A Simple in Syringe Low Density Solvent-Dispersive Liquid Liquid Microextraction for Enrichment of Some Metal Ions Prior to Their Determination by High Performance Liquid Chromatography in Food Samples

A simple and highly sensitive method is developed for the simultaneous determination of Ni2+, Cr2O72-, Co2+, and Hg2+ by using in syringe low density solvent-dispersive liquid liquid microextraction (ISLD-DLLME), followed by high performance liquid chromatography with a UV detector. The four metal ions were derivatized with pyrrolidine dithiocarbamate (PDC) based on complexation before their enrichment by ISLD-DLLME in which 1-octanol and methanol were used as the extraction solvent and the dispersive solvent, respectively. The extraction was performed in a commercially available syringe under vortex agitation. Phase separation was achieved without centrifugation, and the extraction phase was easily collected by moving the syringe plunger. Parameters affecting the extraction efficiency were studied and optimized. Under the optimum conditions, the four metal-PDC complexes were detected within 18 min, and ISLD-DLLME could increase the detection sensitivity in the range of 64-230 times compared to the direct HPLC analysis. The obtained limits of detection (LODs) were found to be in the range of 0.011-2.0 µg L-1. The applicability of the method is demonstrated for freshwater fish, shrimp, and shellfish samples. In addition, the results are in good agreement with those obtained by inductively-coupled plasma-optical emission spectrometry (ICP-OES).

Species and correlations between selenium and mercury in fishpond ecosystems

The chemical species and contents of selenium and mercury in water, sediments, and crucian carps collected from three wild and three aquaculture fishponds in Tianjin, China, were determined, and the interaction between selenium and mercury in water was also investigated by the calorimetry method. The results revealed that the average contents of total selenium (TSe) and total mercury (THg) in each item of the wild areas were higher than in those of the aquaculture areas, and significant differences (95% confidence) were presented for THg both in the sediments and crucian carps. The molar ratios between TSe and THg in all investigated fishponds were far higher than 1, indicating good protective effects of selenium on mercury toxicity. Obviously, negative correlations (r > 0.9993) were found between TSe and THg in water. The antagonism of selenium on mercury in water was confirmed to mainly result from the reaction between selenate and Hg²⁺ to form an insoluble selenium-mercury oxygenated compound, by which the addition of selenate into the water of fishponds would reduce the environmental risk of mercury. PRACTITIONER POINTS: Se and Hg in different fishpond ecosystems were investigated and compared. Direct evidence was provided for the interaction between Se and Hg in water. The addition of Se(VI) into fishpond ecosystems would reduce the environmental risk of Hg.