Effect of the infrastructure material on the failure behavior of prosthetic crowns

Effect of substrate and cement on the final color of zirconia-based all-ceramic crowns

OBJECTIVE

To evaluate the influence of the substrate and the cement on the final color of ceramic crowns.

METHODS

Prosthetic crowns (framework + porcelain) were fabricated using two all-ceramic systems (YZ, 3 mol% yttria-stabilized tetragonal zirconia; IZ, alumina-based zirconia-reinforced glass-infiltrated ceramic) and a metal-ceramic system (MC; n = 8). Metal (M) and resin (R) were used as substrate abutments. For R substrate, crowns were evaluated as seated (R) and after cementation (R-C). CIELAB color coordinates were obtained using a dental spectrophotometer with D65 light illumination. CIELAB, CIEDE2000 (1:1:1) and CIEDE2000 (2:1:1) color difference metrics were used. Data were analyzed using 95% confidence intervals and compared to perceptibility (PT) and acceptability (AT) thresholds.

RESULTS

The ∆ E ab * , ∆E₀₀ (1 : 1 : 1), and ∆E₀₀ (2 : 1 : 1) values of the restorative systems evaluated using different substrates (M.R) were similar to the AT values of each metric. When non-cemented and cemented crowns were evaluated (R.R-C), MC had color difference values at PT and below AT; while YZ and IZ showed similar values to AT, for ∆ E ab * and ∆E₀₀ (1 : 1 : 1) metrics.

CONCLUSION

The substrate and cement affected the final color of zirconia-based all-ceramic crowns, but the color differences corresponded to an acceptable match.

CLINICAL SIGNIFICANCE

As both substrate and cement influence the final color of multi-layered ceramic prosthesis, dentists and dental technicians should understand the optical properties of dental ceramics to reproduce the natural appearance of dental structures and maximize the chance for excellent color matches.

Characterization of a Diamond Ground Y-TZP and Reversion of the Tetragonal to Monoclinic Transformation

PURPOSE

To characterize the surface of an yttria-stabilized zirconia (Y-TZP) ceramic after diamond grinding in terms of its crystalline phase, morphology, mean roughness (Ra), and wettability as well as to determine a thermal treatment to reverse the resulting tetragonal to monoclinic (t-m) transformation.

METHODS AND MATERIALS

Y-TZP specimens were distributed into different groups according to the actions (or no action) of grinding and irrigation. Grinding was accomplished using a diamond stone at a low speed. The samples were characterized by x-ray diffraction (XRD), scanning electron microscopy, goniometry, and profilometry. In situ high-temperature XRD was used to determine an annealing temperature to reverse the t-m transformation. Ra was submitted to the Kruskal-Wallis test, followed by the Dunn test (α=0.05). The volume fraction of the monoclinic phase and contact angle were submitted to one-way analysis of variance, followed by the Tukey test (α=0.05).

RESULTS

Monoclinic zirconia was observed on the surface of samples after dry and wet grinding with a diamond stone. The volume fraction of the monoclinic phase was smaller on the dry ground samples (3.6%±0.3%) than on the wet ground samples (5.6%±0.3%). High-temperature XRD showed reversion of the t-m phase transformation, which started at 700°C and completed at 800°C in a conventional oven.

CONCLUSIONS

Grinding with a diamond stone partially transformed the crystalline phase on the surface of a Y-TZP ceramic from tetragonal to monoclinic zirconia while simultaneously increasing the surface roughness and wettability. The t-m transformation could be reversed by heat treatment at 800°C or 900°C for 60 minutes or 1000°C for 30 minutes.